Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 4
Encontrada(s) 1 página(s)

RUA. Repositorio Institucional de la Universidad de Alicante
Publicación Otros (Other)

Spectroelectrochemical Study of Carbon Monoxide and Ethanol Oxidation on Pt/C, PtSn(3:1)/C and PtSn(1:1)/C Catalysts

  • Rizo, Rubén
  • Lázaro, María Jesús
  • Pastor, Elena
  • García, Gonzalo
  • Rizo, Rubén|||/items/27448570-0e85-47c3-be0f-38bcb1bf11b3
PtSn-based catalysts are one of the most active materials toward that contribute ethanol oxidation reaction (EOR). In order to gain a better understanding of the Sn influence on the carbon monoxide (principal catalyst poison) and ethanol oxidation reactions in acidic media, a systematic spectroelectrochemical study was carried out. With this end, carbon-supported PtSnx (x = 0, 1/3 and 1) materials were synthesized and employed as anodic catalysts for both reactions. In situ Fourier transform infrared spectroscopy (FTIRS) and differential electrochemical mass spectrometry (DEMS) indicate that Sn diminishes the amount of bridge bonded CO (COB) and greatly improves the CO tolerance of Pt-based catalysts. Regarding the effect of Sn loading on the EOR, it enhances the catalytic activity and decreases the onset potential. FTIRS and DEMS analysis indicate that the C-C bond scission occurs at low overpotentials and at the same potential values regardless of the Sn loading, although the amount of C-C bond breaking decreases with the rise of Sn in the catalytic material. Therefore, the elevated catalytic activity toward the EOR at PtSn-based electrodes is mainly associated with the improved CO tolerance and the incomplete oxidation of ethanol to form acetic acid and acetaldehyde species, causing the formation of a higher amount of both C2 products with the rise of Sn loading.
RUA. Repositorio Institucional de la Universidad de Alicante
Publicación Otros (Other)

On the design of Pt-Sn efficient catalyst for carbon monoxide and ethanol oxidation in acid and alkaline media

  • Rizo, Rubén
  • Sebastián, David
  • Lázaro, María Jesús
  • Pastor, Elena
  • Rizo, Rubén|||/items/27448570-0e85-47c3-be0f-38bcb1bf11b3
Pt-Sn catalysts supported on carbon, with different Pt-Sn atomic ratios (3:1, 1:1, 1:3), were prepared through the formic acid method (FAM) and supported on different carbon supports (nanofibers and carbon blacks) to study their behavior toward CO stripping and ethanol oxidation reaction (EOR). PtSn/C catalysts and supports were physicochemically characterized by XRD, EDX, XPS, TEM and TPD. Good particle dispersion onto the carbon support, similar particle sizes (around 4–5 nm) and the presence of tin oxides were observed in all cases. Sn insertion favored the development of the Pt3Sn1 phase and the presence of higher oxidation states of both metals in the catalyst. Ethanol and adsorbed CO oxidation were studied at these materials both in acid and alkaline media, by linear sweep voltammetry and chronoamperometry. Higher EOR current densities were obtained with the increase in the amount of Sn in the samples, been those materials supported on CNF the ones with the best CO tolerance and catalytic activity toward this reaction. As expected, a great improvement of the EOR activity was found in alkaline media compared to sulfuric acid media, providing good expectative for these materials as catalysts for alkaline direct ethanol fuel cells.
RUA. Repositorio Institucional de la Universidad de Alicante
Publicación Otros (Other)

CO electrooxidation on Sn-modified Pt single crystals in acid media

  • Rizo, Rubén
  • Pastor, Elena
  • Koper, Marc T.M.
  • Rizo, Rubén|||/items/27448570-0e85-47c3-be0f-38bcb1bf11b3
The irreversible adsorption of Sn on the three Pt basal planes (Sn/Pt(111), Sn/Pt(100) and Sn/Pt(110)) and the oxidation of adsorbed carbon monoxide have been studied by cyclic and stripping voltammetry. The presence of Sn adatoms blocks the adsorption of hydrogen on platinum, and leads to the observation of a new oxidation peak ascribed to the four-electron oxidation of the Sn adatom at potentials above 0.5 V. The oxidation of adsorbed carbon monoxide is enhanced by the presence of Sn on all three Pt single crystals. On Sn/Pt(111) and Sn/Pt(110), oxidation of adsorbed CO occurs in two distinct potential regions: a pre-peak region at potentials below 0.50 V and the main peak at higher potentials. In the pre-peak, the oxidation of adsorbed CO is suggested to take place at the direct interface between Pt and Sn through the formation of an activated water species on Sn that is not observable in the blank voltammetry. In the main peak, the COad oxidation reaction is suggested to occur through the classical bifunctional mechanism of OH adsorbed on Sn with CO adsorbed on Pt atoms no adjacent to Sn atoms. On Sn/Pt(100), the “pre-peak mechanism” is not observed.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Otros (Other)

Probing CO2 reduction intermediates employing in situ spectroscopy and spectrometry

  • Pérez Rodríguez, Sara
  • García, Gonzalo
  • Lázaro Elorri, María Jesús
  • Pastor Tejera, Elena
17 Figuras.-- Número del capítulo en postprint: 8, The electrochemical reduction of CO2 represents a promising alternative for obtaining a variety of useful products, with important applications in chemical industry or for power generation. However, finding an effective electrode for the activation and further reduction of CO2 continues being a key challenge. In addition, the reaction mechanism of the process and the involved intermediates are not fully clear as most works analyze the electrolysis products after CO2 reduction reaction, sampling the compounds in gas collectors or liquid solvents. With the main aim of generating knowledge, in situ techniques have been also used for the identification of the electrolysis products from CO2 reduction. Although these techniques are powerful tools for the elucidation of the reaction pathways, they are not commercial or recently introduced in the market and not-easy to use and, hence, these methods have not been widely employed. In the current chapter a review of the most commonly in situ techniques used for studying the CO2 electroreduction is addressed, paying special attention to the electrodes involved in the reaction. Furthermore, an explanation of the main experimental specifications is also described for an easier understanding of the method and a comparison of the in situ techniques, summarizing their advantages and disadvantages, is displayed., The authors gratefully acknowledge financial support given by Spanish MINECO (CTQ2011–28913–C02–01 and 02). GG acknowledges the Viera y Clavijo program (ACIISI & ULL) for financial support., Peer reviewed