Pasar al contenido principal

VECTORES DE ANISOTROPIA AMBIENTAL E INDICES DE RIESGO CLIMATICO DEL PATRIMONIO CULTURAL EN UN CLIMA CAMBIANTE

PID2020-116896RB-C21

•
Nombre agencia financiadora Agencia Estatal de Investigación
Acrónimo agencia financiadora AEI
Programa Programa Estatal de I+D+i Orientado a los Retos de la Sociedad
Convocatoria Proyectos de I+D+i (Generación de Conocimiento y Retos Investigación)
Año convocatoria 2020
Plan Estatal 2017-2020 Plan Estatal de Investigación Científica y Técnica y de Innovación
Centro beneficiario AGENCIA ESTATAL CONSEJO SUPERIOR DE INVESTIGACIONES CIENTIFICAS (CSIC)

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

RUA. Repositorio Institucional de la Universidad de Alicante
Publicación Otros (Other)

Estimation of uniaxial compressive strength and intrinsic permeability from ultrasounds in sedimentary stones used as heritage building materials

  • Benavente, David
  • Martínez Martínez, Javier
  • Galiana-Merino, Juan José
  • Pla, Concepción
  • Jongh, Marli de
  • García-Martínez, Noé
  • Benavente, David|||/items/93054314-55c1-4e9f-a84d-f461370acc10
  • Galiana-Merino, Juan José|||/items/2aeffb6f-7a89-465b-a756-a9ca8b74bb42
  • García-Martínez, Noé|||/items/35ea3f49-d77a-4740-8ca5-5bb024c9170c
  • Pla, Concepción|||/items/f9ff3ff5-c55e-4c85-83c1-f71fff810219
This paper combines ultrasonic parameters recorded from P- and S- waves and effective porosity to estimate uniaxial compressive strength, σC, and intrinsic permeability, k - two of the most crucial physical parameters used in stone conservation studies. The ultrasonic parameters have been chosen because they are sensitive to the microstructural properties of stones which influence both σC and k differently. Velocities of compressional or primary, Vp, and shear or secondary, Vs, elastic waves are related to porosity and the mineralogical composition; the waveform attenuation is related to the presence of vuggy macropores and pore and particle size; and the wavelength is related to the pore and particle size. Fifteen types of stones used in the Spanish built heritage were measured including calcarenites, sandstones, dolostones and travertines. Several simple and multiple predictive expressions for σC and k are fitted, which are quantified through the Pearson correlation coefficient, R. Curve fitting improves as the number of petrophysical parameters taken into account in the multiple linear regressions increases. The obtained Pearson's correlations values for σC are slightly higher than for k. The best correlation for σC (R = 0.921) and k (R = 0.903) is found when the predictive equation incorporates all of the elastic wave parameters obtained non-destructively, and the connected porosity. In general, effective porosity is statistically the most significant variable of the fitted regressions. The σC and k estimation from all the ultrasonic parameters, without considering connected porosity, shows a good correlation (R = 0.852 and 0.864, respectively). The addition of Vs to multiple regressions does not significantly improve the goodness of the fit. Consequently, the measurement of Vs is unnecessary as it is difficult and time-consuming. Finally, results also show that vuggy porosity (present in travertines) influences waveform attenuation and σC and k differently, relative to other microstructural properties; limiting the techniques use for stones with this type of porosity. Estimating σC and k using ultrasonic parameters exclusively is advantageous as the estimations can be obtained non-destructively using portable equipment, while also providing an acceptable goodness of fit.
RUA. Repositorio Institucional de la Universidad de Alicante
Publicación Otros (Other)

Control of natural fractures in historical quarries via 3D point cloud analysis

  • Riquelme, Adrián
  • Martínez Martínez, Javier
  • Martin-Rojas, Ivan
  • Sarro, Roberto
  • Rabat, Álvaro
  • Martin-Rojas, Ivan|||/items/86714454-f8b8-44f6-b3e8-58bf83b5730c
  • Riquelme, Adrián|||/items/03cd5ff0-7df3-4736-81f3-4d94bd19316a
This paper applies remote sensing techniques and 3D point cloud (3DPC) analysis to the study of historical quarries and the relationship between old quarry landscapes and the natural fracture systems of rock massifs. Ancient quarry landscapes present particular characteristics and different features from those of modern quarries. Consequently, specific considerations are needed when historical extractive places are studied. The proposed method is based on terrestrial 3D laser scanners and the structure from motion technique with remotely piloted aircraft systems. Additional specific fieldwork is required to identify and characterise quarry faces from old, blurry outcrops. A case study of the 18th century “Rambla Honda” quarries in La Romana (Alicante, SE Spain) is presented. The comparison between the fieldwork and 3DPC analysis enables the numbers and orientations of both (1) the discontinuity sets within the rock mass facilitating extraction and (2) the planes resulting from block extraction (traditional quarry faces) to be determined. The comparative analysis reveals how the stonecutters managed the extraction. The results show that structural and stratigraphic discontinuities act as planes of weakness for block extraction and determine the optimum orientation of the quarry face for minimising efforts and rock waste. The final quarry landscape is formed from the superposition of natural and artificial surfaces, but currently they appear eroded and partially covered by silting and plants. The proposed methodology contributes to distinguishing both natural and artificial discontinuities and to achieving a comprehensive knowledge of these cultural places.
RUA. Repositorio Institucional de la Universidad de Alicante
Publicación Otros (Other)

The Role of Calcite Dissolution and Halite Thermal Expansion as Secondary Salt Weathering Mechanisms of Calcite-Bearing Rocks in Marine Environments

  • Martínez Martínez, Javier
  • Arizzi, Anna
  • Benavente, David
  • Benavente, David|||/items/93054314-55c1-4e9f-a84d-f461370acc10
This research focuses on the analysis of the influence of two secondary salt weathering processes on the durability of rocks exposed to marine environments: chemical dissolution of rock forming minerals and differential thermal expansion between halite and the hosting rock. These processes are scarcely treated in research compared to salt crystallisation. The methodology followed in this paper includes both in situ rock weathering monitoring and laboratory simulations. Four different calcite-bearing rocks (a marble, a microcrystalline limestone and two different calcarenites) were exposed during a year to a marine semiarid environment. Exposed samples show grain detachment, crystal edge corrosion, halite efflorescences and microfissuring. Crystal edge corrosion was also observed after the laboratory simulation during a brine immersion test. Calcite chemical dissolution causes a negligible porosity increase in all the studied rocks, but a significant modification of their pore size distribution. Laboratory simulations also demonstrate the deterioration of salt-saturated rocks during thermal cycles in climatic cabinet. Sharp differences between the linear thermal expansion of both a pure halite crystal and the different studied rocks justify the registered weight loss during the thermal cycles. The feedback between the chemical dissolution and differential thermal expansion, and the salt crystallisation of halite, contribute actively to the rock decay in marine environments.
RUA. Repositorio Institucional de la Universidad de Alicante
Publicación Otros (Other)

Multiproxy Petrological Analysis for Provenance Determination of Two Granitic Stone Anchors in the Western Mediterranean

  • Martínez-Martínez, Javier
  • Corbí, Hugo
  • Fusi, Nicoletta
  • Molina Vidal, Jaime
  • Moya, José A.
  • Lorrio Alvarado, Alberto José
  • Lozano Quijada, Carlos
  • Pérez Burgos, José Manuel
  • Corbí, Hugo|||/items/6b9064af-de45-4355-8ece-2ad15bdb692b
  • Lorrio Alvarado, Alberto José|||/items/bd120cdc-b227-4301-a053-f3b1f723315e
  • Molina Vidal, Jaime|||/items/fe5c9fb1-bcda-465e-ae8a-b9c0d664b400
  • Moya, José A.|||/items/4e5b1032-b616-4fa4-bc6f-fb810720f443
A multiproxy methodology has been employed to characterise two granite anchors discovered on the seabed near the island of Nueva Tabarca (Alicante, Southeast Spain). According to the significant archaeological context where they were found, the studied anchors can be dated from the Roman ages (late Republican period). One of the most interesting aspects is the absence of regional geological outcrops with rocks compatible with the granite used in the production of the anchor, which shows a foreign origin consistent with the connection of the anchor to maritime transport across the Mediterranean Sea. The lack of precise information about the artifact’s origin underscores the interest and need for the application of petrological techniques to determine its provenance. The methodology utilised encompasses five distinct techniques: (1) non-destructive textural analysis using X-ray microcomputed tomography; (2) K–Ar dating; (3) petrological characterisation through optical microscopy; (4) geochemical characterisation using X-ray fluorescence and atomic absorption spectrometry. The results allow for a comparison of the anchor rock’s characteristics with various granite outcrops along the Mediterranean coasts (Eastern, Central, and Western sectors), suggesting potential source areas based on petrological compatibility with the material under study. The findings point to the origin of the Nueva Tabarca granite anchor being granite outcrops in Southern Italy (Calabria), reinforcing the connection between the Spanish southeastern coasts and Southern Italy. These results highlight the utility and significance of multiproxy petrological methodologies in the geoarchaeological study of decontextualised artifacts.
RUA. Repositorio Institucional de la Universidad de Alicante
Publicación Otros (Other)

Erosion anisotropy analysis of construction materials as a key tool for strengthening preventive conservation strategies in built heritage

  • Martínez Martínez, Javier
  • Benavente, David
  • Rocca, Riccardo
  • Ríos Murillo, Asunción de los
  • Gómez Heras, Miguel
  • Benavente, David|||/items/93054314-55c1-4e9f-a84d-f461370acc10
In this paper, we present an innovative Erosion Anisotropy Analysis as a pioneering tool to discern the most harmful hydrometerological agents and their predominant directions of impact on built heritage. The proposed Erosion Anisotropy Analysis includes: 1) the analysis of weathering, bio-weathering and erosion processes affecting the building materials; 2) analysis of climatic series identifying preferential directionality of hydrometeorological agents; 3) erosion quantification using photogrammetric models; and 4) comparative analysis between both erosion and climatic anisotropy models. The proposed analysis is applied to the Cerrillos Tower (Almería, Spain), which is considered a paradigmatic case study due to their location and exposure conditions. Results determinate the primary vulnerability directions against hydrometeorological agents (N200–330°E) and highlight solar radiation, wind and wind-driven rain as the most damaging factors. Moreover, the Erosion Anisotropy Analysis describes the erosion patterns developed as well as their anisotropic distribution in the Tower. The proposed methodology is a benchmark for designing and dimensioning effective preventive measures to mitigate their impact under current climatic conditions as well as to prevent future scenarios within the global framework of climate change.
RUA. Repositorio Institucional de la Universidad de Alicante
Publicación Otros (Other)

Characterization of Anisotropic Salt Weathering through Nondestructive Techniques Mapping Using a GIS Environment

  • Gómez Heras, Miguel
  • López-González, Laura
  • Gil-Muñoz, María Teresa
  • Cabello-Briones, Cristina
  • Benavente, David
  • Martínez Martínez, Javier
  • Benavente, David|||/items/93054314-55c1-4e9f-a84d-f461370acc10
Doctrinal texts on architectural heritage conservation emphasize the importance of fully understanding the structural and material characteristics and utilizing information systems. Photogrammetry allows for the generation of detailed, geo-referenced Digital Elevation Models of architectural elements at a low cost, while GIS software enables the addition of layers of material characteristic data to these models, creating different property maps that can be combined through map algebra. This paper presents the results of the mechanical characterization of materials and salt-related decay forms of the polygonal apse of the 13th-century monastery of Santa María de Bonaval (Guadalajara, Spain), which is primarily affected by salt crystallization. Rock strength is estimated using on-site nondestructive testing (ultrasound pulse velocity and Leeb hardness). They are mapped and combined through map algebra to derive a single mechanical soundness index (MSI) to determine whether the decay of the walls could be dependent on the orientation. The presented results show that salt decay in the building is anisotropic, with the south-facing side of the apse displaying an overall lower MSI than the others. The relative overheating of the south-facing side of the apse enhances the effect of salt crystallization, thereby promoting phase transitions between epsomite and hexahydrite.