Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

Dipòsit Digital de Documents de la UAB
Publicación Artículo científico (JournalArticle)

Early events in the photochemistry of 5-diazo Meldrum's acid, Formation of a product manifold in C-N bound and pre-dissociated intersection seam regions

  • Li, Huijing
  • Migani, Annapaola|||0000-0001-5422-805X
  • Blancafort, Lluís|||0000-0002-0003-5540
  • Li, Quansong
  • Li, Zesheng
5-Diazo Meldrum's acid (DMA) undergoes a photo-induced Wolff rearrangement (WR). Recent gas-phase experiments have identified three photochemical products formed in a sub-ps scale after irradiation, a carbene formed after nitrogen loss, a ketene formed after WR and a second carbene formed after nitrogen and CO elimination (A. Steinbacher, et al. Phys. Chem. Chem. Phys., 2014, 16, 7290-7298). In this work, ground- and excited-state potential energy surfaces (PESs) have been investigated at the MS-CASPT2// CASSCF level. The key element of the PESs is an extended S0/S1 conical intersection seam along the C-N dissociation coordinate. The C-N predissociated region of the seam is accessed after excitation to the bright S2 state, and decay paths from the seam to the three primary products have been characterized. For the ketene and carbene II products, we show two possible formation pathways, a direct and a stepwise one, which suggests that these products may be formed in a bi-modal fashion. We have also characterized two possible mechanisms for triplet formation, one occurring before C-N dissociation involving a (S1/T2/T1) crossing region, and another one through the carbene. In contrast, excitation to S1 leads to a C-N bound region of the seam from where DMA regeneration or diazirine formation is possible, with a preference for the first case. The results are in good agreement with experimental data. Together with our previous work on diazonaphthoquinone, they show the importance of an extended seam in the photochemistry of a-diazoketones.
Dipòsit Digital de Documents de la UAB
Publicación Artículo científico (JournalArticle)

What Controls Photocatalytic Water Oxidation on Rutile TiO2(110) under Ultra-High-Vacuum Conditions?

  • Migani, Annapaola|||0000-0001-5422-805X
  • Blancafort, Lluís|||0000-0002-0003-5540
The photocatalytic O-H dissociation of water absorbed on a rutile TiO(110) surface in ultrahigh vacuum (UHV) is studied with spin-polarized density functional theory and a hybrid exchange-correlation functional (HSE06), treating the excited-state species as excitons with triplet multiplicity. This system is a model for the photocatalytic oxidation of water by TiO in an aqueous medium, which is relevant for the oxygen evolution reaction and photodegradation of organic pollutants. We provide a comprehensive mechanistic picture where the most representative paths correspond to excitonic configurations with the hole located on three- and two-coordinate surface oxygen atoms (O and O). Our picture explains the formation of the species observed experimentally. At near band gap excitation, the O path leads to the generation of hydroxyl anions which diffuse on the surface, without net oxidation. In contrast, free hydroxyl radicals are formed at supra band gap excitation (e.g., 266 nm) from an interfacial exciton that undergoes O-H dissociation. The oxidation efficiency is low because the path associated with the O exciton, which is the most favored one thermodynamically, is unreactive because of a high propensity for charge recombination. Our results are also relevant to understand the reactivity in the liquid phase. We assign the photoluminescence measured for atomically flat TiO(110) surfaces in an aqueous medium to the O exciton, in line with the proposal based on experiments, and we have identified a species derived from the O exciton with an activated O-Ti bond that may be relevant in photocatalytic applications in an aqueous medium.