Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Reducing the Overhead of BCH Codes: New Double Error Correction Codes

  • Saiz-Adalid, Luis-J.|||0000-0002-4868-2050
  • Gracia-Morán, Joaquín|||0000-0001-9715-8960
  • Gil Tomás, Daniel Antonio|||0000-0001-9225-1998
  • Baraza-Calvo, Juan-Carlos|||0000-0001-7692-2309
  • Gil, Pedro|||0000-0002-9364-7385
[EN] The Bose-Chaudhuri-Hocquenghem (BCH) codes are a well-known class of powerful error correction cyclic codes. BCH codes can correct multiple errors with minimal redundancy. Primitive BCH codes only exist for some word lengths, which do not frequently match those employed in digital systems. This paper focuses on double error correction (DEC) codes for word lengths that are in powers of two (8, 16, 32, and 64), which are commonly used in memories. We also focus on hardware implementations of the encoder and decoder circuits for very fast operations. This work proposes new low redundancy and reduced overhead (LRRO) DEC codes, with the same redundancy as the equivalent BCH DEC codes, but whose encoder, and decoder circuits present a lower overhead (in terms of propagation delay, silicon area usage and power consumption). We used a methodology to search parity check matrices, based on error patterns, in order to design the new codes. We implemented and synthesized them, and compared their results with those obtained for the BCH codes. Our implementation of the decoder circuits achieved reductions between 2.8% and 8.7% in the propagation delay, between 1.3% and 3.0% in the silicon area, and between 15.7% and 26.9% in the power consumption. Therefore, we propose LRRO codes as an alternative for protecting information against multiple errors., This research was supported in part by the Spanish Government, project TIN2016-81075-R, by Primeros Proyectos de Investigacion (PAID-06-18), Vicerrectorado de Investigacion, Innovacion y Transferencia de la Universitat Politecnica de Valencia (UPV), project 20190032, and by the Institute of Information and Communication Technologies (ITACA).
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Proposal of an Adaptive Fault Tolerance Mechanism to Tolerate Intermittent Faults in RAM

  • Baraza-Calvo, Juan-Carlos|||0000-0001-7692-2309
  • Gracia-Morán, Joaquín|||0000-0001-9715-8960
  • Saiz-Adalid, Luis-J.|||0000-0002-4868-2050
  • Gil Tomás, Daniel Antonio|||0000-0001-9225-1998
  • Gil, Pedro|||0000-0002-9364-7385
[EN] Due to transistor shrinking, intermittent faults are a major concern in current digital systems. This work presents an adaptive fault tolerance mechanism based on error correction codes (ECC), able to modify its behavior when the error conditions change without increasing the redundancy. As a case example, we have designed a mechanism that can detect intermittent faults and swap from an initial generic ECC to a specific ECC capable of tolerating one intermittent fault. We have inserted the mechanism in the memory system of a 32-bit RISC processor and validated it by using VHDL simulation-based fault injection. We have used two (39, 32) codes: a single error correction-double error detection (SEC-DED) and a code developed by our research group, called EPB3932, capable of correcting single errors and double and triple adjacent errors that include a bit previously tagged as error-prone. The results of injecting transient, intermittent, and combinations of intermittent and transient faults show that the proposed mechanism works properly. As an example, the percentage of failures and latent errors is 0% when injecting a triple adjacent fault after an intermittent stuck-at fault. We have synthesized the adaptive fault tolerance mechanism proposed in two types of FPGAs: non-reconfigurable and partially reconfigurable. In both cases, the overhead introduced is affordable in terms of hardware, time and power consumption., This research was supported in part by the Spanish Government, project TIN2016-81,075-R, and by Primeros Proyectos de Investigacion (PAID-06-18), Vicerrectorado de Investigacion, Innovacion y Transferencia de la Universitat Politecnica de Valencia (UPV), project 20190032.