Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

RUA. Repositorio Institucional de la Universidad de Alicante
Publicación Otros (Other)

Electroactive Biochar for Large-Scale Environmental Applications of Microbial Electrochemistry

  • Schievano, Andrea
  • Berenguer Betrián, Raúl
  • Goglio, Andrea
  • Bocchi, Stefano
  • Marzorati, Stefania
  • Rago, Laura
  • Louro, Ricardo O.
  • Paquete, Catarina M.
  • Esteve-Núñez, Abraham
  • Berenguer Betrián, Raúl|||/items/660b8462-63ec-4910-98e0-ac425e6bd7a6
Large-scale environmental applications of microbial electrochemical technologies (MET), such as wastewater treatment, bioremediation, or soil improvement, would be more feasible if bioelectrodes could be fabricated with simpler materials. Biochar with potentially improved electroactive properties (e-biochar) can be an ideal candidate for this scope, being at the same time widely available, biocompatible, and fully recyclable at its end-of-life as a soil amendment. Here we review the application of biochar to MET, to set benchmarks aimed at tuning the electroactive properties of such materials from the point of view of MET. The precursor biomass, thermochemical process conditions, and pre-, in situ-, and/or post-treatments should tailor optimized combinations of electrical conductivity, capacitance, superficial redox-active and electroactive functional groups, porosity distribution, and capacity to host electroactive microbial communities. We also discuss methods to rigorously characterize e-biochar properties and the most relevant multidisciplinary research challenges toward its application in large-scale MET.
Dipòsit Digital de Documents de la UAB
Publicación Artículo científico (JournalArticle)

Redox-Polymer-Wired [NiFeSe] Hydrogenase Variants with Enhanced O Stability for Triple-Protected High-Current-Density H-Oxidation Bioanodes

  • Ruff, Adrian|||0000-0001-5659-8556
  • Szczesny, Julian|||0000-0002-8842-8057
  • Vega, Maria
  • Zacarias, Sonia
  • Matias, Pedro M.|||0000-0001-6170-451X
  • Gounel, Sébastien|||0000-0002-7602-9657
  • Mano, Nicolas|||0000-0001-7084-9323
  • Pereira, Inês A. C.|||0000-0003-3283-4520
  • Schuhmann, Wolfgang|||0000-0003-2916-5223
Variants of the highly active [NiFeSe] hydrogenase from D. vulgaris Hildenborough that exhibit enhanced O tolerance were used as H-oxidation catalysts in H/O biofuel cells. Two [NiFeSe] variants were electrically wired by means of low-potential viologen-modified redox polymers and evaluated with respect to H-oxidation and stability against O in the immobilized state. The two variants showed maximum current densities of (450±84) μA cm -2 for G491A and (476±172) μA cm -2 for variant G941S on glassy carbon electrodes and a higher O tolerance than the wild type. In addition, the polymer protected the enzyme from O damage and high-potential inactivation, establishing a triple protection for the bioanode. The use of gas-diffusion bioanodes provided current densities for H-oxidation of up to 6.3 mA cm -2. Combination of the gas-diffusion bioanode with a bilirubin oxidase-based gas-diffusion O-reducing biocathode in a membrane-free biofuel cell under anode-limiting conditions showed unprecedented benchmark power densities of 4.4 mW cm -2 at 0.7 V and an open-circuit voltage of 1.14 V even at moderate catalyst loadings, outperforming the previously reported system obtained with the [NiFeSe] wild type and the [NiFe] hydrogenase from D. vulgaris Miyazaki F. Triple protection : A stable, high-current-density-based H-oxidation bioanode is presented. It is equipped with [NiFeSe] variants that show enhanced O tolerance, which are immobilized and wired to electrode surfaces with a low-potential viologen-modified polymer. The polymer acts simultaneously as a high-potential and O shield. The triply protected bioanodes are incorporated in membrane-free biofuel cells, which reveal benchmark performances at moderate catalyst loading.