Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Non-linear finite element formulation applied to thermoelectric materials under hyperbolic heat conduction model

  • Palma, Roberto
  • Pérez-Aparicio, José L.
  • Taylor, R.L.
In the present work, a three-dimensional, dynamic and non-linear finite element to simulate thermoelectric behavior under a hyperbolic heat conduction model is presented. The transport equations, which couple electric and thermal energies by the Seebeck, Peltier and Thomson effects, are analytically obtained through extended non-equilibrium thermodynamics, since the local equilibrium hypothesis is not valid under the hyperbolic model. In addition, unidimensional analytical solutions are obtained to validate the finite element formulation. Numerically, isoparametric eight-node elements with two degrees of freedom (voltage and temperature) per node are used. Non-linearities due to the temperature-dependence on the transport properties and the Joule effects are addressed with the Newton-Raphson algorithm. For the dynamic problem, HHT and Newmark-ß algorithms are compared to obtain accurate results, since numerical oscillations (Gibbs phenomena) are present when the initial boundary conditions are discontinuous. The last algorithm, which is regularized by relating time steps and element sizes, provides the best results. Finally, the finite element implementation is validated, comparing the analytical and the numerical solutions, and a three-dimensional example is presented., This research was partially supported by the Spanish Ministry of Education through Grant No. FPU AP-2006-02372 and also from Grants MICINN BIA-2008-00522, CSD2008-00037 Canfranc Under-ground Physics, Excelencia Junta Andalucia P08-TEP-03641 and "Ayudas Investigacion" from UPV. The authors would also like to thank Prof. Guillermo Rus for his valuable contributions.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Finite element analysis and material sensitivity of Peltier thermoelectric cells coolers

  • Pérez-Aparicio, José L.
  • Palma, Roberto
  • Taylor, R.L.
In this work, a finite element simulation of a commercial thermoelectric cell, working as a cooling heat pump, is presented. The specially developed finite element is three-dimensional, non-linear in its formulation (using quadratic temperature-dependence on material properties) and fully coupled, including the Seebeck, Peltier, Thomson and Joule effects. Another special interface finite element is developed to prescribe the electric intensity, taking advantage of repetitions and symmetries. A thorough study of the distributions of voltage, temperature and the corresponding fluxes is presented, and the performance of the cell is compared with that of the manufacturer and with simplified analytical formulations, showing a good agreement. Combining the finite element model with the Monte Carlo technique, a sensitivity analysis is presented to take into account the performance dependence on the material properties, geometrical parameters and prescribed values. This analysis, which can be considered a first step to optimize these devices, concludes that the temperature-dependence of the material properties of electric conductivity and Seebeck coefficient is very relevant on cell performance., This research was partially supported by the Ministry of Education through Grant FPU AP-2006-02372 and also from Grants MICINN BIA-2008-00522, MCyT DPI 2002-04472-C02-02 and Excelencia Junta Andalucia P08-TEP-3641.