Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 7
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Phenol photodegradation with oxygen and hydrogen peroxide over TiO2 and Fe-doped TiO2

  • Adán, Cristina
  • Carbajo Olleros, Jaime
  • Bahamonde, A.
  • Martínez Arias, Arturo
Photodegradation of phenol was investigated with two types of oxidant agents in water, oxygen and hydrogen peroxide, at two different reaction pH with a series of nanosized iron-doped anatase TiO2 catalysts with different iron contents. The catalysts have been prepared by a sol-gel/microemulsion method. Firstly, iron-doped titania catalysts were studied with respect to their activity behavior when oxygen was used as oxidant agent in the photocatalytic degradation of aqueous phenol in comparison with un-doped reference catalysts. Secondly, two catalysts (TiO2 and 0.7 wt.% Fe-doped TiO2) were selected to extend the study for the employment of hydrogen peroxide as oxidant at different concentrations and two initial reaction pHs. An enhancement of the photocatalytic activity is observed only for relatively low doping level (ca. 0.7 wt.%) in catalyst calcined at 450 °C preferably using hydrogen peroxide as oxidant agent which is attributable to the partial introduction of Fe3+ cations into the anatase structure. Nevertheless, it has been demonstrated that catalyst surface properties can play an important role during phenol photodegradation process on the basis of the analysis of differences found in the photoactivity as a function of reaction pH. © 2008., The authors would like to thank the MEC projects CTQ2004-03409/BQU, CTQ2006-15600/BQU and CTM2007-60577/TECNO and CSIC (project PIF 200420F0280) for financial support.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Optimization of H2O2 use during the photocatalytic degradation of ethidium bromide with TiO2 and iron-doped TiO2 catalysts

  • Carbajo Olleros, Jaime
  • Adán, Cristina
  • Rey Barroso, Ana
  • Martínez Arias, Arturo
  • Bahamonde, A.
A series of nanosized iron-doped titania catalysts has been used for the photocatalytic degradation of ethidium bromide (EtBr) with oxygen. The study shows that EtBr surface adsorption is most favored over basic titania surfaces such as those present in undoped TiO2 and Fe-TiO2 with low iron content. This fact is shown to affect strongly the photocatytic mechanism of EtBr degradation. Based on EtBr adsorption and photocatalytic activity analyses, a titania catalyst with an iron content of 0.7wt.% has been selected for subsequent studies using H2O2 as oxidant. Parameters as reaction pH and initial hydrogen peroxide concentration were analyzed to establish optimum operating conditions. It is shown that a new strategy based on dosing H2O2 in a controlled way could minimize radical self-scavenging reactions and improves final EtBr mineralization degree. Finally, the stability and durability of catalyst/activity have been examined through five consecutive cycles of H2O2 dosing. A constant activity level is maintained during at least four consecutive cycles in which total EtBr and 80% of Total Organic Carbon conversion is achieved. © 2010., Spanish MICINN for the financial support of the CTM2007-60577/TECNO project, and J. Carbajo also acknowledges the FPI grant to the MICINN.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Solar light assisted photodegradation of phenol with hydrogen peroxide over iron-doped titania catalysts: Role of iron leached/readsorbed species

  • Adán, Cristina
  • Carbajo Olleros, Jaime
  • Bahamonde, A.
  • Oller, Isabel
  • Malato, Sixto
  • Martínez Arias, Arturo
Nanostructured iron-doped TiO2 catalysts with anatase structure and two different iron contents (0.7 and 3.5wt.%) have been prepared by a combined sol-gel/microemulsion method and examined with respect to their behaviour for photocatalytic degradation of aqueous phenol with H2O2 under solar light. The activity results are compared with those obtained for similarly prepared undoped systems as well as Degussa P25 reference catalyst and have been complemented with structural/morphological and electronic characterization analyses achieved by XRD, TEM, Raman, SBET, UV-vis DRS and XPS techniques. In contrast to typically observed results, the highest photoactivity is obtained for the catalyst with highest iron loading while that with 0.7% Fe displays lower photoactivity than undoped samples. Such unusual behaviour has been attributed to the contribution of new photoactive iron complexes generated on the surface of the catalyst as a consequence of iron leaching and readsorption processes taking place during the course of phenol photodegradation process. © 2011 Elsevier B.V., Thanks are due to the MEC (projects CTQ2004-03409/BQU, CTQ2006-15600/BQU and CTM2007-60577/TECNO) and CSIC (project PIF 200420F0280) and Programa de Acceso de Grandes Instalaciones Científicas Espanolas ˜ GIC-05-17,for financial support
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Role of the activated carbon surface on catalytic wet peroxide oxidation

  • Rey Barroso, Ana
  • Faraldos, Marisol
  • Bahamonde, A.
  • Casas, J. A.
  • Zazo, J. A.
  • Rodríguez, J. J.
[EN] Three activated carbons with fairly different characteristics have been checked in catalytic wet peroxide oxidation (CWPO) using phenol as a model compound for the purpose of learning the role of these materials which can be used as supports for the preparation of Fe or other metallic catalysts. A complex contribution of mixed effects is involved making difficult to predict the behavior of a given activated carbon. The surface of these materials promotes the undesirable decomposition of H2O2 to unreactive O2 instead of OH radicals in an extent depending on the nature and accessibility of the oxygen groups. A frankly basic surface including groups such as pyrone with an egg-shell type distribution on the carbon particle seems to be beneficial for a more effective decomposition of H 2O2 leading to a higher oxidation activity. The presence of iron in the activated carbon ashes is also an important factor which may hide in part other effects derived from the structure and surface composition of the carbon. However, that factor cannot explain by itself the differences found in the behavior of the activated carbons since two of them with a similar Fe content showed markedly different activities in CWPO of phenol. © 2008 American Chemical Society., Spanish Ministry of Education and Science by the financial support of the CTQ2007-61748/PPQ, CTQ2005-02284/PPQ, and CTM2007-60577/TECNO. Ana Rey acknowledges an FPU Grant from the Spanish Ministry of Education and Science.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Catalytic wet peroxide oxidation of phenol over Fe/AC catalysts: Influence of iron precursor and activated carbon surface

  • Rey Barroso, Ana
  • Faraldos, Marisol
  • Casas, J. A.
  • Zazo, J. A.
  • Bahamonde, A.
  • Rodríguez, J. J.
[EN] Different activated carbon-supported Fe catalysts have been prepared and tested in CWPO of phenol. Three well characterized activated carbons and two iron precursors (iron nitrate and iron pentacarbonyl) have been used. The behavior of these catalysts in CWPO has been related with their porous structure, surface composition, in terms of oxygen groups and Fe distribution onto the catalyst particles. The catalysts with a more uniform distribution of Fe showed a higher oxidation activity than the ones with an internal (egg-yolk type) or external (egg-shell type) distribution. These last provoke a faster decomposition of H2O2 mainly to O2, non-reactive at the mild reaction temperature used (50º C). No significant differences were observed from the iron precursors. Complete conversion of phenol and almost 80 % mineralization were obtained in less than 2 hours with the best catalyst. The residual by-products consisted in short-chain organic acids without significance in terms of toxicity. Fe leaching was observed in all the cases which can be mainly attributed to the presence of oxalic acid as oxidation by-product, refractory to the CWPO process investigated. The intensity of Fe leaching was related with the concentration of oxalic acid, This work has been supported by the Spanish Plan Nacional de I+D+i through the projects CTM2007-60577/TECNO, CTQ2007-1661748/PPQ and CTQ2005-02284/PPQ. Ana Rey thanks to the Ministerio de Educación y Ciencia (MEC) for a FPU Grant., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Optimizing calcination temperature of Fe/activated carbon catalysts for CWPO

  • Zazo, J. A.
  • Fraile, A. F.
  • Rey Barroso, Ana
  • Bahamonde, A.
  • Casas, J. A.
  • Rodriguez, J. J.
[EN] The influence of the calcination temperature (within the temperature range 150-300 °C) on the chemical nature of the surface as well as on the activity of an own-made Fe/AC catalyst for catalytic wet peroxide oxidation (CWPO) has been studied. The catalyst surface was characterized by means of TG, TPD and N2 adsorption/desorption analysis. The presence of iron promotes the oxidation of the activated carbon surface, increasing the amount of oxygen surface groups, mainly carboxylic acid, anhydride and lactone groups. On the other hand, the calcination step modifies the distribution of these groups, increasing the amount of lactone groups and reducing the pHslurry. Within the temperature range studied, the calcination temperature does not affect to the porous structure. The changes observed in the catalyst surface led to an increase of the catalytic activity as a consequence of a higher H2O2 decomposition into OH{radical dot} radicals, probably due to a better dispersion of the active phase. Neither oxygen surface groups by themselves nor pHslurry seemed to have influence on the catalytic activity. © 2009 Elsevier B.V. All rights reserved., Financial support from the Spanish Plan Nacional I+D+I through the projects CTQ2005-02284/PPQ, CTQ2007-61748/PPQ and CTM2007-60577/TECNO and from the CAM through the project S-0505/AMB/0395.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Selectivity of hydrogen peroxide decomposition towards hydroxyl radicals in catalytic wet peroxide oxidation (CWPO) over Fe/AC catalysts

  • Rey Barroso, Ana
  • Bahamonde, A.
  • Casas, J. A.
  • Rodríguez, J. J.
[EN] Two Fe/AC catalysts prepared with different iron precursors (iron nitrate and iron pentacarbonyl) and the same AC support have been tested in H 2O2 decomposition in presence and absence of methanol, a known strong scavenger of hydroxyl radicals, to investigate the selectivity towards zOH formation in this reaction and their behavior in the CWPO of phenol. The catalyst prepared with iron nitrate, with the most oxidized surface and the highest Fe surface content, seems to favor a higher selectivity towards ·OH formation in CWPO allowing for complete phenol conversion and a significant TOC removal, with the highest mineralization degree at 508C and atmospheric pressure. Fe/AC catalysts were more efficient in the CWPO of phenol than in methanol presence due to a better use of the oxidant since adsorbed phenol on catalyst surface minimizes inefficient H2O2 decomposition to H2O and O2(g). The influence of the initial H2O2 concentration on phenol oxidation with this catalyst was also studied. A theoretical stoichiometric amount of H 2O2 for complete oxidation of phenol was chosen as the best starting concentration since auto-scavenging reactions can be minimized and it is sufficient for oxidizing phenol and the aromatic intermediates. © IWA Publishing 2010., Authors acknowledge financial support from the Spanish MICINN through the projects CTM2007-60577/TECNO, CTQ2007-61748/PPQ.