Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 5
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Determination of benzomercaptans in environmental complex samples by combining zeolitic imidazolate framework-8-based solid-phase extraction and high-performance liquid chromatography with UV detection

  • Martinez-Perez-Cejuela, Hector
  • Mompo-Rosello, Oscar
  • Crespi-Sanchez, Neus
  • Palomino Cabello, Carlos
  • Simo-Alfonso, Ernesto F.
  • Herrero-Martinez, Jose Manuel
  • Catalá-Icardo, Mónica|||0000-0001-5897-8501
[EN] In this work, the synthesis of zeolitic imidazolate framework-8 (ZIF-8) crystals and their subsequent application as effective sorbents for extraction and preconcentration of several benzomercaptans from environmental complex samples is described. These materials were prepared by solvothermal approach varying the concentration of n-butylamine modulator to modify the surface of the metal-organic framework. The resulting materials were characterized by scanning and transmission electron microscopy, powder X-ray diffraction and Fourier transform infrared spectroscopy. The ZIF-8 material that gave the best features was selected as extractive phase and the influence of various parameters (sample pH and elution solvent composition, among others) on the extraction efficiency of target compounds were investigated. Under the optimal conditions of the method, the tested analytes (2-mercaptobenzothiazole, 2-mercaptobenzoxazole and 2-mercapto-6-nitrobenzothiazole) were retained and eluted quantitatively with alkaline 50:50 (v:v) methanol-water mixture. Using the proposed method, low limits of detection, in the range of 16-21 ng L-1 for aqueous samples and 0.4-0.5 mu g kg(-1) for soil samples, were achieved whereas the precision (expressed as relative standard deviation) was lower than 7%. The resulting solid-phase extraction protocol, using the zeolitic material as sorbent, was combined with liquid chromatography and ultraviolet-vis detector and successfully applied to determine traces of these organic pollutants in environmental samples. (C) 2020 Elsevier B.V. All rights reserved., The authors would like to gratefully acknowledge the financial support received from the project RTI2018-095536-B-I00 (Ministry of Science, Innovation and Universities, Spain). Spanish Agencia Estatal de Investigacion (AEI-Spain) and the European Funds for Regional Development (FEDER-European Union) are also gratefully acknowledged for financial support through Project CTQ2016-77155-R (AEI/FEDER, UE).). H. M. P-C. and N.C. thank the support from the Spanish Ministry of Science, Innovation and Universities (MCIU) for FPU pre-doctoral fellowships. The authors extend their appreciation to MCIU for granting the Spanish Network of Excellence in Sample preparation (RED2018-102522-T). This article is based upon work from the Sample Preparation Task Force and Network, supported by the Division of Analytical Chemistry of the European Chemical Society.
Repositori Institucional UIB
Publicación Artículo científico (JournalArticle)

Nanoparticle@Metal-Organic Frameworks as a Template for Hierarchical Porous Carbon Sponges

  • Salazar-Beltran, Daniel
  • Palomino Cabello, Carlos
  • Guzman-Mar, Jorge
  • Hinojosa-Reyes, Laura
  • Turnes Palomino, Gemma
  • Maya Alejandro, Fernando
[eng] The preparation of hierarchical porous carbon sponges (HCS) from metal oxide nanoparticle@metal-organic frameworks is reported. ZnO nanoparticles are partially converted to zeolitic imidazolate framework-8 (ZIF-8) crystals in presence of n-butylamine to obtain ZnO@ZIF-8 porous hybrids. After direct carbonization, followed by ZnO acidic etching, ZnO@ZIF-8 crystals were converted to submicrometric HCS. Due to the high surface area and accessible porosity, combining micro- and mesoporosity of HCS, their application for the extraction of water pollutants was studied by preparing HCS/polymer membranes, and showed a high efficiency for the fast (650 Lm@2 h @1) removal of plastic degradation by-products (DBP, dibutyl phthalate. DEHP, bis(2-nethylhexyl)phthalate). DBP and DEHP breakthroughs were lower than 3% after the filtration of 100 mL of water containing simultaneously both phthalates at a high concentration level (300 mg L@1, each). HCS/polymer membranes were reusable up to 5 times, maintaining their extraction capacity, with relative errors of 6% for DBP, and <1% for DEHP.
Repositori Institucional UIB
Publicación Artículo científico (JournalArticle)

Iron metal-organic framework supported in a polymeric membrane for solid-phase extraction of anti-inflammatory drugs

  • Peña-Velasco, Gabriela
  • Hinojosa-Reyes, Laura
  • Escamilla-Coronado, Maricela
  • Turnes-Palomino, Gemma
  • Palomino-Cabello, Carlos
  • Guzmán-Mar, Jorge Luis
[eng] A solid-phase extraction methodology using a MIL-101(Fe)/PVDF membrane was proposed as a useful alternative for the simultaneous determination of naproxen, diclofenac, and ibuprofen, three antiinflammatory drugs (NSAIDs), in wastewater samples by HPLC-CCD analysis. The MIL-101(Fe) was prepared by a rapid microwave-assisted method and supported in a polymeric PVDF membrane. The prepared material was characterized by X-ray diffraction (XRD), nitrogen adsorption-desorption, scanning electron microscopy (SEM), X-ray photoelectron spectroscopy (XPS), and Fourier-transform infrared spectroscopy (FT-IR). The factors that affect the extraction of the NSAIDs using the MIL-101(Fe)/PVDF membrane as the sample volume, the solution pH and the elution solvent were studied in detail. The selected conditions were 50 mL of sample solution at pH 3 and 5 mL of methanol: acetone (30:70, v v1) acidified with formic acid at 2% as elution solvent. The analytical method was linear with determination coefficients (r2 0.998) in the calibration ranges from 2 to 100 ng mL1 for naproxen, 20e200 ng mL1 for diclofenac, and 100e300 ng mL1 for ibuprofen. The intra and inter-day precision (repeatability and reproducibility, respectively) of the method (RSD%, n ¼ 5) were lower than 4.8% and 7.1%, respectively. The accuracy reported as recovery percentages ranged from 82 to 118%, and the limits of detection were between 1.8 and 32.3 ng mL1. Moreover, MIL-101(Fe)/PVDF membrane exhibited improved adsorption efficiency compared to that of its analog MIL-101(Cr)/PVDF and the pristine PVDF membranes, obtaining in an easy and rapid (60 min) way a low-cost and low-toxic adsorbent with excellent stability, reusability, mechanic resistance, and simple operation which shows excellent performance.
Repositori Institucional UIB
Publicación Artículo científico (JournalArticle)

Immobilization of Metal-Organic Frameworks on Supports for Sample Preparation and Chromatographic Separation

  • Maya, Fernando
  • Palomino Cabello, Carlos
  • Figuerola, Andreu
  • Turnes Palomino, Gemma
  • Cerda, Victor
[eng] Metal-organic frameworks (MOFs) are porous crystalline materials with large surface areas, uniform pore size, and tunable selectivity. In the last few years, the number of analytical applications of MOFs has been growing constantly. However, the direct use of as-synthesized MOFs in packed column format is rather limited for analytical separations because of the small size and non-spherical shape of MOF crystals. In this review, we outline and critically discuss the advantages and limitations of the different methods described to immobilize MOFs into functional supports for analytical separations, including beads, monoliths, and fibers. These methods are based on embedding MOF crystals into functional supports, in situ MOF growth, controlled layer-by-layer MOF growth, or the in situ conversion of immobilized MOF metal oxide precursors. Representative examples of immobilized MOFs for sample preparation and chromatographic separation are overviewed. We also overview recent progress on the use of MOFs as precursors to obtain other functional materials such as layered double hydroxides or porous carbons
Repositori Institucional UIB
Publicación Artículo científico (JournalArticle)

Coupled heterogeneous photocatalysis using a P-TiO2-αFe2O3 catalyst and K2S2O8 for the efficient degradation of a sulfonamide mixture

  • Mendiola-Alvareza, Sandra Y.
  • Palomino-Cabello, Carlos
  • Hernandez-Ramirez, Aracely
  • Turnes-Palomino, Gemma
  • Guzman-Mar, Jorge L.
  • Hinojosa-Reyes, Laura
[eng] Phosphorous-doped Ti-Fe mixed oxide (P-TiO2-αFe2O3) catalysts were prepared by the microwave-assisted sol-gel route and characterized using XRD, SEM, N2 physisorption, UV-vis diffuse reflectance, FTIR, and XPS. P-TiO2-αFe2O3 was evaluated during the degradation of a sulfonamide mixture (5 mg/L, each) under visible light. The photocatalytic process was optimized with a face-centered central composite design. Under optimal conditions (0.5 wt% of αFe2O3, pH 10, and 0.75 g/L of catalyst loading), the sulfate radical advanced oxidation process was carried out using 5 mM K2S2O8 (PS). P doping shifted the light absorption of P-TiO2-αFe2O3 in the visible light range owing to substitutional doping, while the coupling of P-TiO2 with α-Fe2O3 enhanced the absorption in the visible range, which resulted in an increase in the lifetime of the charge carriers and in a superior photoactivity of the P-TiO2-αFe2O3 catalyst in comparison to that of TiO2. The mineralization yield of the sulfonamides (SNs) mixture was enhanced in the presence of an electron acceptor (SO4−radical dot), allowing nearly 69 % within 300 min with the P-TiO2-αFe2O3/PS system, while P-TiO2-αFe2O3 and K2S2O8 oxidation achieved only 27 % and 21 %, respectively. The biodegradability index was 0.48 using the P-TiO2-αFe2O3/PS system, indicating a less toxic effluent than the original compounds. Recycling tests demonstrated that P-TiO2-αFe2O3 exhibits good stability in activating PS for SNs degradation during three cycles. Two main intermediates (pyrimidine and hydroquinone) and their hydroxylated re-arrangements were detected during the degradation of the SNs by the coupled process. Oxalic, oxamic, sulfonic, and acetic acids were also identified as by-products from the degradation of the SNs