Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 1
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Problems in laser repair cladding a surface AISI D2 heat-treated tool steel

  • Candel Bou, Juan José
  • Ramos de Campos, José Antonio
  • Amigó, Vicente|||0000-0002-2107-0273
  • Busquets Mataix, David Jeronimo|||0000-0001-5031-7805
The aim of the present work is to establish the relationship between laser cladding process parameters (Power, Process Speed and Powder feed rate) and AISI D2 tool steel metallurgical transformations, with the objective of optimizing the processing conditions during real reparation. It has been deposited H13 tool steel powder on some steel substrates with different initial metallurgical status (annealed or tempered) using a coaxial laser cladding system. The microstructure of the laser clad layer and substrate heat affected zone (HAZ) was characterized by Optical microscopy, Scanning Electron Microscopy (SEM) and Electron Backscattered Diffraction (EBSD). Results show that the process parameters (power, process speed, feed rate ...) determine the dimensions of the clad layer and are related to the microstructure formation. Although it is simple to obtain geometrically acceptable clads (with the right shape and dimensions) in many cases occur some harmful effects as carbide dilution and non-equilibrium phases formation which modify the mechanical properties of the coating. Specifically, the presence of retained austenite in the substrate-coating interface is directly related to the cooling rate and implies a hardness diminution that must be avoided. It has been checked that initial metallurgical state of the substrate has a big influence in the final result of the deposition. Tempered substrates imply higher laser absorption and heat accumulation than the ones in annealed condition. This produces a bigger HAZ. For this reason, it is necessary to optimize process conditions for each reparation in order to improve the working behaviour of the component., The authors thank the Ministry of Education and Science for the financing of this investigation through project DPI2005-09244-C04-04 under the Industrial Production Programme of theNational Plan and its continuity with project MAT2008-06882-C04-04/MAT of the Ministry of Science and Innovation.