Pasar al contenido principal

PROCESADO, CARACTERIZACION E IRRADIACION DE ALEACIONES NANOESTRUCTURADAS DE CU, W-CU Y DE ACEROS ODS PARA REACTORES DE FUSION

ENE2015-70300-C3-2-R

•
Nombre agencia financiadora Ministerio de Economía y Competitividad
Acrónimo agencia financiadora MINECO
Programa Programa Estatal de I+D+i Orientado a los Retos de la Sociedad
Convocatoria Proyectos I+D+i Retos de Investigación
Año convocatoria 2015
Plan Estatal 2013-2016 Plan Estatal de Investigación Científica y Técnica y de Innovación
Unidad de gestión Dirección General de Investigación Científica y Técnica
Centro beneficiario UNIVERSIDAD CARLOS III DE MADRID
Identificador persistente http://dx.doi.org/10.13039/501100003329

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Positron Annihilation Spectroscopy Study of Carbon-Vacancy Interaction in Low-Temperature Bainite

  • Rementería, Rosalía
  • Domínguez-Reyes, Ricardo
  • Capdevila, Carlos
  • García Mateo, Carlos
  • García Caballero, Francisca
Nano-scale investigations of bainitic structures formed at temperatures below 350 °C have shown that the bainitic ferrite lattice is super-saturated in carbon. A high density of intrinsic defects would be playing a part in the carbon-supersaturation levels detected. In this work, the role of C−vacancy complexes on carbon-supersaturation in low temperature bainite is investigated by means of Positron Annihilation Spectroscopy. Results reveal the presence of a significant amount of monovacancies in the structures that plays an important role on the formation of carbon clusters in the ferrite lattice of nano-scale bainitic structures., Tis research was supported by the Spanish Ministerio de Economia y Competitividad (MINECO) in the form of a Coordinate Project (MAT2016-80875-C3-1-R and ENE2015-70300-C3-2-R); by the Regional Government of Madrid through the programs S2013/MAE-2745 TECHNOFUSION(II)-CM MINECO/FEDER, and S2013/MIT-2862-MULTIMAT-CHALLENGE; and the Research Fund for Coal and Steel under the Contracts RFCS-CT-2015-709607 and RFCS-CT-2016-754070.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

High-heat flux Cu-0.8Y alloys investigated by positron annihilation spectroscopy

  • Domínguez-Reyes, Ricardo
  • Monge, M. Ángeles
  • Galiana, Beatriz
  • Ortega, Y.
  • Muñoz, A.
  • Carro-Sevillano, Gabriel
This work studies the thermal stability of the microstructure and the evolution of the defects of two high-heat flux Cu-0.8 wt%Y alloys fabricated following two alternative powder metallurgy routes. One batch was produced by direct hot isostatic pressing (HIP) consolidation of Cu-0.8 wt%Y pre-alloyed atomized powders while an additional ball milling processing step was introduced before HIP sintering for the second alloy. The stability and recovery characteristics of the vacancy type defects in these alloys in the as-produced state and after processing by severe equal channel angular pressing to achieve a refine microstructure have been investigated by positron lifetime and coincidence Doppler broadening measurements in samples subjected to isochronal annealing from room temperature to 900 °C. Microhardness measurements and electron transmission microscopy analysis have also been performed to support the results obtained from the positron annihilation spectroscopy analysis techniques. The recovery curves of the positron lifetime and S-W plots show a recovery stage in agreement with the recovery stage V for Cu. However, a full recovery is not accomplished, and a stage that reverts the previous recovery takes place after annealing above ~600 °C, that leads to the formation of very stable defects at temperatures up to 900 °C, identified as vacancy aggregates and nanocavities. The characteristic shape of the coincidence Doppler broadening indicates that the dispersed Y-O particles in the Cu matrix appear to be responsible for stabilizing the vacancy aggregates and nanocavities for temperatures above 600–700 °C., This research was supported by the Spanish Ministerio de Economia y Competitividad (MINECO) in the form of Project ENE2015-70300-C3-2-R and by the Regional Government of Madrid (Spain) through TECHNOFUSIÓN(III)CM (S2018/EMT-4437), and Comunidad de Madrid (Spain) - multiannual agreement with UC3M (“Excelencia para el Profesorado Universitario” - EPUC3M14) - Fifth regional research plan 2016–2020; and also Spanish Ministerio de Ciencia e Innovación through project DAMAINSOL [grant number RTI2018-101020-B-I00].