Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Bioinspired design of triboceramics: Learning from the anisotropic microfracture response of dental enamel under sliding contact

  • Sanchez-Gonzalez, Estibaliz
  • Rodriguez-Rojas, Fernando
  • Borrero-Lopez, Oscar
  • Ortiz, Angel L.
  • Guiberteau, Fernando
  • Pinilla-Cienfuegos, Elena|||0000-0002-3734-0821
[EN] In the quest for novel ceramics for tribological applications via bioinspired design, the differences in the fracture modes that arise upon scratching relevant locations of ceramic-like tooth enamel are investigated. It is found that fracture initiates from weak rod-sheath interfaces at relatively low loads, independent of the sliding direction. However, the geometry and propagation of the cracks depends on the orientation of the interfaces relative to the maximum tensile stress: scratching along the occlusal surface propagates approximately sinusoidal cracks, parallel to the sliding direction, while scratching along the cross-section produces straight cracks that propagate normal (scratch parallel to occlusal surface) or parallel (scratch perpendicular to occlusal surface) to the sliding direction. The formation of cracks is hindered in scratching near the enamel-dentine junction. Implications for the microstructural design of triboceramics (bulks and coatings) with improved durability are discussed., The authors wish to thank Dr Florencio Monje Gil for kindly providing tooth specimens from his clinic (CICOM, Centro de Implantologia Cirugia Oral y Maxilofacial, Badajoz, Spain). This study was supported by Junta de Extremadura, Spain, and FEDER/ERDF funds (grants IB16139 and GR18149), and the Spanish Ministry of Science and Innovation (grant PID2019-105377RB-I00). E. P.-C. gratefully acknowledges support from the Spanish Ministry of Economy and Competitiveness (MINECO) under grant FJCI-2015-27228.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Contact damage of human dental enamel under cyclic axial loading with abrasive particles

  • Sanchez-Gonzalez, Estibaliz
  • Borrero-Lopez, Oscar
  • Rodriguez-Rojas, Fernando
  • Guiberteau, Fernando
  • Pinilla-Cienfuegos, Elena|||0000-0002-3734-0821
[EN] The damage to human dental enamel under cyclic, axial contacts in a silica particle medium is investigated. It is found that such damage is hierarchical, affecting different length-scales of the enamel structure. At the contact surface, it consists of micron-sized defects, with an attendant increase of surface roughness due to micro-indentation of the abrasive particles. Below the surface, demineralization of the enamel is observed, which is attributable to inelastic processes at the nanoscale. Axial-only contacts in particulate media result in negligible wear at the macroscopic scale, but may degrade the fracture strength. Potential implications of these results in the fields of dentistry and biology are discussed., The authors wish to thank Dr. Florencio Monje Gil for kindly providing tooth specimens from his clinic (CICOM, Centro de Implantologfa Cirugfa Oral y Maxilofacial, Badajoz, Spain). Fruitful discussions with Dr. Brian Lawn (National Institute of Standards and Technology, NIST, MD), Dr. Antonia Pajares (Universidad de Extremadura, Spain), Dr. Todora Ivanova Angelova (NTC; Universitat Politecnica de Valencia, Spain) and Dr. Paul Constantino (St. Michael's College, VT) are gratefully acknowledged. This study was supported by Junta de Extremadura, Spain, and FEDER/ERDF funds (grant IB16139 and GR18149). E. P. -C. gratefully acknowledges support from the Spanish Ministry of Economy and Competitiveness (MINECO) under grant FJCI-2015-27228.