Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 3
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Thermally Rearranged Polybenzoxazoles Containing Bulky Adamantyl Groups from Ortho-Substituted Precursor Copolyimides

  • Aguilar-Lugo, Carla
  • Álvarez, Cristina
  • Lee, Young M.
  • Campa, José G. de la
  • Lozano López, Ángel Emilio
A new nucleophilic monomer (2,2-bis(3-amino-4-hydroxyphenyl)adamantane, ADHAB) having bulky adamantane groups has been synthesized following an efficient synthetic methodology. The main target of this work was to employ a high thermal stable bulky cycloaliphatic moiety as adamantane to obtain aromatic ortho-hydroxypolyimides (poly(o-hydroxyimide)s) able to thermally rearrange to give polybenzoxazole (TR-PBO) materials that could be tested as gas separation membranes. Thus, an array of ortho-acetylcopolyimides, o-acetyl PIs) were prepared by reaction of ADHAB and 2,2-bis(3-amino-4-hydroxyphenyl)hexafluoropropane (APAF) with 2,2-bis(3,4-dicarboxyphenyl)hexafluoropropane dianhydride (6FDA) via chemical imidization. Copolyimides and homopolyimides showed inherent viscosities ranging from 0.49 to 0.70 dL/g and provided good-quality dense membranes. Glass transition temperatures of these o-acetyl copolyimides were higher as the amount of ADHAB increased. The thermal stability of the adamantane moiety during the TR process was evaluated by directly synthesizing PBOs, which were made from the reaction, and ulterior thermal cyclization, of 2,2-bis(4-chlorocarbonylphenyl)-hexafluoropropane with ADHAB/APAF. TR-PBO membranes made through a thermal treatment at 450 °C for 30 min showed excellent gas separation properties for the CO/CH gas pair with values close to the 2008 Robeson limit., The authors acknowledge financial support provided by Spain’s MINECO (CTQ2013-48406-P, MAT2016-76413-C2-R1, and MAT2016-76413-C2-R2). This research was also supported by the Korea Carbon Capture & Sequestration R&D Center (KCRC) administered through the National Research Foundation of Korea (NRF) funded by the Ministry of S c i e n c e , IC T , a n d Fu t u r e Pl anni n g (NRF - 2014M1A8A1049305). We are also indebted to the Spanish Junta de Castilla y León for funding help (Projects VA248U13 and VA256U13). C. Aguilar-Lugo gratefully acknowledges a CONACYT postdoctoral fellowship (264013)., Peer Reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Partially pyrolized gas-separation membranes made from blends of copolyetherimides and polyimides

  • Escorial, Lucia
  • Viuda, Monica de la
  • Rodríguez, Sara
  • Tena, Alberto
  • Marcos-Fernández, Ángel
  • Palacio, Laura
  • Prádanos, Pedro
  • Lozano López, Ángel Emilio
  • Hernández, Antonio
Herein, a new approach to achieve gas separation materials with improved resistance to plasticization (obtained by partial pyrolysis of new polyimide blends) is presented. Blends of an aromatic polyimide (formally, 6FDA-6FpDA) and aliphatic-aromatic copolyetherimides based on the same polyimide in combination with other aliphatic polyimides, having polyethylene oxide moieties, were obtained. After their synthesis and characterization, a selective elimination of the polyether by thermal treatment was carried and the obtained partially pyrolyzed materials were tested as gas separation membranes. For neat blends, permeability was shown to decrease when PEO content increases. This effect is due to polyethylene oxide (PEO) chains encroaching on free volume because phase segregation was minimized. When these blends were subjected to thermal treatment at relatively low temperatures in air or in N2, it was clearly observed that all the polyether moieties were selectively eliminated from the structure, which gave rise to an increase of permeability. Higher permeabilities were obtained after a thermal treatment at 390 °C in N2. Degradation of PEO chains after a 290 °C treatment in air produced materials with permeability values lower than those observed under N2. In both cases, even though PEO was selectively and wholly eliminated, permeability was not totally recovered to give the values observed for neat 6FDA-6FpDA due probably to a combination of shrinkage and crosslinking of the membrane produced during the thermal process. Crosslinking provides the materials with an increased resistance to plasticization. In particular, the best improvement against plasticization proceeded from the thermal treatments of blends at 290 °C in air., Authors would like to thank the Spanish MINECO for the financial support of this work within the frame of the Plan Nacional de I+D+I through the research MAT2016-76413-C2-R1 and MAT2016-76413-C2- R2., Peer Reviewed
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Effects of Protonation, Hydroxylamination, and Hydrazination of g-C3N4 on the Performance of Matrimid®/g-C3N4 Membranes

  • Soto-Herranz, María
  • Sánchez-Báscones, Mercedes
  • Hérnandez-Giménez, Antonio
  • Calvo-Díez, José I.
  • Martín-Gil, Jesús
  • Martín Ramos, Pablo
One of the challenges to continue improving polymeric membranes properties involves the development of novel chemically modified fillers, such as nitrogen-rich 2-D nanomaterials. Graphitic carbon nitride (g-C3N4) has attracted significant interest as a new class of these fillers. Protonation is known to afford it desirable functionalities to form unique architectures for various applications. In the work presented herein, doping of Matrimid® with protonated g-C3N4 to yield Matrimid®/g-C3N4 mixed matrix membranes was found to improve gas separation by enhancing the selectivity for CO2/CH4 by up to 36.9% at 0.5 wt % filler doping. With a view to further enhancing the contribution of g-C3N4 to the performance of the composite membrane, oxygen plasma and hydrazine monohydrate treatments were also assayed as alternatives to protonation. Hydroxylamination by oxygen plasma treatment increased the selectivity for CO2/CH4 by up to 52.2% (at 2 wt % doping) and that for O2/N2 by up to 26.3% (at 0.5 wt % doping). Hydrazination led to lower enhancements in CO2/CH4 separation, by up to 11.4%. This study suggests that chemically-modified g-C3N4 may hold promise as an additive for modifying the surface of Matrimid® and other membranes.