Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Aromatic poly(ether ether ketone)s capable of crosslinking via UV irradiation to improve gas separation performance

  • Puertas-Bartolomé, María
  • Dose, M. E.
  • Bosch, Paula
  • Freeman, Benny D.
  • McGrath, J. E.
  • Riffle, J. S.
  • Lozano López, Ángel Emilio
  • González de la Campa, José
  • Álvarez, Cristina
The effect of UV-crosslinking on the gas transport properties of two poly(ether ether ketone)s derived from difluorobenzophenone and two bisphenol derivatives, with four (TMBP-DFB) or six (HMBP-DFB) methyl groups, has been studied. The crosslinking reaction was conducted on dense membranes, using polychromatic light, with wavelengths higher than 350 nm, at room temperature and in presence of air. Both polymers were able to produce crosslinked membranes, with gel fractions close to 75%, but a shorter irradiation time was required for HMBP-DFB. A DFT quantum mechanical study has stated that HMBP-DFB radical formation is much easier than for TMBP-DFB, which would support the fastest kinetics of the crosslinking process for HMBP-DFB. The crosslinked membranes have shown greatly improved gas transport properties, especially for the O2/N2 gas pair, where the Robeson upper bound line of 1991 was clearly surpassed. The improvement in selectivity has been ascribed to the better molecular-sieving characteristics of crosslinked membranes, We acknowledge the Financial support provided by MINECO (MAT2013-45071-R, CTQ2012-31076 and MAT2016-76413-C2- R2) and by the National Science Foundation under grant number IIP-1237857. Authors wish to thank Judit González for helping with the characterization of polymers, Peer Reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Thermally Rearranged Polybenzoxazoles Containing Bulky Adamantyl Groups from Ortho-Substituted Precursor Copolyimides

  • Aguilar-Lugo, Carla
  • Álvarez, Cristina
  • Lee, Young M.
  • Campa, José G. de la
  • Lozano López, Ángel Emilio
A new nucleophilic monomer (2,2-bis(3-amino-4-hydroxyphenyl)adamantane, ADHAB) having bulky adamantane groups has been synthesized following an efficient synthetic methodology. The main target of this work was to employ a high thermal stable bulky cycloaliphatic moiety as adamantane to obtain aromatic ortho-hydroxypolyimides (poly(o-hydroxyimide)s) able to thermally rearrange to give polybenzoxazole (TR-PBO) materials that could be tested as gas separation membranes. Thus, an array of ortho-acetylcopolyimides, o-acetyl PIs) were prepared by reaction of ADHAB and 2,2-bis(3-amino-4-hydroxyphenyl)hexafluoropropane (APAF) with 2,2-bis(3,4-dicarboxyphenyl)hexafluoropropane dianhydride (6FDA) via chemical imidization. Copolyimides and homopolyimides showed inherent viscosities ranging from 0.49 to 0.70 dL/g and provided good-quality dense membranes. Glass transition temperatures of these o-acetyl copolyimides were higher as the amount of ADHAB increased. The thermal stability of the adamantane moiety during the TR process was evaluated by directly synthesizing PBOs, which were made from the reaction, and ulterior thermal cyclization, of 2,2-bis(4-chlorocarbonylphenyl)-hexafluoropropane with ADHAB/APAF. TR-PBO membranes made through a thermal treatment at 450 °C for 30 min showed excellent gas separation properties for the CO/CH gas pair with values close to the 2008 Robeson limit., The authors acknowledge financial support provided by Spain’s MINECO (CTQ2013-48406-P, MAT2016-76413-C2-R1, and MAT2016-76413-C2-R2). This research was also supported by the Korea Carbon Capture & Sequestration R&D Center (KCRC) administered through the National Research Foundation of Korea (NRF) funded by the Ministry of S c i e n c e , IC T , a n d Fu t u r e Pl anni n g (NRF - 2014M1A8A1049305). We are also indebted to the Spanish Junta de Castilla y León for funding help (Projects VA248U13 and VA256U13). C. Aguilar-Lugo gratefully acknowledges a CONACYT postdoctoral fellowship (264013)., Peer Reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Synthesis, characterization and gas separation properties of novel polyimides containing cardo and tert-butyl-m-terphenyl moieties

  • Bermejo, L. A.
  • Álvarez, Cristina
  • Maya, Eva M.
  • García Sánchez, Carolina
  • González de la Campa, José
  • Lozano López, Ángel Emilio
series of aromatic polyimides has been obtained by the reaction of two dianhydrides, the commercial 2,2'- bis(3,4-dicarboxyphenyl)hexafluoropropane dianhydride (6FDA) and another having a 5'-tert-butyl-m-terphenyl moiety (BTPDA), with several diamines, including two that have a cardo structure (derived from 9H-fluorene), one of them bearing methyl groups ortho to the amino functionalities (TMeCardo). The solubility, and also the thermal, mechanical, and gas separation properties of the corresponding polyimide membranes were evaluated and compared in order to explore the effect of the different groups in the polyimide backbone. The novel polyimides, which were derived from BTPDA and the cardo diamines, showed high thermal stability, excellent solubility in organic solvents and good gas separation properties, especially the polyimide that bore the ortho methyl substituents. The behavior was especially good for the pair O/N, where the TMeCardo polymer overpassed the Robeson upper bound., The financial support of this work by the Spanish Ministry of Economy and Competitiveness (MINECO) (MAT2013- 45071, CTQ2013-48406-P, MAT2016-76413-C2-R2) is greatly appreciated., Peer Reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Partially pyrolized gas-separation membranes made from blends of copolyetherimides and polyimides

  • Escorial, Lucia
  • Viuda, Monica de la
  • Rodríguez, Sara
  • Tena, Alberto
  • Marcos-Fernández, Ángel
  • Palacio, Laura
  • Prádanos, Pedro
  • Lozano López, Ángel Emilio
  • Hernández, Antonio
Herein, a new approach to achieve gas separation materials with improved resistance to plasticization (obtained by partial pyrolysis of new polyimide blends) is presented. Blends of an aromatic polyimide (formally, 6FDA-6FpDA) and aliphatic-aromatic copolyetherimides based on the same polyimide in combination with other aliphatic polyimides, having polyethylene oxide moieties, were obtained. After their synthesis and characterization, a selective elimination of the polyether by thermal treatment was carried and the obtained partially pyrolyzed materials were tested as gas separation membranes. For neat blends, permeability was shown to decrease when PEO content increases. This effect is due to polyethylene oxide (PEO) chains encroaching on free volume because phase segregation was minimized. When these blends were subjected to thermal treatment at relatively low temperatures in air or in N2, it was clearly observed that all the polyether moieties were selectively eliminated from the structure, which gave rise to an increase of permeability. Higher permeabilities were obtained after a thermal treatment at 390 °C in N2. Degradation of PEO chains after a 290 °C treatment in air produced materials with permeability values lower than those observed under N2. In both cases, even though PEO was selectively and wholly eliminated, permeability was not totally recovered to give the values observed for neat 6FDA-6FpDA due probably to a combination of shrinkage and crosslinking of the membrane produced during the thermal process. Crosslinking provides the materials with an increased resistance to plasticization. In particular, the best improvement against plasticization proceeded from the thermal treatments of blends at 290 °C in air., Authors would like to thank the Spanish MINECO for the financial support of this work within the frame of the Plan Nacional de I+D+I through the research MAT2016-76413-C2-R1 and MAT2016-76413-C2- R2., Peer Reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

New Materials for Gas Separation Applications: Mixed Matrix Membranes Made from Linear Polyimides and Porous Polymer Networks Having Lactam Groups

  • Aguilar-Lugo, Carla
  • Suárez-García, Fabian
  • Hernández, Antonio
  • Miguel, Jesús A.
  • Lozano López, Ángel Emilio
  • Campa, José G. de la
  • Álvarez, Cristina
A set of mixed matrix membranes (MMMs) has been prepared by incorporating a triptycene-isatin porous polymer network (PPN) to three aromatic polyimides (one commercial, Matrimid, and two synthesized by us: 6FDA-6FpDA and 6FDA-TMPD) covering a wide range of performances for gas separation. The triptycene-isatin PPN is a highly microporous network having a high CO uptake and high chemical and thermal stability. The good compatibility between the components (PPN content of 15 and 30% w/w) was supported by the increase in the glass transition temperature of MMMs relative to the pure polyimide membranes. The addition of the PPN particles improved the permeability of all the gases tested, by increasing diffusivity and, in some cases, gas solubility. The improvements were particularly noticeable in Matrimid-based MMMs, where gas permeability increased by 700%, whereas CO/N and CO/CH ideal selectivities decreased by a mere 4% and 12%, respectively., We gratefully acknowledge Dr. Manuel Avella-Romero for the SEM images taken at the SEM−TEM Microscopy Facilities of the University of Valladolid; and Judit González Jarillo for the characterization of the mixed matrix membranes and the gas separation measurements. This work was supported by Spain’s MINECO (Projects MAT2016−76413-C2-R2, MAT2016− 76413-C2-R1, MAT2015−69844-R, and CTQ2016−80913- P), and the Spanish Junta de Castilla y León (Projects VA248U13 and VA051P17). Finally, we dedicate this article to Professor Pablo Espinet on his 70th birthday, Peer Reviewed
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Effects of Protonation, Hydroxylamination, and Hydrazination of g-C3N4 on the Performance of Matrimid®/g-C3N4 Membranes

  • Soto-Herranz, María
  • Sánchez-Báscones, Mercedes
  • Hérnandez-Giménez, Antonio
  • Calvo-Díez, José I.
  • Martín-Gil, Jesús
  • Martín Ramos, Pablo
One of the challenges to continue improving polymeric membranes properties involves the development of novel chemically modified fillers, such as nitrogen-rich 2-D nanomaterials. Graphitic carbon nitride (g-C3N4) has attracted significant interest as a new class of these fillers. Protonation is known to afford it desirable functionalities to form unique architectures for various applications. In the work presented herein, doping of Matrimid® with protonated g-C3N4 to yield Matrimid®/g-C3N4 mixed matrix membranes was found to improve gas separation by enhancing the selectivity for CO2/CH4 by up to 36.9% at 0.5 wt % filler doping. With a view to further enhancing the contribution of g-C3N4 to the performance of the composite membrane, oxygen plasma and hydrazine monohydrate treatments were also assayed as alternatives to protonation. Hydroxylamination by oxygen plasma treatment increased the selectivity for CO2/CH4 by up to 52.2% (at 2 wt % doping) and that for O2/N2 by up to 26.3% (at 0.5 wt % doping). Hydrazination led to lower enhancements in CO2/CH4 separation, by up to 11.4%. This study suggests that chemically-modified g-C3N4 may hold promise as an additive for modifying the surface of Matrimid® and other membranes.