Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 3
Encontrada(s) 1 página(s)

Recercat. Dipósit de la Recerca de Catalunya
Publicación Artículo científico (JournalArticle)

Flocculation of Cellulose Microfiber and Nanofiber Induced by Chitosan–Xylan Complexes

  • Bastida, Gabriela A.
  • Tarrés Farrés, Joaquim Agustí
  • Aguado, Roberto J.
  • Aguilar, Marc
  • Zanuttini, Miguel A.
  • Galván, María V.
This study aims to provide a comprehensive understanding of the key factors influencing the rheological behavior and the mechanisms of natural polyelectrolyte complexes (PECs) as flocculation agents for cellulose microfibers (CMFs) and nanofibers (CNFs). PECs were formed by combining two polyelectrolytes: xylan (Xyl) and chitosan (Ch), at different Xyl/Ch mass ratios: 60/40, 70/30, and 80/20. First, Xyl, Ch, and PEC solutions were characterized by measuring viscosity, critical concentration (c*), rheological parameter, ζ-potential, and hydrodynamic size. Then, the flocculation mechanisms of CMF and CNF suspensions with PECs under dynamic conditions were studied by measuring viscosity, while the flocculation under static conditions was examined through gel point measurements, floc average size determination, and ζ-potential analysis. The findings reveal that PEC solutions formed with a lower xylan mass ratio showed higher intrinsic viscosity, higher hydrodynamic size, higher z-potential, and a lower c*. This is due to the high molecular weight, charge, and gel-forming ability. All the analyzed solutions behave as a typical non-Newtonian shear-thinning fluid. The flocculation mechanisms under dynamic conditions showed that a very low dosage of PEC (between 2 and 6 mg PEC/g of fiber) was sufficient to produce flocculation. Under dynamic conditions, an increase in viscosity indicates flocculation at this low PEC dosage. Finally, under static conditions, maximum floc sizes were observed at the same PEC dosage where minimum gel points were reached. Higher PEC doses were required for CNF suspensions than for CMF suspensions, This work was supported by: (a) Agencia I+D+I (PICT 2018 Nº 4410, PICT 2019 Nº 03246 and PICT 2020 Nº 02920); (b) CAI+D 2020 PI, Tipo II-Nº 50620190100135LI; (c) CONICET; (d) Spanish Ministry of Science and Innovation to the projects CON-FUTURO-ES (PID2020-113850RB-C22) and VALORCON-NC (PDC2021-120964-C22)
Recercat. Dipósit de la Recerca de Catalunya
Publicación Artículo científico (JournalArticle)

Sustainability of cellulose micro-/nanofibers: A comparative life cycle assessment of pathway technologies

  • Arfelis, Sergi
  • Aguado, Roberto J.
  • Civancik, Didem
  • Fullana i Palmer, Pere
  • Pèlach Serra, Maria Àngels
  • Tarrés Farrés, Joaquim Agustí
  • Aguilar, Marc
Cellulose micro- and nanofibers (CNFs) are commonly regarded as “greener” than petro-based materials. The high energy input that their production still demands, along with the use of chemicals or heat in some pretreatments, asks for a critical view. This paper attempts a life cycle assessment of CNFs produced from bleached hardwood kraft pulp via three different pre-treatments before mechanical homogenization. First, a fully mechanical route, based on a Valley beating pre-treatment. Second, an enzymatic route, based on endoglucanases and requiring certain temperature (~50 °C). Third, a TEMPO-mediated oxidation route, considering not only the impact of the chemical treatment itself but also the production of TEMPO from ammonia and acetone. The main output of the study is that both, mechanical and TEMPO-mediated oxidation routes, present lower impacts than the enzymatic pre-treatment. Although the mechanical route presents slightly milder contributions to climate change, acidification, eutrophication, and other indicators, saying that TEMPO-mediated oxidation is environmentally unfeasible should be put under question. After all, and despite being disregarded in most assessment publications up to date, it is the only well-known way to selectively oxidize primary hydroxyl groups and thus producing kinds of CNFs that are unthinkable by other ways., Authors wish to acknowledge the financial support of the Spanish Ministry of Science and Innovation to the projects CON-FUTURO-ES (PID2020-113850RB-C22) and VALORCON-NC (PDC2021-120964-C22), 9
Recercat. Dipósit de la Recerca de Catalunya
Publicación Artículo científico (JournalArticle)

Kinetic study and real-time monitoring strategy for TEMPO-mediated oxidation of bleached eucalyptus fibers

  • Mazega Fontes, André
  • Santos Ferreira, Alexandre
  • Aguado, Roberto J.
  • Tarrés Farrés, Joaquim Agustí
  • Fiol Santaló, Núria
  • Pèlach Serra, Maria Àngels
  • Delgado Aguilar, Marc
The present work aims at glimpsing the rate-determinant process parameters of TEMPO-mediated oxidation of bleached kraft cellulose for developing kinetic models and real-time monitoring tools. This may contribute to the scaling up of this reaction, frequently used as precursor of the production of cellulose nanofibers. For this, the effect of temperature, TEMPO and NaBr contents, and surface area of the fibers was assessed by means of a total experimental batch of 18 combinations, monitoring the carboxyl content (CC) of the samples and the NaOH consumption during oxidation. The obtained data was used to calculate the kinetic constant as a function of the conditions, as well as correlating the CC with the NaOH consumption, obtaining a strong linear correlation between these parameters. It was found that similar correlations could be used regardless process conditions, except for the case of TEMPO, which was found to protect the fibers from depolymerization and, thus, having different behavior at increasing TEMPO contents. Overall, the obtained results in the present study reveal the suitability of upscaling TEMPO-mediated oxidation, as well as having a deeper understanding on how the key parameters involved in the reaction affect the reaction path and, thus, contributing to the industrial deployment of oxidized cellulose and nanofibers, The present work has been funded by the Spanish Ministry of Science and Innovation, projects CON-FUTURO-ES (PID2020-113850RB-C22) and VALORCON-NC (PDC2021-120964-C22). Alexandre Ferreira Santos received funding from the Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq, Brazil) for his research stay at University of Girona. André Mazega Fontes received funding for his PhD thesis by the University of Girona (PhD grant IFUdG2020), Open Access funding provided thanks to the CRUE-CSIC agreement with Springer Nature