Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 5
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Stochastic dynamics in first-order thermal Sigma-Delta modulation

  • Domínguez-Pumar, Manuel
  • Ceballos-Cáceres, J.
  • Torre Juárez, Manuel de la
  • Navarro, Sara
  • Marín, Mercedes
  • Gómez-Elvira, Javier
  • Rodríguez-Manfredi, José Antonio
The objective of this paper is the analysis of stochastic drifts in first-order thermal Sigma-Delta modulation due to the presence of noise at the input of the comparator. This type of temperature controls has been extensively used in constant temperature anemometry in three missions to Mars. It will be shown that the presence of additive zero-mean noise at the input of the comparator generates non-zero mean drifts on the controlled temperatures. These drifts may increase the response time of sensors working under Constant Temperature Operation (CTO). The case of the MEDA wind sensor in Mars2020 is analyzed, showing that even though this phenomenon slightly increases the response time above the expected thermal dynamics under perfect CTO, it is still below the 0.5 s requirement for the 90% response time. A comparison is presented between the modeled dynamics and measurements made in wind tunnel., This work has been partially funded by MICINN, Spain, grant nos. PID2021-126719OB-C41, PID2021-126719OB-C42, PID2021-126719OB-C43 by the Spain Ministry of Science, Innovation/State Agency of Research MCIN/AEI/ 10.13039/501100011033, by “ERDF A way of making Europe” TED2021-131442B-C32 and PDC2023-145889-C22; AGAUR, Spain, grant no. 56 30142 2021 2A, CPP2021-008740 and CPP2023-010559. Part of this work was carried out at the Jet Propulsion Laboratory/California Institute of Technology, United States under a NASA-STMD grant, and under a contract with the National Aeronautics and Space Administration, United States (80NM0018D0004)., Peer reviewed
UPCommons. Portal del coneixement obert de la UPC
Publicación Artículo científico (JournalArticle)

Extension of the frequency range of thermal impedance measurements for the characterization of the thermophysical properties of regolith

  • Rosero Pozo, Carlos Alberto|||0000-0003-3660-727X
  • Pons Nin, Joan|||0000-0002-0356-5678
  • Kumar, Suresh|||0000-0002-8079-0107
  • Jiménez Serres, Vicente|||0000-0001-5668-7049
  • Bermejo Broto, Sandra|||0000-0003-1660-0273
  • Domínguez Pumar, Manuel|||0000-0001-5439-7953
An effective approach for the extension of the frequency range of a miniaturized thermoprobe for the measurement of the thermophysical properties of regolith is proposed. The thermoprobe inserted into the regolith measures its thermal impedance in the frequency domain to infer the thermal conductivity and thermal diffusivity. The frequency extension is based on improved modeling of the heat transfer inside the sensor head and through the supporting structure of the thermoprobe. A Finite Element Method tool has been used to model this transfer function. The thermophysical properties of nine different samples including glass microbeads and the Enhanced Mojave Mars Simulant have been estimated. The results are compared with the reference values measured by a dual-probe heat-pulse standard analyzer at room atmospheric conditions. Errors below 8% for thermal conductivity and below 7% for thermal diffusivity have been observed. The proposed approach represents a very important reliability improvement, since it allows decreasing the minimum measurement frequency by a factor of 10, allowing to capture the most representative part of the thermal impedance spectra, and thus making a far more robust measurement., This work has been partially funded by MICINN, grants no. PID2021-126719OB-C42, CPP2021-008740, PDC2023-145889-C22, TED2021-131442B-C32 and CPP2023-010559., Peer Reviewed
UPCommons. Portal del coneixement obert de la UPC
Publicación Artículo científico (JournalArticle)

Noise-induced tracking errors in discrete-time sliding mode controls for sensors

  • Domínguez Pumar, Manuel|||0000-0001-5439-7953
The objective of this paper is to analyze, using Itô diffusions, the stochastic non-zero-mean drifts generated by noise at the input of the comparator in first-order sigma-delta modulators implementing discrete-time sliding-mode controls. These controls have been used in constant temperature anemometry in three missions to Mars. The objective is to expand previous results obtained with discrete-time Markov chains, by using the high-rate (continuous-time) diffusion limit with Itô diffusions. The studied examples are time-variant thermal models used for the wind sensors. The distributions will be analyzed using the gradient flow interpretation, and by solving the Fokker-Planck equations. Second order stability is analyzed using the dead zone Lyapunov function analysis, for one-dimensional and multi-dimensional models. Guidelines for the design of sensors working under quasi-constant state operation are provided., This work has been partially funded by MICINN, grants no. PID2021-126719OB-C42 and PID2024-161247OB-C32, by the Spain Ministry of Science, Innovation/State Agency of Research MCIN/AEI/ 10.13039/501100011033, by “ERDF A way of making Europe” and CPP2021-008740, PDC2023-145889-C22 and CPP2023-010559., Peer Reviewed
Recercat. Dipósit de la Recerca de Catalunya
Publicación Artículo científico (JournalArticle)

Extension of the frequency range of thermal impedance measurements for the characterization of the thermophysical properties of regolith

  • Rosero Pozo, Carlos Alberto
  • Pons Nin, Joan
  • Kumar, Suresh
  • Jiménez Serres, Vicente
  • Bermejo Broto, Sandra
  • Domínguez Pumar, Manuel
An effective approach for the extension of the frequency range of a miniaturized thermoprobe for the measurement of the thermophysical properties of regolith is proposed. The thermoprobe inserted into the regolith measures its thermal impedance in the frequency domain to infer the thermal conductivity and thermal diffusivity. The frequency extension is based on improved modeling of the heat transfer inside the sensor head and through the supporting structure of the thermoprobe. A Finite Element Method tool has been used to model this transfer function. The thermophysical properties of nine different samples including glass microbeads and the Enhanced Mojave Mars Simulant have been estimated. The results are compared with the reference values measured by a dual-probe heat-pulse standard analyzer at room atmospheric conditions. Errors below 8% for thermal conductivity and below 7% for thermal diffusivity have been observed. The proposed approach represents a very important reliability improvement, since it allows decreasing the minimum measurement frequency by a factor of 10, allowing to capture the most representative part of the thermal impedance spectra, and thus making a far more robust measurement., This work has been partially funded by MICINN, grants no. PID2021-126719OB-C42, CPP2021-008740, PDC2023-145889-C22, TED2021-131442B-C32 and CPP2023-010559., Peer Reviewed, Postprint (published version)
Recercat. Dipósit de la Recerca de Catalunya
Publicación Artículo científico (JournalArticle)

Noise-induced tracking errors in discrete-time sliding mode controls for sensors

  • Domínguez Pumar, Manuel
The objective of this paper is to analyze, using Itô diffusions, the stochastic non-zero-mean drifts generated by noise at the input of the comparator in first-order sigma-delta modulators implementing discrete-time sliding-mode controls. These controls have been used in constant temperature anemometry in three missions to Mars. The objective is to expand previous results obtained with discrete-time Markov chains, by using the high-rate (continuous-time) diffusion limit with Itô diffusions. The studied examples are time-variant thermal models used for the wind sensors. The distributions will be analyzed using the gradient flow interpretation, and by solving the Fokker-Planck equations. Second order stability is analyzed using the dead zone Lyapunov function analysis, for one-dimensional and multi-dimensional models. Guidelines for the design of sensors working under quasi-constant state operation are provided., This work has been partially funded by MICINN, grants no. PID2021-126719OB-C42 and PID2024-161247OB-C32, by the Spain Ministry of Science, Innovation/State Agency of Research MCIN/AEI/ 10.13039/501100011033, by “ERDF A way of making Europe” and CPP2021-008740, PDC2023-145889-C22 and CPP2023-010559., Peer Reviewed, Postprint (published version)