Pasar al contenido principal

INVESTIGACION EN LA PROXIMA GENERACION DE BOMBAS DE CALOR AEROTERMICAS PARA EDIFICIOS INTEGRADAS EN LOS SISTEMAS DE CALEFACCION/REFRIGERACION Y AGUA CALIENTE SANITARIA.

PID2023-148964OB-I00

•
Nombre agencia financiadora Agencia Estatal de Investigación
Acrónimo agencia financiadora AEI
Programa Programa Estatal para Impulsar la Investigación Científico-Técnica y su Transferencia
Subprograma Subprograma Estatal de Generación de Conocimiento
Convocatoria Proyectos de I+D+i (Generación de Conocimiento y Retos Investigación)
Año convocatoria 2023
Plan Estatal 2021-2023 Plan Estatal de Investigación Científica y Técnica y de Innovación
Centro beneficiario UNIVERSITAT POLITÈCNICA DE VALÈNCIA

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Experimental investigation of ambient temperature effects on performance and refrigerant charge in a variable-speed, direct-suction R290 scroll compressor for heat pump applications

  • Gómez-Parada, Nicolás
  • Barceló Ruescas, Francisco|||0000-0002-0577-2662
  • Gonzálvez-Maciá, José|||0000-0001-9422-7756
[EN] Scroll compressors with direct suction are commonly used in commercial heat pumps; however, the evaluation of refrigerant inventory and the factors governing refrigerant retention within the compressor remain limited, particularly when operating with propane (R290). This aspect is particularly important in low-charge system designs due to the flammability of hydrocarbon refrigerants. This work experimentally characterizes a variable-speed direct-suction scroll compressor over a wide range of evaporation and condensation conditions, rotational speeds, and ambient temperatures with and without a thermal-acoustic insulation jacket. Results show that ambient temperature has a negligible influence on mass flow rate and power consumption at fixed suction and discharge pressures, but significantly affects discharge and oil-sump temperatures, especially at low speed and high-pressure ratio. A compact compressor model is calibrated for mass flow rate and power, and extended with a lumped heat-loss correction term to capture variations in discharge temperature under ambient exposure. The oil-sump temperature is then correlated with the modeled discharge temperature, yielding low errors (RMSE of 1.8 °C for insulated tests and 1.3 °C for non-insulated tests). Combining the oil-temperature correlation with published R290/PAG solubility curves enables estimation of the refrigerant mass dissolved in the oil, revealing differences up to 67.5 g at the same operating point. Finally, simulations for an air-to-water heat pump show that thermal insulation can shift operating limits in domestic hot-water mode by up to 4 K under a discharge-temperature constraint. The dataset and modeling approach support compressor thermal management and charge optimization for low-charge heat pumps using flammable refrigerants., We gratefully acknowledge the financial support provided by the project "Investigacion en la proxima generacion de bombas de calor aerotermicas para edificios integradas en los sistemas de calefaccion/ refrigeracion y agua caliente sanitaria", funded by Agencia Estatal de Investigacion de Espana , with code number: PID2023-148964OB-I00. The work of Nicolas Gomez Parada in this project has been partially supported by Generalitat Valenciana, under the program Santiago Grisolía with reference GRISOLIAP/2021/084. Funding for open access charge: Universitat Politecnica de Valencia.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Experimental study about frost formation and growth in the evaporator of an air-to-water heat pump

  • Alarcón-Gallén, David|||0000-0003-3338-2888
  • Marchante-Avellaneda, Javier|||0000-0001-5680-5033
  • Hassan, Abdelrahman|||0000-0001-9063-9569
  • Navarro-Peris, Emilio|||0000-0002-0608-2129
[EN] Frost formation in the evaporator of air-to-water heat pumps (AWHPs) is one of the most crucial aspects that affect the efficiency of these systems. This paper analyzes the frost formation and growth in a finned-tube evaporator to monitor the degradation of a commercial heat pump's performance. The analysis includes the characterization of the various frost formation processes that may occur in real operating conditions, as well as a detailed examination of the water vapor sublimation process as a function of evaporation temperature and relative humidity. The results are presented in terms of the air-side pressure drop, evaporation temperature evolution, and the amount of condensed water recovered. From these results, key factors in the evolution of this process, like the frost structure, are critical in the system performance degradation, and parameters like air-side pressure drop are not enough to determine the optimum time for initiating the defrost process., This work has been funded by the project " Investigacion en la proxima generacion de bombas de calor aerotermicas para edificios integradas en los sistemas de calefaccion/refrigeracion y agua caliente sanitaria ", Ref. PID2023-148964OB-I00, by the Spanish Ministry of Science, Innovation and Universities. The authors are grateful for the support given.Marchante-Avellaneda J. would like to acknowledge the Universitat Politecnica de Valencia (UPV) for the grants for contracts for research personnel access (Ref. PAID-10-23) ; and initial research projects (Ref. PAID-06-24) .