Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publicación
Artículo científico (JournalArticle)
Multi-parameter and multi-objective optimisation of thermoelectric modules for enhanced performance in geothermal passive generators
Geometrical optimisation studies of thermoelectric modules often overlook the significant influence of system-level components, particularly heat exchangers. This research addresses this critical gap by developing an integrated system-level optimisation approach, applied to a geothermal passive thermoelectric generator installed in Antarctica. The methodology is based on the premise that the thermal and electrical phenomena are interdependent, demanding a holistic design. For the first time, a comprehensive multi-objective, multi-parameter computational model for geometric optimisation of modules is presented, which incorporates all thermoelectric effects, temperature-dependent properties, and all system components. The framework simultaneously maximises electrical power output and minimises semiconductor material volume by adjusting the thermocouple length and cross-sectional area to their optimal values. Application to the Antarctic installation demonstrated that geometric optimisation yields energy production improvements from 3.7% to 12.6% with respect to the commercial modules used in the installation. These improvements correspond to configurations with leg lengths of 0.11 cm and 0.27 cm and cross-sectional areas of 0.023 cm2 and 0.06 cm2, respectively. Crucially, an extended analysis revealed that while the source temperature difference does not affect optimal geometric parameters, the thermal resistances are paramount. Reducing the sum of heat exchanger thermal resistances by 26% increases optimisation potential by 60%, while also reducing semiconductor volume by 18.5%. These results demonstrate a system-level optimisation approach is essential. Findings indicate efforts must first prioritise optimising heat exchangers for the lowest thermal resistance. Subsequently, the optimal module geometry is determined by maximising the thermocouple cross-sectional area before adjusting the length for optimal thermal matching., The authors would like to acknowledge the support of the Spanish State Research Agency and FEDER-UE under the grants PID2024-162043OB-I00 and PRE2022-103787. The authors would also like to acknowledge the Thermoelectric and Electrochemical Systems and Technology Group at the Jet Propulsion Laboratory, supervised by Dr. Thierry Caillat, for their insightful comments and valuable discussions. Open access funding provided by the Public University of Navarre.