Pasar al contenido principal

ESTUDIO EXPERIMENTAL DE LA APLICACION DE LA TECNOLOGIA DE MEMBRANAS PARA POTENCIAR LA RECUPERACION DE RECURSOS EN LAS EDAR ACTUALES.

PRE2018-083726

•
Nombre agencia financiadora Agencia Estatal de Investigación
Acrónimo agencia financiadora AEI
Programa Programa Estatal de Promoción del Talento y su Empleabilidad en I+D+i
Subprograma Subprograma Estatal de Formación
Convocatoria Contratos Predoctorales
Año convocatoria 2018
Plan Estatal 2017-2020 Plan Estatal de Investigación Científica y Técnica y de Innovación
Centro beneficiario UNIVERSITAT DE VALÈNCIA

Resultados relacionados

Resultados totales (Incluyendo duplicados): 4
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Evaluating the Feasibility of Employing Dynamic Membranes for the Direct Filtration of Municipal Wastewater

  • Sanchis-Perucho, Pau
  • Aguado García, Daniel|||0000-0002-6417-366X
  • FERRER, J.
  • Seco, Aurora
  • Robles, Ángel
[EN] The aim of this study was to assess the feasibility of using dynamic membranes for direct filtration of municipal wastewater. The influence of different alternative supporting materials (one or two layers of flat open monofilament woven polyamide meshes with 1 or 5 mu m of pore size) was studied. A stable short-term self-forming DM was achieved (from some hours to 3 days) regardless of the supporting material used, producing relatively similar permeate qualities (total suspended solids, chemical oxygen demand, total nitrogen, total phosphorous and turbidity of 67-88 mg L-1, 155-186 mg L-1, 48.7-50.4 mg L-1, 4.7-4.9 mg L-1, and 167-174 NTU, respectively). A DM permeability loss rate of from 5.21 to 10.03 LMH bar(-1) day(-1) was obtained, which depended on the supporting material used. Unfortunately, the preliminary energy, carbon footprint, and economic evaluations performed showed that although DMs obtain higher pollutant captures than conventional treatments (primary settler), the benefits are not enough to justify their use for treating average municipal wastewater. However, this alternative scheme could be suitable for treating higher-loaded MWW with a higher fraction of organic matter in the non-settleable solids., This research work was supported by the Ministerio de Economia, Industria y Competitividad via the fellowship PRE2018-083726. This research work was also possible thanks to the financial aid received from the Ministerio de Economia, Industria y Competitividad during the implementation of the Project "AplicaciOn de la tecnologia de membranas para potenciar la transformaciOn de las EDAR actuales en estaciones de recuperaciOn de recursos." (CTM2017-86751-C1 and CTM2017-86751-C2).
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Building a simple multivariable filtration model to predict irreversible fouling when directly filtering municipal wastewater

  • Sanchis-Perucho, Pau
  • Aguado García, Daniel|||0000-0002-6417-366X
  • Harmand, Jerome
  • Feddaoui-papin, Aida
  • Robles Martínez, Ángel
[EN] This paper describes a simple generic model designed to predict membrane fouling in municipal wastewater (MWW) treatment. The work was conducted using data from a direct membrane filtration demo-system (middle/ long-term filtration periods of about 35 - 124 days) to calibrate the model. Two influents were treated by the demo-system: raw pre-treated MWW and primary settler supernatant from a full-scale MWW treatment plant. A resistance-in-series mathematical model structure was proposed considering fouling due to two different mechanisms: persistent cake layer formation (from suspended material) and pore blocking (from soluble and colloidal compounds). The proposed model represented transmembrane pressure dynamics at different operating solids concentrations (around 1, 2.6, 6 and 11 gL-1) using 7 model parameters, achieving 7-28 mbar differences between the experimental data and model predictions in all cases (calculated as the root mean square error). The model was also able to match the results from two different influents (raw MWW and primary settler supernatant) by modifying 3 of the 7 parameters while low uncertainties were obtained in long-term filtrations, demonstrating its robustness. This model thus provides a good potential to generate reasonable membrane fouling predictions while its simple and open structure makes it easy to implement with complementary materials. Further research will be carried out to enhance the model's precision and validate its potential for optimizing filtration and fouling control processes., This research work was supported by the Ministerio de Economia, Industria y Competitividad via Grant N degrees PRE2018-083726. It was also made possible thanks to the financial support received from the above Ministry during the implementation of the Project " Aplicacion de la tecnologia de membranas para potenciar la transformacion de las EDAR actuales en estaciones de recuperacion de recursos ." (CTM2017-86751-C1 and CTM2017-86751-C2) .
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Dynamic Membranes for Enhancing Resources Recovery from Municipal Wastewater

  • Sanchis-Perucho, Pau
  • Aguado García, Daniel|||0000-0002-6417-366X
  • FERRER, J.
  • Seco, Aurora
  • Robles, Ángel
[EN] This paper studied the feasibility of using dynamic membranes (DMs) to treat municipal wastewater (MWW). Effluent from the primary settler of a full-scale wastewater treatment plant was treated using a flat 1 mu m pore size open monofilament polyamide woven mesh as supporting material. Two supporting material layers were required to self-form a DM in the short-term (17 days of operation). Different strategies (increasing the filtration flux, increasing the concentration of operating solids and coagulant dosing) were used to enhance the required forming time and pollutant capture efficiency. Higher permeate flux and increased solids were shown to be ineffective while coagulant dosing showed improvements in both the required DM forming time and permeate quality. When coagulant was dosed (10 mg L-1) a DM forming time of 7 days and a permeate quality of total suspended solids, chemical oxygen demand, total nitrogen, total phosphorous and turbidity of 24 mg L-1, 58 mg L-1, 38.1 mg L-1, 1.2 mg L-1 and 22 NTU, respectively, was achieved. Preliminary energy and economic balances determined that energy recoveries from 0.032 to 0.121 kWh per m(3) of treated water at a cost between euro0.002 to euro0.003 per m(3) of treated water can be obtained from the particulate material recovered in the DM., This research work was supported by Ministerio de Economia, Industria y Competitividad via the fellowship PRE2018-083726. This research work was also possible thanks to the financial received from Ministerio de Economia, Industria y Competitividad during the implementation of the Project ¿Aplicación de la tecnología de membranas para potenciar la transformación de las EDAR actuales en estaciones de recuperación de recursos.¿ (CTM2017-86751-C1 and CTM2017-86751-C2).
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Direct Membrane Filtration of MunicipalWastewater: Studying the Most Suitable Conditions for Minimizing Fouling Rate in Commercial Porous Membranes at Demonstration Scale

  • Sanchis-Perucho, Pau
  • Aguado García, Daniel|||0000-0002-6417-366X
  • FERRER, J.
  • Seco, Aurora
  • Robles, Ángel
[EN] This study aimed to evaluate the feasibility of applying a commercial porous membrane to direct filtration of municipal wastewater. The effects of membrane pore size (MF and UF), treated influent (raw wastewater and the primary settler effluent of a municipal wastewater treatment plant) and operating solids concentration (about 1 and 2.6 g L-1) were evaluated on a demonstration plant. Filtration periods of 2-8 h were achieved when using the MF membrane, while these increased to 34-69 days with the UF membrane. This wide difference was due to severe fouling when operating the MF membrane, which was dramatically reduced by the UF membrane. Use of raw wastewater and higher solids concentration showed a significant benefit in the filtration performance when using the UF module. The physical fouling control strategies tested (air sparging and backwashing) proved to be ineffective in controlling UF membrane fouling, although these strategies had a significant impact on MF membrane fouling, extending the operating period from some hours to 5-6 days. The fouling evaluation showed that a cake layer seemed to be the predominant reversible fouling mechanism during each independent filtration cycle. However, as continuous filtration advanced, a large accumulation of irreversible fouling appeared, which could have been related to intermediate/complete pore blocking in the case of the MF membrane, while it could have been produced by standard pore blocking in the case of the UF membrane. Organic matter represented more than 70% of this irreversible fouling in all the experimental conditions evaluated., This research work was supported by the Spanish Ministerio de Economia, Industria y Competitividad via Fellowship PRE2018-083726 and was also possible thanks to the funding received from Ministerio de Economia, Industria y Competitividad during the implementation of the Project "Aplicacion de la tecnologia de membranas para potenciar la transformacion de las EDAR actuales en estaciones de recuperacion de recursos." (CTM2017-86751-C1 and CTM2017-86751-C2).