Pasar al contenido principal

DES.NUEVA FAMILIA VITROCERAMICOS

PTQ-14-07289

•
Nombre agencia financiadora Ministerio de Ciencia e Innovación
Acrónimo agencia financiadora MICINN
Programa Programa Estatal de Promoción del Talento y su Empleabilidad en I+D+i
Subprograma Subprograma Estatal de Incorporación
Convocatoria Torres Quevedo
Año convocatoria 2014
Plan Estatal 2013-2016 Plan Estatal de Investigación Científica y Técnica y de Innovación
Unidad de gestión Subdirección General de Recursos Humanos para la Investigación
Centro beneficiario CENTRO TECNOLOGICO VIDRES, S.L.
Identificador persistente http://dx.doi.org/10.13039/501100004837

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

e-Archivo. Repositorio Institucional de la Universidad Carlos III de Madrid
Publicación Artículo científico (JournalArticle)

Improvement of thermal efficiency in cement mortars by using synthetic feldspars

  • Torres Carrasco, Manuel
  • Enríquez, E.
  • Terrón-Menoyo, L.
  • Cabrera, M.J.
  • Muñoz, D.
  • Fernández, J.F.
The use of white cements as a building material is widely employed due to its high whiteness and reflectance. However, building materials should adopt better thermal insulation characteristics to contribute for a significant urban heat-islands mitigation. In this work, synthetic feldspar has been evaluated as partial and total replacement of sand in white cement mortars. Thermal, mechanical, and optical properties of these new mortars are characterized by thermal conductivity, compression resistance test and reflectance-colorimetry, respectively. The replacement of sand by synthetic feldspar allows to obtain white mortars having [almost equal to]18% improvement in solar reflectance. Experiment under solar irradiance of mortars having synthetic feldspars reduce the surface heating of the mortar in 25% and the heating transmission to the rear of the mortar in >55%. Moreover, the high crystallinity of the synthetic feldspar reduces the mortar expansion due alkali-silica reactions (ASR). Improvement in reflectance and thermal conductivity resistance of white cement mortar having synthetic feldspar opens a wide range of building material applications., The authors express their thanks to the Project MAT-2017-86450-C4-1-R, CSIC NANOMIND project CSIC2015-60E068 and projects CDTI (IDI-20130894 and IDI-20161120) for their financial support. Dra. E. Enríquez is indebted to MINECO for a "Torres Quevedo" contract (ref: PTQ-14-07289), which is co-financed with European Social Funds. Dr. M. Torres-Carrasco is also indebted to MINECO for a postdoctoral fellowship "Juan de la Cierva-Formación" (ref: FJCI-2016-28488).
e-Archivo. Repositorio Institucional de la Universidad Carlos III de Madrid
Publicación Artículo científico (JournalArticle)

Towards more sustainable building based on modified Portland cements through partial substitution by engineered feldspars

  • Enríquez, E.
  • Torres Carrasco, Manuel
  • Cabrera, M.J.
  • Muñoz, D.
  • Fernández, J.F.
Global warming is one of the main problems that facing modern civilization. As buildings consume 40% of total energy, the heating in the cities is a primary concern. Therefore, it seeks to improve sustainable construction materials with better thermal and reflective properties, reducing consumption and heat islands. In this work, mineral and engineered feldspars have been used as partial substitution of white cement, that is widely used in the cladding of façades mainly due to its high whiteness, to improve composites' reflectance and reducing their thermal conductivity. Both feldspars show pozzolanic effect and new composites have superior whiteness and reflectance (greater than12%). Moreover, the engineered feldspar avoids the alkali-silica reaction (ASR) effect in spite of its alkaline content. A reduction of heat of greater than 2 °C after 6 h of solar irradiance is demonstrated for engineered feldspar composite resulting in a good alternative for their implementation as exterior insulation and finish systems., The authors express their thanks to the Project MAT-2017-86450-C4-1-R, CSIC NANOMIND project CSIC2015-60E068 and projects CDTI (IDI-20130894 and IDI-20161120) for their financial support. Dra. E. Enriquez is also indebted to MINECO for a "Torres Quevedo" contract (ref: PTQ-14-07289), which is co-financed with European Social Funds.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Contribución de congreso (ConferenceOutput)

Nanostructured Au(111)/Oxide Epitaxial Heterostructures with Tailoring Plasmonic Response by a One-Step Strategy

  • Serrano Rubio, Aída
  • Rubio-Zuazo, J.
  • López-Sánchez, Jesús
  • Enríquez Pérez, Esther
  • Salas, Eduardo
  • Castro, Germán R.
[EN]In this work, we present a strategy for developing epitaxial incommensurate nanostructured Au/oxide heterostructures with tunable plasmonic response. Previously, high-quality single-phase and single-oriented α-FeO(0001) thin films were achieved, which have been used as a template for noble-metal epitaxial deposition. The complex systems have been grown by pulsed laser deposition on two different types of oxide substrates: α-AlO(0001) and SrTiO(111). A one-step procedure has been achieved tailoring the isolated character and the morphological features of Au nanostructures through the substrate temperature during Au growth, without altering the structural characteristics of the hematite layer that is identified as a single iron oxide phase. The epitaxial character and the lattice coupling of Au/oxide bilayers are mediated through the sort of oxide substrate. Single-oriented Au(111) islands are disposed with a rotation of 30° between their crystallographic axes and those of α-FeO(0001). The Au(111) and SrTiO(111) lattices are collinear, while a rotation of 30° happens with respect to the α-AlO(0001) lattice. The crystallographic domain size and crystalline order of the hematite structure and the Au nanostructured layer are dependent on the substrate type and the Au growth temperature, respectively. Besides, the functional character of the complex systems has been tested. The localized surface plasmons related to Au nanostructures are excited and controlled through the fabrication parameters, tuning the optical resonance with the degree of Au nanostructuring., This work was supported by the Ministerio Español de Ciencia, Innovación y Universidades (MCIU), and the Consejo Superior de Investigaciones Cientificas (CSIC) through the project PIE-2010 6 OE 013. J.L.-S. and E.E. acknowledge the FPI fellowship and the Torres Quevedo contract (ref: PTQ-14-07289). The ESRF, MCIU, and CSIC are acknowledged for the provision of synchrotron radiation facilities. The authors thank Dr M.A. García for the useful discussion about the plasmonic results and Carlos Beltrán for technical support during the experiments at the BM25 beamline at The ESRF.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Absence of surface flaking in hierarchical glass-ceramic coating: High impact resistant ceramic tiles

  • Enríquez Pérez, Esther
  • Fuertes de la Llave, Víctor
  • Cabrera Ibáñez, María José
  • Seores Goterris, Jaime
  • Muñoz, D.
  • Fernández Lozano, José Francisco
[EN] The impact resistance method is a useful procedure to determine the tile resistance. While other works are focused on modifying the tile support to improve the impact resistance, in this work, a new glass-ceramic material was developed to used it as glaze coating in order to relax impact tensions. This material possesses a hierarchical nano-microstructure consisted of microcrystal surrounded by nanostructured regions having low glassy phase, which is considered responsible for tension relaxations. The resilience coefficient measured in conventional and glass-ceramic glazes presents little differences (0.85–0.88). However, impact damages on the surface is totally inhibited for glass-ceramic coating while the conventional one suffers great flaking. These damages were analyzed by Optical profilometry and FESEM to compare the impact resistance and to correlate it with its microstructure. The results confirm that the micro-nanostructured coating paves the way to improve impact resistance in ceramic materials where surface damage is a critical parameter., MINECO (Spain) project MAT2017-86450-C4-1-R, and project CDTI of CTV for theirfinancial support. Dra. E. Enriquez is also indebted to MINECO (Spain) for a“Torres Quevedo’’contract (ref: PTQ-14-07289), which is co-financedwith European Social Funds
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Towards more sustainable building based on modified Portland cements through partial substitution by engineered feldspars

  • Enríquez Pérez, Esther
  • Torres-Carrasco, M.
  • Cabrera Ibáñez, María José
  • Muñoz, D.
  • Fernández Lozano, José Francisco
[EN] Global warming is one of the main problems that facing modern civilization. As buildings consume 40% of total energy, the heating in the cities is a primary concern. Therefore, it seeks to improve sustainable construction materials with better thermal and reflective properties, reducing consumption and heat islands. In this work, mineral and engineered feldspars have been used as partial substitution of white cement, that is widely used in the cladding of façades mainly due to its high whiteness, to improve composites’ reflectance and reducing their thermal conductivity. Both feldspars show pozzolanic effect and new composites have superior whiteness and reflectance (greater than12%). Moreover, the engineered feldspar avoids the alkali-silica reaction (ASR) effect in spite of its alkaline content. A reduction of heat of greater than 2 °C after 6 h of solar irradiance is demonstrated for engineered feldspar composite resulting in a good alternative for their implementation as exterior insulation and finish systems., MAT-2017-86450-C4-1-R, CSIC NANOMIND project CSIC2015-60E068 andprojects CDTI (IDI-20130894 and IDI-20161120) for their financialsupport. Dra. E. Enriquez is also indebted to MINECO for a ‘‘Torres Quevedo’’ contract (ref: PTQ-14-07289), which is co-financed with European Social Funds
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Improvement of thermal efficiency in cement mortars by using synthetic feldspars

  • Torres-Carrasco, M.
  • Enríquez Pérez, Esther
  • Terrón-Menoyo, L.
  • Cabrera Ibáñez, María José
  • Muñoz, D.
  • Fernández Lozano, José Francisco
[EN] The use of white cements as a building material is widely employed due to its high whiteness and reflectance. However, building materials should adopt better thermal insulation characteristics to contribute for a significant urban heat-islands mitigation. In this work, synthetic feldspar has been evaluated as partial and total replacement of sand in white cement mortars. Thermal, mechanical, and optical properties of these new mortars are characterized by thermal conductivity, compression resistance test and reflectance-colorimetry, respectively. The replacement of sand by synthetic feldspar allows to obtain white mortars having ≈18% improvement in solar reflectance. Experiment under solar irradiance of mortars having synthetic feldspars reduce the surface heating of the mortar in 25% and the heating transmission to the rear of the mortar in >55%. Moreover, the high crystallinity of the synthetic feldspar reduces the mortar expansion due alkali-silica reactions (ASR). Improvement in reflectance and thermal conductivity resistance of white cement mortar having synthetic feldspar opens a wide range of building material applications., Project MAT-2017-86450-C4-1-R, CSIC NANOMIND project CSIC2015-60E068 andprojects CDTI (IDI-20130894 and IDI-20161120) for their financialsupport. Dra. E. Enríquez is indebted to MINECO for a ‘‘Torres Quevedo’’ contract (ref: PTQ-14-07289), which is co-financed withEuropean Social Funds. Dr. M. Torres-Carrasco is also indebted toMINECO for a postdoctoral fellowship ‘‘Juan de la Cierva-Formación” (ref: FJCI-2016-28488).