Pasar al contenido principal

Halide perovskites for energy devices

RYC2021-034941-I

•
Nombre agencia financiadora Agencia Estatal de Investigación
Acrónimo agencia financiadora AEI
Programa Programa Estatal para Desarrollar, Atraer y Retener Talento
Subprograma Subprograma Estatal de Incorporación
Convocatoria Ramón y Cajal
Año convocatoria 2021
Plan Estatal 2021-2023 Plan Estatal de Investigación Científica y Técnica y de Innovación
Centro beneficiario UNIVERSIDAD DE SEVILLA

Resultados relacionados

Resultados totales (Incluyendo duplicados): 4
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Surfactant-Dependent Bulk Scale Mechanochemical Synthesis of CsPbBr3 Nanocrystals for Plastic Scintillator-Based X-ray Imaging

  • Ghosh, Joydip
  • O'Neill, Joseph
  • Masteghin, Mateus G
  • Braddock, Isabel
  • Crean, Carol
  • Dorey, Robert
  • Salway, Hayden
  • Anaya, Miguel
  • Reiss, Justin
  • Wolfe, Douglas
  • Sellin, Paul
We report a facile, solvent-free surfactant-dependent mechanochemical synthesis of highly luminescent CsPbBr3 nanocrystals (NCs) and study their scintillation properties. A small amount of surfactant oleylamine (OAM) plays an important role in the two-step ball milling method to control the size and emission properties of the NCs. The solid-state synthesized perovskite NCs exhibit a high photoluminescence quantum yield (PLQY) of up to 88% with excellent stability. CsPbBr3 NCs capped with different amounts of surfactant were dispersed in toluene and mixed with polymethyl methacrylate (PMMA) polymer and cast into scintillator discs. With increasing concentration of OAM during synthesis, the PL yield of CsPbBr3/PMMA nanocomposite was increased, which is attributed to reduced NC aggregation and PL quenching. We also varied the perovskite loading concentration in the nanocomposite and studied the resulting emission properties. The most intense PL emission was observed from the 2% perovskite-loaded disc, while the 10% loaded disc exhibited the highest radioluminescence (RL) emission from 50 kV X-rays. The strong RL yield may be attributed to the deep penetration of X-rays into the composite, combined with the large interaction cross-section of the X-rays with the high-Z atoms within the NCs. The nanocomposite disc shows an intense RL emission peak centered at 536 nm and a fast RL decay time of 29.4 ns. Further, we have demonstrated the X-ray imaging performance of a 10% CsPbBr3 NC-loaded nanocomposite disc., We acknowledge the financial support from Defense Threat Reduction Agency (DTRA) under the Basic Research contract HDTRA1-18-1-0019. Part of this work was supported by the United Kingdom Engineering and Physical Research Council (Grant number EP/V036327/1). H.S. thanks the U.K. Engineering and Physical Sciences Research Council (EPSRC) grant EP/S023046/1 for the EPSRC Centre for Doctoral Training in Sensor Technologies for a Healthy and Sustainable Future. M.A. acknowledges support by the Royal Academy of Engineering under the Research Fellowship programme and by the Spanish Ministry of Science and Innovation through a Ramon y Cajal Fellowship (RYC2021-034941-I).We would like to thank John-William Brown, Sarah Heisig, Michelle Williams, and David Jones for their technical support., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Synergetic Near- and Far-Field Plasmonic Effects for Optimal All-Perovskite Tandem Solar Cells with Maximized Infrared Absorption

  • Bueno, Jaime
  • Carretero-Palacios, Sol
  • Anaya, Miguel
The efficiency and reliability of perovskite solar cells have rapidly increased in conjunction with the proposition of advanced single-junction and multi-junction designs that allow light harvesting to be maximized. However, Sn-based compositions required for optimized all-perovskite tandem devices have reduced absorption coefficients, as opposed to pure Pb perovskites. To overcome this, we investigate near- and far-field plasmonic effects to locally enhance the light absorption of infrared photons. Through optimization of the metal type, particle size, and volume concentration, we maximize effective light harvesting while minimizing parasitic absorption in all-perovskite tandem devices. Interestingly, incorporating 240 nm silver particles into the Pb-Sn perovskite layer with a volume concentration of 3.1% indicates an absolute power conversion efficiency enhancement of 2% in the tandem system. We present a promising avenue for experimentalists to realize ultrathin all-perovskite tandem devices with optimized charge carrier collection, diminishing the weight and the use of Pb. © 2024 The Authors. Published by American Chemical Society., support by the Spanish Ministry of Science and Innovation through a Ramón y Cajal Fellowship (RYC2021-034941-I). J.B. acknowledges support by the Programa Investigo funded by the European Union “NextGenerationEU”/ PRTR. The authors also acknowledge financial support of the Spanish Ministry of Science and Innovation under Grants TED2021-131001A-I00, CNS2022-135967, and PID2022-142525OA-I00 funded by MCIN/AEI/10.13039/ 501100011033 and by the European Union “NextGenerationEU”/ PRTR, and Grant RED2022-134939-T., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Interfacial Chemistry Limits the Stability of Deep Blue Perovskite LEDs Revealed by Operando Characterization

  • Mirabelli, Alessandro James
  • Kammlander, Birgit
  • Lu, Yang
  • Varma, Rahul Mahavir
  • Gu, Qichun
  • Radetzky, Karen
  • Selby, Thomas A
  • Liu, Tianjun
  • Riva, Stefania
  • Wei, Zimu
  • Lee, Tien-Lin
  • Rawle, Jonathan
  • Rensmo, Håkan
  • Anaya, Miguel
  • Cappel, Ute B
  • Stranks, Samuel D
To commercialize lead halide perovskites as light-emitting diodes (LEDs), the operational device lifetime needs to be drastically improved. For this to be achieved, an understanding of degradation behavior under bias is crucial. Herein, we perform operando measurements of the structural, chemical, and electronic changes using synchrotron-based grazing-incidence wide-angle X-ray scattering and hard X-ray photoelectron spectroscopy on full-stack deep blue mixed bromide/chloride lead halide perovskite LEDs. While a clear drop in optoelectronic performance is recorded under electrical bias, the accompanying X-ray scattering data reveals only minor changes in structural properties. However, photoelectron spectroscopy reveals substantial chemical changes at the electron-injecting interface after bias is applied, including the formation of unwanted metallic lead and a new chlorine species that is not in the perovskite structure. These operando approaches give important structural and interfacial perspectives to reveal the degradation mechanisms in these LEDs and highlight the need to address the top electron-injecting interface to realize step-changes in operational stability., A.J.M. acknowledges funding from the D.M.P. VFdS74 foundation. We thank the Swedish Research Council (Grant Nos. VR 2018-06465, VR 2023-05072, and VR 2022-03168) and the Göran Gustafsson foundation for funding. This work was partially supported by the Wallenberg Initiative Materials Science for Sustainability (WISE), funded by the Knut and Alice Wallenberg Foundation. We further thank the Swedish Energy Agency (P50626-1). The authors acknowledge the European Research Council (ERC) under the European Union’s Horizon 2020 research and innovation program (HYPERION, grant agreement No. 756962). M.A. acknowledges support from the Royal Academy of Engineering under the Research Fellowship programme, and from MICIU/AEI/10.13039/501100011033 and the European Union NextGenerationEU/PRTR through grants RYC2021-034941-I and PID2022-142525OA-I00. The authors acknowledge the Engineering and Physical Sciences Research Council (EPSRC) (grant agreement nos. EP/R023980/1, EP/V06164X/1). T.A.S. acknowledges support by the EPSRC Cambridge NanoDTC, EP/L015978/1. S.D.S. acknowledges the Royal Society and Tata Group (UF150033). The authors thank Diamond Light Source UK for the beamtime allocated both at I07 and at I09 to conduct these experiments (Proposal numbers SI30043-1, SI32266-1, SI32266-3, SI30838-1, SI33096-1, SI33096-2) and thank Dr. Deepnarayan Biswas for the kind help offered during the beamtimes at I09. The authors also thank the staff from the Cavendish Laboratory workshops for their help in realizing the sample stages used in this work., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

High-performance red light-emitting diodes from quasi-two-dimensional perovskite nanocrystals

  • Zhang, Jibin
  • Liu, Tianjun
  • Gu, Qichun
  • Lin, Shuailing
  • Mao, Jian
  • Wei, Zimu
  • Wang, Meng
  • Lu, Yang
  • Cai, Bo
  • Ooi, Zher Ying
  • Mirabelli, Alessandro James
  • Lian, Linyuan
  • Anaya, Miguel
  • Liu, Ying
  • Jia, Mochen
  • Chen, Xu
  • Han, Yanbing
  • Ji, Xinzhen
  • Zhang, Yiwei
  • Ma, Zhuangzhuang
  • Zhang, Xinping
  • Zhou, Xin
  • Li, Xinjian
  • Yuan, Fanglong
  • Hou, Lintao
  • Shan, Chongxin
  • Greenham, Neil C.
  • Stranks, Samuel D.
  • Shi, Zhifeng
Metal halide perovskite light-emitting diodes offer a promising platform for low-cost full-color displays, yet achieving high-performance pure-red emission remains challenging. Here, we report a crystallization regulation strategy for mixed bromide/iodide quasi-two-dimensional perovskites using a multifunctional molecule, 4-(trifluoromethyl)benzenesulfonamide, which simultaneously coordinates with organic spacer cations, Pb2+ ions and halide ions. Moreover, the combination of large steric hindrance and ordered molecular assembly in the precursor solution plays a decisive role in directing the formation of nanocrystals, thereby suppressing defect formation, inhibiting halide ions migration, and enhancing exciton binding energy. The resulting light-emitting diodes exhibited pure-red emission at ~635 nm, delivering a peak external quantum efficiency of 30.2%, a maximum luminance exceeding 25,000 cd m-2, and a half-lifetime of 8426 min. Achieving perovskite light-emitting diodes with performance comparable to that of quantum-dot or organic light-emitting diodes would mark a major milestone toward commercialization. This work would expand opportunities beyond conventional light-emitting diode technologies., J.Z. acknowledges financial support from the National Natural Science Foundation of China [12574460, 12304473], the Natural Science Foundation of Henan Province [252300421229], the JSPS Postdoctoral Fellowships for Research in Japan and JSPS Grants-in-Aid for Scientific Research (KAKENHI) (25KF0209). Z.S. acknowledges financial support from the National Natural Science Foundation of China [U24A20292], the Natural Science Foundation of Henan Province [252300421236], and the Science and Technology Innovation Leading Talent Program of Henan Province [264200510013]. B.C. acknowledges financial support from the National Natural Science Foundation of China [62404107]. T.L., Q.G., Z.W., Yang L., Z.Y.O., A.J.M., and S.D.S. acknowledge financial support from the Engineering and Physical Sciences Research Council (EPSRC) [EP/R023980/1, EP/S030638/1, EP/V012932/1, EP/V027131/1]. S.D.S. further acknowledges financial support from the Royal Society and Tata Group [UF150033] and the European Research Council under the European Union’s Horizon 2020 research and innovation program [756962]. M.A. acknowledges financial support from the Royal Academy of Engineering under the Research Fellowship program, and from MICIU/AEI/10.13039/501100011033 and the European Union NextGenerationEU/PRTR through a Ramón y Cajal Fellowship [RYC2021-034941-I]. J.M. acknowledges financial support for the research of this work from the Marie Skłodowska-Curie Postdoctoral Fellowships via UKRI Horizon Europe Guarantee [EP/X025764/1] and the National Natural Science Foundation of China [62204049]., Peer reviewed