RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación
Capítulo o parte de un libro (BookPart)
Internal flow and air core dynamics in simplex and spill-return pressure-swirl atomizers
[EN] It is well known that the spray characteristics of pressure-swirl atomizers are strongly linked to the internal flow and
that an unstable air core may cause instabilities in the spray. In this paper, a 10:1 scale transparent Plexiglas
(PMMA) model of a pressure-swirl atomizer as used in a small gas turbine is introduced. The internal flow was
examined using high-speed imaging, laser-Doppler anemometry and computational fluid dynamics tools. The
experimental and numerical results were analysed and compared in terms of the air core morphology and its
temporal stability. Two different liquids were used, Kerosene-type Jet A-1 represented a commonly used fuel while
p-Cymene (4-Isopropyltoluene) matched the refractive index of the Plexiglas atomizer body. The internal flow
characteristics were set using dimensionless numbers i.e. the Reynolds number and Froude number. The flow test
conditions were limited to inlet Reynolds numbers from 750 to 1750. Two atomizers were examined to represent a
Simplex and Spill-return (SR) geometries. In a comparative manner, the SR atomizer features a central passage in
the rear wall of the swirl chamber. The main advantage of this concept is that the fuel is always supplied to the swirl
chamber at a high pressure therefore providing good atomization over a wide range of the injection flow rate.
However, the presence of the spill orifice strongly affects the internal flow even if the spill-line is closed. The air core
in the Simplex atomizer was found fully developed and stable. The SR atomizer behaved differently, the air core
did not form at all, and the spray was therefore unstable., This work has been supported by the project No. GA15-09040S funded by the Czech Science Foundation and the project LO1202 NETME CENTRE PLUS with the financial support from the Ministry of Education, Youth and Sports of the Czech Republic under the "National Sustainability Programme I" and project Reg. No. FSI-S-17-4444 funded by the Brno University of Technology.