Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 8
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

High-Performance Ammonia Sensor at Room Temperature Based on a Love-Wave Device with Fe2O3@WO3−x Nanoneedles

  • Bahos, Fabio Andrés
  • Vallejos, Stella
  • Gràcia Tortadès, Isabel
  • Cané Ballart, Carles
  • Fernández, María Jesús
  • Horrillo, Carmen
  • Matatagui, Daniel
An innovative, simple and inexpensive Love-wave gas sensor based on Fe<sub>2</sub>O<sub>3</sub>@WO<sub>3</sub>−x nanoneedles to detect the variation of ammonia at room temperature was developed. The nanoneedles were successfully formed on Love-wave device via aerosol-assisted chemical vapor deposition (AACVD). The nanoneedles worked as guiding and sensitive layers detecting the changes of the elastic properties presented by ammonia interaction. The sensor was tested to ammonia concentrations between 25 to 90 ppm and showed large frequency shifts, high sensibility, short response time and good reproducibility., This research is supported by project DGAPA-PAPIIT IA-103016 from Universidad Nacional Autónoma de México and the projects TEC-2013-48147 (AEI/FEDER, EU) and TEC2015-74329-JIN (AEI/FEDER, EU) from Ministerio de Economía y Competitividad of Spain. In addition, F. A. Bahos thanks Programa de Posgrado en Ingeniería- UNAM and CONACYT for Master studies grant.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Room Temperature Ethanol Microsensors Based on Silanized Tungsten Oxide Nanowires

  • Vallejos, Stella
  • Fohlerová, Zdenka
  • Tomić, Milena
  • Gràcia Tortadès, Isabel
  • Figueras Costa, Eduard
  • Cané Ballart, Carles
Gas microsensors based on tungsten oxide (WO3-x) nanowires (NWs) silanized with APTES (3-aminopropyltriethoxysilane) are developed in this work. These surface modified microsensors are highly sensitive to ethanol at room temperature (RT) via photoactivation and show enhanced selectivity towards other volatile organic compounds (VOCs) including acetone and toluene., This work has been supported by the Czech Science Foundation (GAČR) via Grant no. 17-16531S. The support of the Spanish Ministry of Economy and Competitiveness via the Ramón y Cajal programme and projects TEC2015-74329-JIN-(AEI/FEDER, EU) and TEC2016-79898-C6-1-R (AEI/FEDER, EU) are also acknowledged, Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Cerium oxide-tungsten oxide core-shell nanowire-based microsensors sensitive to acetone

  • Tomić, Milena
  • Šetka, Milena
  • Chmela, Ondřej
  • Gràcia Tortadès, Isabel
  • Figueras Costa, Eduard
  • Cané Ballart, Carles
  • Vallejos, Stella
Gas sensitive cerium oxide-tungsten oxide core-shell nanowires are synthesized and integrated directly into micromachined platforms via aerosol assisted chemical vapor deposition. Tests to various volatile organic compounds (acetone, ethanol, and toluene) involved in early disease diagnosis demonstrate enhanced sensitivity to acetone for the core-shell structures in contrast to the non-modified materials (i.e., only tungsten oxide or cerium oxide). This is attributed to the high density of oxygen vacancy defects at the shell, as well as the formation of heterojunctions at the core-shell interface, which provide the modified nanowires with ‘extra’ chemical and electronic sensitization as compared to the non-modified materials., This work has been supported by the Czech Science Foundation (GAČR) via Grant no. 17-16531S, and the Spanish Ministry of Science and Innovation via the Ramón y Cajal Programme and Grants TEC2015-74329-JIN-(AEI/FEDER,EU) and TEC2016-79898-C6-(AEI/FEDER,EU). This research has used the Spanish ICTS Network MICRONANOFABS (partially funded by MINECO). CEITEC Nano Research Infrastructure (IDLM2015041, MEYS CR, 2016–2019) is also acknowledged., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Love Wave Sensors with Silver Modified Polypyrrole Nanoparticles for VOCs Monitoring

  • Šetka, Milena
  • Bahos, Fabio Andrés
  • Matatagui, Daniel
  • Gràcia Tortadès, Isabel
  • Figueras Costa, Eduard
  • Drbohlavová, Jana
  • Vallejos, Stella
© 2020 by the authors., Love wave sensors with silver-modified polypyrrole nanoparticles are developed in this work. These systems prove functional at room temperature with enhanced response, sensitivity and response time, as compared to other state-of-the-art surface acoustic wave (SAW) sensors, towards volatile organic compounds (VOCs). Results demonstrate the monitoring of hundreds of ppb of compounds such as acetone, ethanol and toluene with low estimated limits of detection (~3 ppb for acetone). These results are attributed to the use of silver-modified polypyrrole as a second guiding/sensitive layer in the Love wave sensor structure, which provides further chemically active sites for the gas-solid interactions. The sensing of low VOCs concentrations by micro sensing elements as those presented here could be beneficial in future systems for air quality control, food quality control or disease diagnosis via exhaled breath as the limits of detection obtained are within those required in these applications., This research was funded by the Czech Science Foundation (GACR) via Grant No. 20-20123S, ˇ the Spanish Ministry of Economy and Competitiveness via projects TEC2015-74329-JIN-(AEI/FEDER, EU), and TEC2016-79898-C6-1-R (AEI/FEDER, EU) and by Universidad Nacional Autónoma de México via Grant DGAPA-UNAM-PAPIIT TA100118. The support of the “Ramón y Cajal” programme is also acknowledged. This research has made use of the infrastructures the Spanish ICTS Network MICRONANOFABS, partially supported by MINECO, and Czech CEITEC Nano Research Infrastructure, supported by MEYS (2016-2019)., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Gas sensitive ZnO structures with reduced humidity-interference

  • Vallejos, Stella
  • Gràcia Tortadès, Isabel
  • Pizúrová, Naděžda
  • Figueras, Eduard
  • Čechal, Jan
  • Hubálek, J.
  • Cané, Carles
Gas microsensors based on zinc oxide structures with rod- and needle-like morphology, both integrated via a non-catalyzed vapor-solid mechanism enabled using aerosol-assisted chemical vapor deposition, are developed. Analyses of the films via SEM, TEM, XPS, and water contact angle indicate a higher concentration of oxygen vacancies, higher aspect ratio and higher roughness factor for the needles than for the rods. Gas sensing tests towards hydrogen and carbon monoxide demonstrate reduced humidity-interference, and higher responses to the analytes for the needle-based systems compared to the rods. These results are attributed to the morphology of the sensitive materials, which not only affects the surface-area-to-volume-ratio of the films but also their surface chemistry. These findings indicate that a thorough optimization of morphology, structure and surface properties of gas sensitive metal oxides could allow for more reliable sensor operation in humid conditions., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Love wave sensors based on gold nanoparticle-modified polypyrrole and their properties to ammonia and ethylene

  • Šetka, Milena
  • Bahos, Fabio Andrés
  • Matatagui, Daniel
  • Potoček, Michal
  • Kral, Z.
  • Drbohlavová, Jana
  • Gràcia Tortadès, Isabel
  • Vallejos, Stella
This work presents the fabrication and gas sensing properties of Love wave sensors based on non-modified and gold nanoparticle-modified polypyrrole. Results demonstrate the integration of uniform polypyrrole layers with smooth granular surface and the incorporation of dispersed crystalline gold nanoparticles within the modified layers. Gas sensing tests of the sensors in dry conditions show enhanced sensing performance to ethylene and ammonia for the modified systems as compared to those without modification and those reported in the literature. The effect of humidity proves significant in both systems with the results showing a decrease of sensitivity in humid conditions. Despite this weakness, the relatively facile and scalable fabrication of these sensors, as well as their sensing response at room temperature may be attractive in gas detection systems, in which high humidity levels can be restricted by the use of filter or preconditioning elements., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Cadmium telluride/polypyrrole nanocomposite based Love wave sensors highly sensitive to acetone at room temperature

  • Šetka, Milena
  • Bahos, Fabio Andrés
  • Chmela, Ondrej
  • Matatagui, Daniel
  • Gràcia Tortadès, Isabel
  • Drbohlavová, Jana
  • Vallejos, Stella
Cadmium telluride/polypyrrole (CdTe/PPy) nanocomposites are synthesized and integrated into Love mode surface acoustic wave (L SAW) sensors, achieving high sensitivity to various volatile organic compounds including acetone, ethanol, and toluene. Chemical/physical analysis of the composites and their integration as second/guiding sensitive layer into the L SAW structure show no evidence of strong chemical interaction among the structural components based on CdTe quantum dots and PPy nanoparticles. The gas sensing tests are focus on the performance of L SAW sensors consisting of CdTe/PPy (1:10), CdTe/PPy (1:2), and non-modified PPy layers. Results reveal that the L SAW sensors containing CdTe/PPy (1:10) composite improve the sensing performances to acetone showing a sensitivity of 771 Hz/ppm, an estimated limit of detection (LOD) of 5 ppb, and low interference to ethanol and toluene, compared to the sensors with CdTe/PPy (1:2) or without CdTe modification. The high sensitivity of the L SAW sensors to acetone is connected with the adsorption of acetone at PPy via dipole-dipole interaction and the incorporation of CdTe in the guiding/sensitive L SAW layers., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Highly hydrogen sensitive micromachined sensors based on aerosol-assisted chemical vapor deposited ZnO rods

  • Vallejos, Stella
  • Gràcia Tortadès, Isabel
  • Lednický, Tomáš
  • Vojkuvka, Lukáš
  • Figueras, Eduard
  • Hubálek, J.
  • Cané, Carles
Chemoresistive gas microsensors with highly hydrogen sensitive zinc oxide rods dominated by exposed {100} surfaces are fabricated. The hexagonal rod structures are integrated into micromachined transducing platforms without the need for substrate pre-treatment, via a vapor-solid mechanism enabled using an aerosol-assisted chemical vapor deposition method. The microsensors demonstrate an enhanced functionality towards hydrogen, with greater sensor responses (between 200% and 1800%) compared to other gases including ethanol, carbon monoxide, acetone, and toluene, and with low interferences among these reductive gases. The improved functionality of these systems towards hydrogen is attributed to the formation of an accumulation layer at the zinc oxide rods after hydrogen exposure, which includes a mechanism not only dominated by the oxygen vacancies, but also by the formation of intermediate energy levels for the transfer of charge from hydrogen to the zinc oxide conduction band., Peer reviewed