Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 5
Encontrada(s) 1 página(s)

Dipòsit Digital de Documents de la UAB
Publicación Artículo científico (JournalArticle)

Personalized heart rate management through data-driven dynamic exercise control

  • Sato, Takao|||0000-0003-0590-3594
  • Nishino, Tomoka
  • Kawaguchi, Natsuki
  • Mori, Hisashi
  • Uchida, Hayato
  • Murotani, Kiichiro
  • Kimura, Yuichi
  • Mizukura, Isao
  • Kobashi, Syoji
  • Arrieta Orozco, Orlando|||0000-0002-4004-8573
Maximizing healthy life expectancy is essential for enhancing well-being. Optimal exercise intensity is crucial in promoting health and ensuring safe rehabilitation. Since heart rate is related to exercise intensity, the required exercise intensity is achieved by controlling the heart rate. This study aims to control heart rate during exercise by dynamically adjusting the load on a bicycle ergometer using a proportional-integral (PI) control. The choice of PI parameters is very important because the PI parameters significantly affect the performance of heart rate control. Since the dynamic characteristics of heart rate relative to work rate vary widely from subject to subject, the PI parameters for each subject must be determined individually. In this study, PI parameters are optimized directly from exercise data using a data-driven design approach. Thus, the proposed method does not require excessive exercise of the subject to model heart rate dynamics. Using the proposed method, the heart rate can be controlled to follow a designed reference model so that the heart rate is safely increased to the desired value. The quantitative evaluation of the control results of fifteen healthy volunteers confirmed that the proposed method improved the control error of the target heart rate trajectory by approximately 40%, regardless of gender or age. In addition, it was shown that control parameters from the exercise experiment also indicate that females are more likely than males to have an elevated heart rate at the same load.
Dipòsit Digital de Documents de la UAB
Publicación Artículo científico (JournalArticle)

Transfer Learning in wastewater treatment plants control, Measuring the transfer suitability

  • Pisa, Ivan|||0000-0003-3931-9257
  • Morell, Antoni|||0000-0003-2249-8594
  • Lopez Vicario, Jose|||0000-0002-3574-4697
  • Vilanova, Ramon|||0000-0002-8035-5199
The industrial sector is nowadays experiencing a digital transformation motivated by the Industry 4.0 paradigm. Concepts such as data-driven models, Artificial Neural Networks (ANNs), and Transfer Learning (TL) are part of the current vocabulary in the industrial management and control topics. For that reason, in this paper the application of TL techniques is proposed to derive new ANN-based control structures from pre-existing ones. Notice that if an ANN-based controller is transferred into a new industrial environment, its appropriate behaviour must be ensured, and what it is more important, this must be known a priori. Nevertheless, TL techniques do not always ensure this. That is why the Transfer Suitability Metric (TSM) is proposed here. Determining the similarity among environments, this metric tells if the controller can be transferred, transferred with certain limitations, or if it cannot be transferred at all. Here, the metric is applied over a Wastewater Treatment Plant (WWTP). The objective is to derive the control structure of one control loop, let us say the Dissolved Oxygen (DO), and then transfer it into another basic control loop in a WWTP, the Nitrate-nitrogen (NO), and vice-versa. Results show that with the help of the TSM, an improvement around a 68.54% and 80.53% in the Integrated Absolute Error (IAE) and the Integrated Squared Error (ISE) is obtained in the NO management, respectively. Moreover, a simplification and speed-up of the controller design process is achieved.
Dipòsit Digital de Documents de la UAB
Publicación Artículo científico (JournalArticle)

Nitrous oxide reduction in wastewater treatment plants by the regulation of the internal recirculation flow rate with a fuzzy controller

  • Santín López, Ignacio|||0000-0002-4312-1035
  • Meneses, Montse|||0000-0002-5846-2676
  • Pedret Ferré, Carles|||0000-0001-8633-2548
  • Barbu, Marian|||0000-0001-6645-3705
  • Vilanova, Ramon|||0000-0002-8035-5199
The reduction of greenhouse gas emissions due to anthropogenic causes is one of the world's main challenges to face climate change. Wastewater treatment plants are necessary to improve the quality of wastewater before it is discharged into the receiving environment, but they have the disadvantage of generating nitrous oxide emissions during the biological treatment, which is a potent greenhouse gas. Avoiding partial nitrification by increasing dissolved oxygen is one of the ways to reduce these emissions. However, this article proposes to face a reduction of nitrous oxide emissions by reducing oxygen to minimum levels causing heterotrophic microorganisms to reduce nitrous oxide to dinitrogen. To achieve this objective, the present work proposes a regulation of the internal recirculation flow rate of the biological treatment by means of a fuzzy controller. This regulation is added to a usual control strategy in wastewater treatment plants, which achieves satisfactory results with respect to water quality and operational costs but that generates high nitrous oxide emissions. The Benchmark Simulation Model no. 2 Gas is used as working scenario, which includes the two main nitrous oxide emission pathways: heterotrophic denitrification and ammonia oxidizing bacteria denitrification. The proposed internal recirculation manipulation is shown to achieve nitrous oxide reductions of 26.70 and 30.83 % in different time periods with a slight effluent quality improvement and an operational cost reduction.
Dipòsit Digital de Documents de la UAB
Publicación Artículo científico (JournalArticle)

Design a Robust Proportional-Derivative Gain-Scheduling Control for a Magnetic Levitation System

  • Almobaied, Moayed|||0000-0001-7912-2673
  • Al-Nahhal, Hassan|||0000-0003-0547-542X
  • Arrieta Orozco, Orlando|||0000-0002-4004-8573
  • Vilanova, Ramon|||0000-0002-8035-5199
This study focuses on the design of a robust PD gain-scheduling controller (PD-GS-C) for an unstable SISO (single-input, single-output) magnetic levitation system with two electromagnets (MLS2EM). Magnetic levitation systems offer various advantages, including friction-free, reliable, fast, and cost-effective operations. However, due to their unstable and highly nonlinear nature, these systems require sophisticated feedback control techniques to ensure optimal performance and functionality. To address these challenges, in this study, we derive the nonlinear state-space mathematical model of the MLS2EM and linearize it around five different operating points. The PDGS-C controller aims to stabilize the system and improve steady-state control error. The strategy for obtaining the PD controller gains involves a parameter space technique, which specifies performance requirements. This technique results in ranges of proportional (KP) and derivative (KD) gains that are used by the PD-GS-C structure. To optimize the controller's performance further, we utilize the big bang-big crunch optimization technique (BB-BC) to determine the optimal PD gains within the specified ranges. The optimization process focuses on achieving optimal performance in terms of a specific performance index function. This function quantifies the system's time-domain step response criteria, which include minimizing overshoot percentage, settling time, and rising time. The index function is inversely proportional to the desired performance criteria, meaning that the goal is to maximize the index function to optimize the system's performance. To validate the effectiveness and viability of the proposed strategy, we conducts MATLAB simulations and real-time experiments. The simulations and experimental findings serve to demonstrate the controller's performance and verify its capabilities in stabilizing the MLS2EM magnetic levitation system.
Dipòsit Digital de Documents de la UAB
Publicación Artículo científico (JournalArticle)

Memristor Crossbar Array Simulation for Deep Learning Applications

  • Diaz Machado, Elvis|||0000-0002-6583-8547
  • Lopez Vicario, Jose|||0000-0002-3574-4697
  • Miranda, E.|||0000-0003-0470-5318
  • Morell, Antoni|||0000-0003-2249-8594
Hardware neural networks (HNNs) based on crossbar arrays are expected to be energy-efficient computing architectures for solving complex tasks due to their small feature sizes. Although there exist software libraries able to deal with circuit simulation of memristor networks, they still exceed the memory available of any consumer grade GPU's VRAM for large scale crossbar arrays while having a significant computational complexity. This work discusses an iterative method to implement a fast simulation of the corresponding memristor crossbar array with much more limited memory use.