Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 4
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Increasing Peak Power Handling in Microstrip Bandpass Filters by Using Rounded-End Resonators

  • Morales-Hernández, Aitor
  • Sánchez-Soriano, Miguel Á.
  • Marini, Stephan
  • Guglielmi, Marco
  • Boria Esbert, Vicente Enrique|||0000-0001-7150-9785
[EN] This work describes a new strategy for improving the peak power handling capability (PPHC) of microstrip bandpass filters (BPFs) without any degradation in the electrical performance. For this purpose, a new resonator topology with rounded open-circuit terminations is proposed. Using this strategy, sharp edges are avoided, and a reduction of the maximum peak voltage (V-peak) is obtained, leading to higher peak power thresholds. An in-depth analysis of the variation of V-peak and PPHC as a function of the circle radius is also carried out. As a validation, two microstrip BPFs centered at 1.6 GHz with different end-circle sizes are designed, manufactured, and measured, showing a PPHC enhancement of 2.10 and 1.15 dB, respectively, compared to a standard microstrip BPF., This work was supported in part by the University of Alicante through the Fellowship Grant UAFPU2018-054 and in part by the Ministry of Science and Innovation through the sub-projects C41 and C43 of the Coordinated Project PID2019-103982RB.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Contribución de congreso (ConferenceOutput)

Estrategia de Diseño para Aumentar la Capacidad en Potencia en Guias de Onda Groove-Gap

  • Morales-Hernández, Aitor
  • Sánchez-Soriano, Miguel Ángel
  • Marini, Stephan
  • Ferrando-Rocher, Miguel|||0000-0003-4098-7180
  • Boria Esbert, Vicente Enrique|||0000-0001-7150-9785
[EN] This work describes a new design strategy for improving the power handling capability (PHC) of groove gap waveguides (GGW). First, a theoretical analysis is carried out to study the distribution of the quasi-TE10 mode and the variation of the PHC for different configurations and frequencies. Then, in order to minimize the strength of the maximum electric field above the pins, three of the main geometrical dimensions of the nails are optimized. Finally, the numerical results show that by using this strategy, the corona discharge power thresholds can be enhanced without degrading the electrical response., Este trabajo ha sido financiado por la Universidad de Alicante mediante la beca de investigación UAFPU2018-054, y por el Ministerio de Ciencia e Innovación a través de los proyectos de investigación PID2019-103982RB-C41 y PID2019-103982RB-C43.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Enhancement of corona discharge thresholds in microstrip bandpass filters by using cover-ended resonators

  • Morales-Hernández, Aitor
  • Sánchez-Soriano, Miguel Á.
  • Marini, Stephan
  • Esteve, Laura
  • Guglielmi, Marco
  • Reglero Mangada, Marta Sofía|||0000-0002-3811-843X
  • Boria Esbert, Vicente Enrique|||0000-0001-7150-9785
[EN] This paper studies the corona discharge power thresholds in microstrip bandpass filters (BPFs) and, in particular, is focused on a solution based on lambda/2 cover-ended resonators to enhance their peak power handling capability (PPHC). First, a parametric analysis is carried out to evaluate the variation of the maximum electric field and the unloaded quality factor (Q(u)) as a function of the cover's geometrical dimensions (i.e. height, length, and width). Next, several microstrip BPFs centered at 1.6 GHz are designed, and their behaviors under moderate-to-high applied RF power signals are simulated to corroborate the previous study. A suitable number and size of covers are selected to enhance PPHC without barely degrading the filters' electrical performance and, consequently, without hardly increasing the insertion losses. Finally, two third-order filters with covers and without covers (benchmark prototype) are manufactured, by way of illustration, and they are tested in the European High-Power RF Space Laboratory to validate the good performance of the proposed solution, where a PPHC enhancement of 3.1 dB at high pressures is achieved as compared to the benchmark prototype., This work has been supported by the University of Alicante through the fellowship grant UAFPU2018-054 and by the "Ministerio de Ciencia e Innovacion" through the sub-projects C41 and C43 of the coordinated project PID2019-103982RB. The authors would like to thank Val Space Consortium for its contribution - Laboratories funded by the European Development Fund - A way of making Europe.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Peak Power Handling Capability in Groove Gap Waveguide Filters Based on Horizontally Polarized Resonators and Enhancement Solutions

  • Morales-Hernández, Aitor
  • Sánchez-Soriano, Miguel Ángel
  • Marini, Stephan
  • Ferrando-Rocher, Miguel|||0000-0003-4098-7180
  • Taroncher Calduch, Mariam|||0000-0001-9068-1169
  • Boria Esbert, Vicente Enrique|||0000-0001-7150-9785
[EN] This letter studies the peak power handling capability (PPHC) in groove gap waveguide filters based on horizontally polarized resonators. Moreover, a modification of the resonant cavity is proposed, where the central pins of the original structure are replaced by a rounded metal block. As a result of this change, the TE101-like mode can still be excited, but the maximum electric field strength is shifted to the center of the cavity, which leads to a higher PPHC. The main advantages of the original structure are maintained, and greater robustness in the manufacturing process is achieved. Next, some guidelines for the design of the coupling windows and the dimensions of the blocks are shown to minimize the electric field strength and, consequently, maximize the PPHC. Finally, two third-order bandpass filters (with pins and with blocks) centered at 16 GHz have been manufactured and tested in a measurement campaign, where a PPHC enhancement of 8.7 dB at high pressures is achieved for the novel solution presented in this work., This work was supported in part by the University of Alicante through the Fellowship Grant UAFPU2018-054 and in part by MCIN/AEI/10.13039/501100011033 through the Sub-Projects C41 and C43 of the Coordinated Project under Grant PID2019-103982RB.