Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Electrochemical properties of PSFC-BCYb composites as cathodes for proton conducting solid oxide fuel cells

  • Vert Belenguer, Vicente Bernardo
  • Solis Díaz, Cecilia
  • Serra Alfaro, José Manuel|||0000-0002-1515-1106
[EN] The electrochemical properties of mixed conducing ceramic¿ceramic composites for proton conducting fuel cells have been investigated. Different ratios of Pr0.58Sr0.4Fe0.8Co0.2O3¿¿¿BaCe0.9Yb0.1O3¿¿ composites have been tested as cathodes in symmetrical cells based on BaCe0.9Y0.1O3¿¿ dense electrolytes. Impedance measurements have been carried out in the temperature range of 600¿800¿°C under wet (2.5%) air. Different dilutions on both oxygen partial pressure and water content have been performed as a function of the temperature in order to characterise the processes (surface reaction and charge transport) occurring at the composite electrode under oxidising conditions. The variation of the impedance spectra after replacing protonated water by heavy water has been studied in order to understand the role of the proton transport in the overall composite cathode operation. Additional four-point DC-conductivity measurements have been done under different atmospheres comprising different oxygen partial pressures and H2O/D2O saturation for composites and single materials., Funding from Universitat Politècnica de València (grant FPI-UPV-2007-06), the Spanish Ministry for Science and Innovation (Project ENE-2008-06302) and European Union (FP7 Project EFFIPRO – grant Agreement 227560) are kindly acknowledged. Authors are indebted to S. Jiménez for sample preparation.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Tesis de maestría (MasterThesis)

Monitorización del contenido de humedad de láminas de lasaña mediante ultrasonidos sin contacto, Contactless Ultrasonic Monitoring of Moisture Content in Lasagna Sheets, Monitorització del contingut d humitat de làmines de lasanya mitjançant ultrasons sense contacte

  • Mansilla-Villena Becerra, Constanza María Pía
[ES] El contenido de humedad es un factor determinante en la calidad y aceptabilidad de los productos de pasta laminada, ya que afecta a su estructura y propiedades texturales durante el procesado y el almacenamiento. No obstante, la evaluación de estos cambios se ha basado tradicionalmente en métodos destructivos, limitando su aplicación industrial. El objetivo de este estudio fue analizar la relación entre el contenido de humedad y los parámetros ultrasónicos y texturales de muestras de lasaña seca, evaluando el potencial de técnicas ultrasónicas sin contacto como herramienta no destructivas. Las muestras se sometieron a diferentes condiciones de humedad y se analizaron mediante ensayos de textura y mediciones ultrasónicas, aplicándose análisis estadístico y multivariante. Los resultados mostraron que el aumento de humedad se asocia con una pérdida de firmeza y rigidez, junto con disminución del tiempo de vuelo, lo que sugiere modificaciones en la matriz alimentaria. Estos resultados indican el potencial de las técnicas ultrasónicas para la monitorización no destructiva de productos de pasta., Los autores agradecen la financiación del proyecto ULTRADIGITALM (AGROALNEXT/2022/045), el cual forma parte del programa AGROALNEXT, financiado por el Ministerio de Ciencia e Innovación con fondos europeos NextGenerationEU (PRTR-C17.I1), así como por la Generalitat Valenciana.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Enhanced oxygen diffusion in low barium-containing La0.2175Pr0.2175Ba0.145Sr0.4Fe0.8Co0.2O3&amp, #8722, &amp, #948, intermediate temperature solid oxide fuel cell cathodes

  • Vert Belenguer, Vicente Bernardo
  • Kilner, J.A.
  • Burriel, M.
  • Serra Alfaro, José Manuel|||0000-0002-1515-1106
[EN] Isotopic tracer diffusion studies have been performed on the perovskite composition La0.2175Pr0.2175Ba0.145Sr0.4Fe0.8Co0.2O3-delta to obtain the diffusion and surface exchange coefficients for oxygen. This material has been identified as a highly active electrocatalytic cathode for intermediate temperature solid oxide fuel cells. The oxygen diffusion coefficients obtained in the 450-650 degrees C temperature range are higher than the ones measured for most of the cathode materials reported in the literature and they agree with those calculated from electrochemical impedance spectroscopy measurements performed on symmetrical cells., Funding from the Universitat Politecnica de Valencia (grants FPI-UPV-2007-06 and PAID-00-10) and Spanish Government (grant ENE2011-24761) is kindly acknowledged. The research leading to these results has received funding from the European Union Seventh Framework Programme (FP7/2007-2013) under grant agreement no : PIEF-GA-2009-252711 and from King Abdullah University of Science and Technology (KAUST) through a research grant. The authors would like to thank S. Jimenez for material and sample preparation and Dr. S. Fearn, R. Charter and S. Cook for their help with ToF-SIMS analysis.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Study of CO2 stability and electrochemical oxygen activation of mixed conductors with low thermal expansion coefficient based on the TbBaCo3ZnO7+δ system

  • Vert Belenguer, Vicente Bernardo
  • Serra Alfaro, José Manuel|||0000-0002-1515-1106
[EN] The influence of different application-oriented factors on the electrochemical activity and stability of TbBaCo3ZnO7+delta when used as a solid oxide fuel cell cathode has been studied. Calcination at temperatures above 900 degrees C (e.g. 1000 degrees C) leads to a significant increase in the electrode polarization resistance. The effect of the sintering temperature of the TbBaCo3ZnO7+delta cathode seems to be more important than the effect produced by the Tb substitution as observed when compared with 900 degrees C-sintered YBaCo3ZnO7+delta; and ErBaCo3ZnO7+delta electrode performances. The presence of CO2 in the air flow leads to an increase of roughly 10% in the polarization resistance for the whole studied temperature range (500-850 degrees C) while this effect is reversible. Analysis of the impedance spectroscopy measurements shows that the exchange rate constant (k(G) from Gerischer element) is significantly affected by CO2 at temperatures below 700 degrees C, while the diffusion coefficient related parameter is slightly influenced at low temperatures. Electrode degrades with a low constant rate of 1 m Omega cm(2) h(-1) after 60h. This cathode material exhibits high CO2 tolerance, as shown by temperature programmed treatment under a continuous gas flow of air with 5% CO2, and a relatively low thermal expansion coefficient., Financial support by the Universitat Politecnica de Valencia (Grant UPV-2007-06), the Spanish Ministry for Science and Innovation (Project ENE2008-06302), the EU through FP7 NASA-OTM Project (NMP3-SL-2009-228701), and the Helmholtz Association of German Research Centres through the Helmholtz Alliance MEM-BRAIN (Initiative and Networking Fund) is kindly acknowledged. The revision of this paper was funded by the Politecnica de Valencia. The authors wish to thank S. Jimenez for material preparation.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Quaternary mixture designs applied to the development of multi-element oxygen electrocatalysts based on the Ln(0.58)Sr(0.4)Fe(0.8)Co(0.2)O(3-delta) system (Ln = La1-x-y-zPrxSmyBaz): Predictive modeling approaches

  • Serra Alfaro, José Manuel|||0000-0002-1515-1106
  • Vert Belenguer, Vicente Bernardo
[EN] The experimental data generated through the optimization of oxygen electrocatalysts based on the perovskite Ln(0.58)Sr(0.4)Fe(0.8)Co(0.2)O(3-delta) system (Ln = La1-x-y-zPrxSmyBaz) have been modeled following different approaches. The main application of these catalysts is as fuel cell (SOFC) cathodes and activation layers on oxygen-transport membranes. Among the different La, Pr and Sm combinations, those containing at a time Sm-La-Ba or alternatively Pr-La-Ba show the lowest polarization resistance values. Within the same substitution degree, Pr-Ba-based compositions have lower electrode resistance than samarium-based ones. The experimental datasets available for the series of materials can be divided into: composition data, structural data (X-ray diffraction patterns), and electrochemical characterization data (electrochemical impedance spectra). Electrochemical characterization was performed for each electrode composition as a function of the operating temperature and oxygen partial pressure. Different ways of reducing the dimensionality of the spectral descriptors (XRD patterns and impedance spectroscopy) were applied based on knowledge-guided and unsupervised approaches. Different material descriptors were studied as input variables in the modeling of the electrochemical properties. (C) 2010 Elsevier B.V. All rights reserved., Funding from Universitat Politècnica de València (grant UPV2007-06), the Spanish Ministry for Science and Innovation (Project ENE-2008-06302), the Helmholtz Association of German Research Centers through the Helmholtz Alliance MEM-BRAIN (Initiative and Networking Fund) and EU through FP7 NASA-OTM Project (NMP3-SL-2009-228701) is kindly acknowledged.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Redox stability and electrochemical study of nickel doped chromites as anodes for H-2/CH4-fueled solid oxide fuel cells

  • Vert Belenguer, Vicente Bernardo
  • MELO FAUS, FRANCISCO VICENTE
  • Navarrete Algaba, Laura
  • Serra Alfaro, José Manuel|||0000-0002-1515-1106
[EN] The influence of nickel and strontium incorporation in LaCrO3 on the crystalline structure, redox behavior and electrochemical performance by impedance spectroscopy using symmetrical cells has been studied. Namely, the La1-xSrxCr1-yNiyO3-delta (x = 0, 0.15: y = 0.05, 0.1, 0.2) system was investigated. Structural and redox evolution has been monitored by X-ray diffraction in oxidized and reduced samples. Reduced samples kept the initial perovskite structure although metallic nickel nanoparticles were detected on the perovskite grain surface by TEM analysis. The re-oxidized surface did not present nickel particles, suggesting the nickel re-incorporation into perovskite lattice coupled with cation diffusion. The perovskites were tested as SOFC anodes and the polarization resistance depended on the nickel stoichiometry and the reduction temperature. La0.85Sr0.15Cr0.9Ni0.1O3-delta reduced at 800 degrees C showed the lowest polarization resistance, both in hydrogen and methane. In fact this composition showed a 20% methane conversion at 900 degrees C for the methane steam reforming in a fixed bed reactor. Tolerance to redox cycling was proved electrochemically by in situ treatments of La0.85Sr0.15Cr0.9Ni0.1O3-delta electrode. Materials were further analyzed by TPR and XPS (in oxidized and reduced state) in order to identify the possible species involved in the electrocatalytic processes. (C) 2011 Elsevier B.V. All rights reserved., Authors thank funding by the Universidad Politecnica de Valencia (Grant FPI-UPV-2007-06), the Spanish Ministry for Science and Innovation (Project ENE2008-06302) and Generalitat Valenciana (Grant ACOMP2010/223). P. Concepcion has contributed to this work with the XPS measurements. N. Morlanes, S. Climent and M. Algarra are kindly acknowledged for the catalytic experiments.