Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 7
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Middle Stone Age in the Río Campo Region, Equatorial Guinea

  • Rosas, Antonio
  • García-Tabernero, Antonio
  • Fidalgo, Darío
  • Fero, Maximilian
  • Morales, Juan Ignacio
Ministerio de Ciencia, Innovación y Universidades (España); Consejo Superior de Investigaciones Científicas (España); Fundación Palarq
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Solid State Tuning of TiO2 Morphology, Crystal Phase, and Size through Metal Macromolecular Complexes and Its Significance in the Photocatalytic Response

  • Allende-Gonzalez, P.
  • Laguna-Bercero, M.A.
  • Barrientos, L.
  • Valenzuela, M.L.
  • Diaz, C.
A solid-state phase control of TiO2 by the use of different macromolecular complex precursors is reported for the first time. During the formation of TiO2 nanoparticles, chitosan and poly(styrene-co-4-vinylpyridine) polymers can act as solid-state template producing areas after carbonization, where the TiO2 nucleates. It seems that the location of metal centers through the polymeric chain (i.e., the distance between the metal centers) strongly influences the morphology and particle size of the photocatalyst. To demonstrate the application value of our different TiO2 structures, the photocatalytic behavior was explored. The efficient photocatalytic decoloration of methylene blue on different polymorphic forms of nanostructured TiO2 is confirmed. The best photocatalyst achieved a 98% discoloration rate in only 25 min when the pH of the solution was 9.5, improving the efficiency of the standard photocatalyst Degussa P25 without the addition of other phases or dopants. The novelty of the present work is that, by means of an appropriate synthesis, the three main factors (morphology, size, and crystalline phase) that allow modulating the photocatalytic response of titania material can be tuned simultaneously. This control has allowed an advance in the properties of the material, managing to increase the photoresponse in a short time.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Monte Carlo simulation of neutron scattering by a textured polycrystal

  • Laliena, Víctor
  • Vicente-Álvarez, Miguel Ángel
  • Campo, Javier
A method of simulating the neutron scattering by a textured polycrystal is presented. It is based on an expansion of the scattering cross sections in terms of the spherical harmonics of the incident and scattering directions, which is derived from the generalized Fourier expansion of the polycrystal orientation distribution function. The method has been implemented in a Monte Carlo code as a component of the McStas software package, and it has been validated by computing some pole figures of a Zircaloy-4 plate and a Zr-2.5Nb pressure tube, and by simulating an ideal transmission experiment. The code can be used to estimate the background generated by components of neutron instruments such as pressure cells, whose walls are made of alloys with significant crystallographic texture. As a first application, the effect of texture on the signal-to-noise ratio was studied in a simple model of a diffraction experiment, in which a sample is placed inside a pressure cell made of a zirconium alloy. With this setting, the results of two simulations were compared: one in which the pressure-cell wall has a uniform distribution of grain orientations, and another in which the pressure cell has the texture of a Zr-2.5Nb pressure tube. The results showed that the effect of the texture of the pressure cell on the noise of a diffractogram is very important. Thus, the signal-to-noise ratio can be controlled by appropriate choice of the texture of the pressure-cell walls.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Solventless preparation of thoria and its inclusion into SIO2 and TIO2: a luminescence and photocatalysis study

  • Diaz C.
  • Valenzuela M.L.
  • Laguna-Bercero M.A.
  • Carrillo D.
  • Segovia M.
  • Mendoza K.
  • Cartes P.
Thoria was prepared using a solid-state method from the macromolecular precursor Chitosan·Th(NO3)4 (chitosan) and PS-co-4-PVP·Th(NO3)4 (PVP). The morphology and the average size of ThO2 depend of the chitosan and PS-co-4-PVP polymer forming the precursor. Their photoluminescent properties were investigated, finding a dependence of their intensity emission maxima, with the nature of the precursor polymer. The photocatalytic activity of ThO2 toward the degradation of methylene blue was measured for the first time, finding a degradation of about 66% in 300 min. The inclusion of ThO2 into SiO2 and TiO2 was achieved by the solid-state pyrolysis of the macromolecular composites Chitosan·Th(NO3)4; MO2 and PS-co-4-PVP·Th(NO3)4; MO2, MO2 = SiO2 or TiO2. The ThO2 exhibits a homogeneous dispersion inside the silica, showing sizes of about 40 and 50 nm for the chitosan and PVP polymer precursors, respectively. The luminescent properties of the ThO2/SiO2 and ThO2/TiO2 composites were also studied, finding a decrease in intensity when introducing the SiO2 or TiO2 matrices. The photocatalytic behavior to methylene blue degradation of ThO2 and their composites ThO2/SiO2 and ThO2/TiO2 was investigated for the first time, with them in the following order: ThO2 > ThO2/TiO2 > ThO2/SiO2.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

A novel method to obtain integral parameters of the orientation distribution function of textured polycrystals from wavelength-resolved neutron transmission spectra

  • Vicente Alvarez M.A.
  • Laliena V.
  • Malamud F.
  • Campo J.
  • Santisteban J.
A novel method to estimate integral parameters of the orientation distribution function (ODF) in textured polycrystals from the wavelength-resolved neutron transmission is presented. It is based on the expression of the total coherent elastic cross section as a function of the Fourier coefficients of the ODF. This method is broken down in detail for obtaining Kearns factors in hexagonal crystals, and other material properties that depend on the average of second- and fourth-rank tensors. The robustness of the method against three situations was analyzed: effects of sample misalignment, of cutoff value l max of the series expansion and of experimental standard deviation. While sample misalignment is shown not to be critical for the determination of Kearns factors and second-order-rank properties, it can be critical for fourth-rank and higher-order tensor properties. The effect of the cutoff value on the method robustness is correlated to the standard deviation of the experimental data. In order to achieve a good estimation of the Fourier coefficients, it is recommended that the experimental standard deviation be around 3-5% of the total scattering cross section of the material for the method to be stable. The method was applied for the determination of Kearns factors from transmission measurements performed at the instrument ENGIN-X (ISIS) on a Zr-2.5 Nb pressure tube along two sample directions and was shown to be able to estimate Kearns factors with an error below 5%.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Routines for optimizing neutron scattering instruments with McStas

  • Laliena, V.
  • Vicente Álvarez, M. A.
  • Campo, J.
We present software routines for simulating the transport of thermal neutrons through materials relevant for neutron instrumentation. The elastic interactions in different types of textured polycrystals are modelled and implemented in the routines. Three limit cases of textures are explicitly considered: powder texture, with uniform distribution of grain orientations, mosaic single crystal texture, with a distribution of orientations sharply peaked about one direction, and ideal fibre textures. Sharp textures can be modelled as combinations of these three limit textures. For polycrystals with mild textures, a different method is used. The inelastic scattering is treated in the incoherent approximation, including multi-phonon terms of arbitrary large order. The routines have been implemented in the McStas software package.
Recercat. Dipósit de la Recerca de Catalunya
Publicación Artículo científico (JournalArticle)

J-PLUS: The javalambre photometric local universe survey

  • Cenarro Lagunas, Andrés Javier
  • Moles Villamate, Mariano
  • Cristóbal Hornillos, David
  • Rebassa Mansergas, Alberto
The Javalambre-Photometric Local Universe Survey (J-PLUS ) is an ongoing 12-band photometric optical survey, observing thousands of square degrees of the Northern hemisphere from the dedicated JAST/T80 telescope at the Observatorio Astrofísico de Javalambre (OAJ). T80Cam is a 2 deg2 field-of-view camera mounted on this 83 cm-diameter telescope, and is equipped with a unique system of filters spanning the entire optical range (3 500–10 000 Å). This filter system is a combination of broad, medium and narrow-band filters, optimally designed to extract the rest-frame spectral features (the 3 700–4 000 Å Balmer break region, Hd, Ca H+K, the G-band, the Mgb and Ca triplets) that are key to both characterize stellar types and to deliver a low-resolution photospectrum for each pixel of the sky observed. With a typical depth of AB ~ 21.25 mag per band, this filter set thus allows for an indiscriminate and accurate characterization of the stellar population in our Galaxy, it provides an unprecedented 2D photo-spectral information for all resolved galaxies in the local universe, as well as accurate photo-z estimates (at the ¿ z ~ 0.01–0.03 precision level) for moderately bright (up to r ~ 20 mag) extragalactic sources. While some narrow band filters are designed for the study of particular emission features ([OII]/¿3727, Ha/¿6563) up to z < 0.015, they also provide well-defined windows for the analysis of other emission lines at higher redshifts. As a result, J-PLUS has the potential to contribute to a wide range of fields in Astrophysics, both in the nearby universe (Milky Way structure, globular clusters, 2D IFU-like studies, stellar populations of nearby and moderate redshift galaxies, clusters of galaxies) and at high redshifts (emission line galaxies at z ˜ 0.77, 2.2 and 4.4, quasi stellar objects, etc). With this paper, we release ~36 deg2 of J-PLUS data, containing about 1.5 × 105 stars and 105 galaxies at r < 21 mag. These numbers are expected to rise to about 35 million of stars and 24 million of galaxies by the end of the survey, Peer Reviewed, Postprint (published version)