Skip to main content

XXX

MAT2014-59961-C2-1-R

•
Funding agency name Ministerio de Economía y Competitividad
Funding agency acronym MINECO
Program Programa Estatal de I+D+i Orientado a los Retos de la Sociedad
Call Proyectos I+D+i Retos de Investigación
Call year 2014
State Plan 2013-2016 Plan Estatal de Investigación Científica y Técnica y de Innovación
Management unit Secretaría de Estado de Educación, Formación Profesional y Universidades
Beneficiary centre FUNDACIO INSTITUT DE RECERCA DE L ENERGIA DE CATALUNYA

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Upscaling high activity oxygen evolution catalysts based on CoFe2O4 nanoparticles supported on nickel foam for power-to-gas electrochemical conversion with energy efficiencies above 80%

  • Urbain, Félix
  • Du, Ruifeng
  • Tang, Peng-Yi
  • Smirnov, Vladimir
  • Andreu, Teresa
  • Finger, Friedhelm
  • Divins, Núria J.
  • Llorca, Jordi
  • Arbiol, Jordi
  • Cabot, Andreu
  • Morante, Joan Ramón
We investigate cobalt ferrite nanoparticles (NPs) supported on large-scale electrodes as oxygen evolution reaction (OER) catalysts. Colloidal CoFe2O4 NPs were loaded on low-cost and high surface area nickel foam (NF) scaffolds. The coating process was optimized for large electrode areas, ensuring a proper distribution of the NPs on the NF that allowed overcoming the electrical conductivity limitations of oxide NPs. We were able to produce CoFe2O4-coated NFs having 10 cm2 geometric surface areas with overpotentials below 300 mV for the OER at a current density of 50 mA/cm2. Such impressively low overpotentials suggested using CoFe2O4 NP-based electrodes within a water electrolysis device. In this prototype device, stable operating currents up to 500 mA at remarkably low cell-voltages of 1.62 and 1.53 V, at ambient and 50 °C electrolyte temperatures, respectively, were reached during operation periods of up to 50 h. The high electrochemical energy efficiencies reached at 50 mA/cm2, 75% and 81% respectively, rendered these devices particularly appealing to be combined with low-cost photovoltaic systems for bias-free hydrogen production. Therefore, CoFe2O4 NP-based electrolysers were coupled to low-cost thin-film silicon solar cells with 13% efficiency to complete a system that afforded solar-to-fuel efficiencies above 10%., Authors acknowledge funding from Generalitat de Catalunya through the CERCA program, 2017 SGR 1246, 2017 SGR 327 and the Spanish MINECO projects MAT2014-59961, ENE2016-80788-C5-5-R, ENE2016-77798-C4-3-R and ENE2017-85087, together with the support from Repsol S. A. Likewise, the authors thank Enagás S.A. ICN2 is supported by the Severo Ochoa program from Spanish MINECO (Grant No. SEV-2017-0706). IREC also acknowledges additional support from the European Regional Development Funds (ERDF, FEDER), (S)TEM part of the present work has been performed in the framework of Universitat Autònoma de Barcelona Materials Science PhD program and the rest in the Nanoscience program of the University of Barcelona. The authors thank S. Moll (IEK-5), M. Biset-Peiró (IREC), and H. Xie (IREC) for their contribution to this work. F.U. acknowledges financial support from MINECO through Juan de la Cierva fellowship (FJCI-2016-29147).V.S. and F.F. (authors from IEK-5) thank the Deutsche Forschungsgemeinschaft (DFG) (Priority Program SPP 1613). J. Llorca is a Serra Húnter Fellow and is grateful to ICREA Academia program and funding from Generalitat de Catalunya 2017 SGR 128., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Enhanced hetero‐junction quality and performance of kesterite solar cells by aluminum hydroxide nanolayers and efficiency limitation revealed by atomic‐resolution scanning transmission electron microscopy

  • Xie, Haibing
  • Sánchez, Yudania
  • Tang, Peng-Yi
  • Espíndola‐Rodríguez, Moisés
  • Guc, Maxim
  • Calvo‐Barrio, Lorenzo
  • López-Marino, Simon
  • Liu, Yu
  • Morante, Joan Ramón
  • Cabot, Andreu
  • Izquierdo-Roca, Victor
  • Arbiol, Jordi
  • Pérez-Rodríguez, Alejandro
  • Saucedo, Edgardo
A strategy for interface engineering of hetero‐junctions in kesterite solar cells by using Al(OH)3 is demonstrated. The hydroxide nanolayers are prepared via a facile and fast wet chemical route, based on an aqueous solution of aluminum chlorides and thioacetamide. Considerable enhancement of open circuit voltage (Voc) (30–60 mV) and fill factor (FF) (10–20%) after this chemical treatment are observed, achieving a champion conversion efficiency of 9.1% and a champion FF of 70% (among the best FF in kesterite solar cells). The functional mechanism is systematically studied by current‐voltage, capacitance‐voltage, temperature dependence of current–voltage and photoluminescence measurements, which reveal that Al(OH)3 nanolayers can effectively reduce the interface recombination and largely improve the shunt resistance. Furthermore, atomic resolution high angle annular dark field scanning transmission electron microscopy (HAADF‐STEM) evidences the epitaxial relationship of Al(OH)3 with kesterite and CdS, indicating the benign and effective interface passivation achieved by this chemical treatment. Finally, based on HAADF‐STEM and electron energy loss spectroscopy mappings, insights into the efficiency limiting and beneficial factors for CZTSSe solar cells, as well as suggestions to further improve both the bulk and related interfaces are presented., The research leading to these results has received funding from Generalitat de Catalunya 2014SGR1638 and the Spanish MINECO (Ministerio de Economía y Competitividad de España) under the NASCENT (ENE2014‐56237‐C4‐1‐R), the TNT‐FUELS and e‐TNT (MAT2014‐59961) projects, funding from the Framework 7 program under the project KESTCELLS (FP7‐PEOPLE‐2012‐ITN‐316488) and European Regional Development Founds (ERDF, FEDER Programa Competitivitat de Catalunya 2007–2013). Authors from IREC and IN2UB belong to the M‐2E (Electronic Materials for Energy) Consolidated Research Group and the XaRMAE Network of Excellence on Materials for Energy of the “Generalitat de Catalunya”. H. Xie thanks the “China Scholarship Council” fellowship (CSC N° 201206340113), Y. S. the MINECO for the PTA fellowship (PTA2012‐7852‐A), and E.S. the “Ramon y Cajal” fellowship (RYC‐2011‐09212). ICN2 acknowledges support from the Severo Ochoa Program (MINECO, Grant SEV‐2013‐0295)., Peer reviewed