Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 7
Encontrada(s) 1 página(s)

Helvia. Repositorio Institucional de la Universidad de Córdoba
Publication Artículo científico (JournalArticle)

Diffusional Features of a Lithium-Sulfur Battery Exploiting Highly Microporous Activated Carbon

  • Luna Lama, Fernando
  • Marangon, Vittorio
  • Caballero, Álvaro
  • Morales, Julián
  • Hassoun, Jusef
Diffusion processes at the electrode/electrolyte interphase drives the performance of lithium-sulfur batteries, and activated carbon (AC) can remarkably vehicle ions and polysulfide species throughout the two-side liquid/solid region of the interphase. We reveal original findings such as the values of the diffusion coefficient at various states of charge of a Li−S battery using a highly porous AC, its notable dependence on the adopted techniques, and the correlation of the diffusion trend with the reaction mechanism. X-ray photoelectron spectroscopy (XPS) and X-ray energy dispersive spectroscopy (EDS) are used to identify in the carbon derived from bioresidues heteroatoms such as N, S, O and P, which can increase the polarity of the C framework. The transport properties are measured by cyclic voltammetry (CV), electrochemical impedance spectroscopy (EIS), and galvanostatic intermittent titration technique (GITT). The study reveals Li+-diffusion coefficient (DLi+) depending on the technique, and values correlated with the cell state of charge. EIS, CV, and GITT yield a DLi+ within 10−7–10−8 cm2 s−1, 10−8–10−9 cm2 s−1, and 10−6–10−12 cm2 s−1, respectively, dropping down at the fully discharged state and increasing upon charge. GITT allows the evaluation of DLi+ during the process and evidences the formation of low-conducting media upon discharge. The sulfur composite delivers in a Li-cell a specific capacity ranging from 1300 mAh g−1 at 0.1 C to 700 mAh g−1 at 2C with a S loading of 2 mg cm−2, and from 1000 to 800 mAh g−1 at 0.2C when the S loading is raised to 6 mg cm−2.
Helvia. Repositorio Institucional de la Universidad de Córdoba
Publication Artículo científico (JournalArticle)

Chlorine-assisted synthesis of Mn-deficient LiMn2O4 spinel with ultra-high-rate capability and long-term cyclability in half and full Li ion cells

  • Luna Lama, Fernando
  • Barbosa, Lucía
  • Tesio, Álvaro Y.
  • Caballero, Álvaro
  • Morales, Julián
A different route is proposed to reduce the Mn3+ content in LiMn2O4 spinel. Manganese ions are responsible for both the Jahn–Teller distortion and the dissolution of Mn in the electrolyte, the main causes of low cycling stability and limited rate capability. For this, Cl2 was used as an oxidising agent to promote partial oxidation of Mn3+ without destroying the spinel structure. The X-ray diffraction (XRD) pattern recorded with Mo Kα1 confirmed the formation of a spinel defective in Mn, with Li1.06Mn1.94O4 stoichiometry. The Mn vacancies were occupied by excess Li together with the presence of a layered Li2MnO3 phase as an impurity. Combining SEM images and EDX spectra, it was possible to differentiate both components as independent phases with different morphology. The spinel has a remarkable rate capability in the half-cell configuration from 1C to 50C, delivering an average capacity of 130 to 96 mA h g−1, respectively. Also, it has excellent cycling stability, as revealed by the capacity retention values, between 98–96% from 0.5 (500 cycles) to 10C (1000 cycles), maintaining high capacity values, from 138 to 127 mA h g−1, respectively. Furthermore, it can deliver high power, 26 196 W kg−1, with a high energy of 322 W h kg−1. To our knowledge, our spinel delivers the highest specific energy for lower power values reported so far. These excellent properties can be attributed to both its Mn deficiency, which decreases Mn3+, and the good transport properties obtained from CV and EIS techniques. The first, together with the high crystallinity and micrometric particle size, would mitigate the dissolution of Mn and enhance the structure stability. On the other hand, the high rates that the electrode supports can be ascribed to the high values of Li+ diffusion coefficient averaged to the different stages of the process, around 4 × 10−10 cm2 s−1. Spinel also provides satisfactory performance in full cells using MCMB as an anode and a positive/negative ratio close to 1 without the need for a prelithiation process. Thus, for power values of 10 567 W kg−1, it supplied an energy of 196 W h kg−1.
Helvia. Repositorio Institucional de la Universidad de Córdoba
Publication Artículo científico (JournalArticle)

Green biomass-derived hierarchically porous non-activated carbon from carob waste for high-performance lithium-sulfur batteries

  • Zoubir, Otmane
  • Lallaoui, Abdelfettah
  • Edfouf, Zineb
  • Caballero, Álvaro
  • Tesio, Álvaro Y.
To expedite the development of lithium-sulfur (Li–S) battery technology, it is necessary to address the inherent technological hurdles surrounding sulfur-based cathodes, including mitigating the shuttle effect and enhancing the electrical conductivity of sulfur. The use of biomass-derived carbonaceous materials offers a promising avenue to alleviate these challenges and help reduce the carbon footprint associated with battery technologies. Herein, we report the green synthesis of carob-derived carbonaceous material without additional physical/chemical activation steps, making the process sustainable, affordable, and eco-friendly. The obtained carob-derived carbon (CC) offers a hierarchical micro/meso/macroporous structure with a high surface area of 633 m2 g−1. The electrochemical performance with a sulfur content of 70% (CC@S70) in the composite and a sulfur mass loading of 1 mg cm−2 delivers an initial discharge capacity of 1405 mAh g−1, reducing to 798 mAh g−1 after 260 cycles. Increasing the sulfur content to 90% in the cathode (CC@S90) yields a high capacity in Li–S cells, reaching a discharge capacity of 937 mAh g−1 with a sulfur loading of 2 mg cm−2 at 0.3C (1C = 1675 mA g−1) after 100 cycles. The improved performance can be attributed to the well-preserved interconnected pores within the carbon material, serving as an efficient framework to accommodate high sulfur content.
Helvia. Repositorio Institucional de la Universidad de Córdoba
Publication Artículo científico (JournalArticle)

Understanding the role played by Cu nanoparticles embedded in situ in a carbonaceous matrix as sulfur host for lithium-sulfur batteries

  • Soler-Piña, Francisco Javier
  • Morales, Julián
  • Caballero, Álvaro
  • Rodríguez-Castellón, Enrique
Embargado hasta 10/12/2026, The lithium-sulfur (Li-S) battery is a promising alternative to Li-ion batteries as an energy storage system, owing to its higher capacity and specific energy values. To tackle its intrinsic problems, the element copper (Cu) is an attractive option given both its excellent conductivity and its ability to interact with highly reactive polysulfides. Here, we propose the use of a carbon/copper composite (90.5:9.5 wt ratio) obtained by thermal decomposition of a single precursor based on a Cu(II) oleate/oleic acid complex and eliminating the use of H2 as a reducing agent as commonly reported. Cu nanoparticles (mean particle size around 15 nm in diameter) which are highly dispersed on an amorphous carbon matrix derived from an organic framework, enhance both the conductivity and the ability for the chemical adsorption of lithium polysulfides (LiPSs), and thus increasing the reaction efficiency. Poor cycling stability, less specific capacity, and diminished rate capability were observed when the Cu content was reduced to around 70 % through treatment with concentrated nitric acid. This confirms the electrocatalytic role of the metal.
Helvia. Repositorio Institucional de la Universidad de Córdoba
Publication Artículo científico (JournalArticle)

Ethanol-derived graphene by microwave plasma torch as efficient cathode for Li-S batteries with ultralong cycle life

  • Blázquez-Moreno, Jesús M.
  • Morales Calero, Francisco Javier
  • Cobos-Luque, A.
  • Raya, A.M.
  • Rincón, Rocío
  • Benítez, Almudena
  • Caballero, Álvaro
High-quality graphene derived from ethanol (EdG) using an atmospheric pressure plasma torch has been used for the first time as a sulfur host for lithium-sulfur (Li-S) battery cathodes. Its excellent structural, morphological, and conductive properties make it a suitable material to accommodate sulfur inside its pores. In this way, the shuttle effect is effectively alleviated, reducing the loss of capacity, and improving the lifespan of Li-S batteries. EdG@S-based cathodes have demonstrated excellent performance for use in this technology, showing ultra-high stability, reaching 1000 cycles at very high rates of 3C and 5C, with minimal capacity loss (0.064 % and 0.045 % per cycle, respectively). In addition, a remarkable specific capacity of 256 mAh/g at ultra-high rates of up to 10C is achieved. Therefore, this study demonstrates that the use of ethanol-derived graphene synthesised by microwave plasma can be a viable option for the development, scalability, and industrialisation of Li-S battery technology.
Helvia. Repositorio Institucional de la Universidad de Córdoba
Publication Artículo científico (JournalArticle)

Dynamic polarization control unlocks long-life, high-efficiency Lithium-Sulfur batteries

  • González-Jiménez, José R.
  • Jiménez Romero, Francisco Javier
  • López Luna, Mª del Carmen
  • Bonilla, Álvaro
  • Caballero, Álvaro
Lithium‑sulfur (Lisingle bondS) batteries offer exceptional theoretical capacity and energy density but are hindered in practice by sluggish reaction kinetics and severe polarization effects. Here, we introduce a pioneering Polarization-Controlled Charging Protocol (PPC) that dynamically adjusts the charging current in real time by maintaining a constant polarization threshold. This strategy accelerates charging in kinetically favorable regimes while suppressing current in polarization-prone regions, thereby preserving electrode structure and extending cycle life. The PPC yields a linear voltage-time charging profile, enabling direct state-of-charge (SOC) estimation and accurate charging time prediction. Average long-term cycling demonstrates that PPC can double battery lifespan. Compared to constant-current charging (CC), PPC achieves over 800 stable cycles at selected C-rates, while CC leads to faster capacity fading. The found average Li diffusion coefficient in PPC is seven times higher than that of the CC conditions, supporting hasted reaction kinetics. Overall, PPC reduces degradation by ∼69 % under equivalent average kinetics conditions, and offers a non-chemical, kinetics-responsive strategy to enhance durability, efficiency, and control in Lisingle bondS batteries, with strong relevance for high-demand applications such as electric mobility.
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publication Artículo científico (JournalArticle)

Boosting Li-S batteries through the synergistic effect of recycled ferrites and external magnetic induction

  • Bonilla, Álvaro
  • Jiménez Blasco, Uxua
  • Gómez-Cámer, Juan Luis
  • Garayo Urabayen, Eneko
  • Pérez de Landazábal Berganzo, José Ignacio
  • Caballero, Álvaro
Despite being considered one of the most promising energy storage technologies, lithium-sulfur batteries (LSBs) are limited in terms of commercialization by the shuttle effect and slow reaction kinetics. In this work, we demonstrate for the first time that the use of recycled ferrite in conjunction with an external magnetic field generated by a permanent magnet can enhance the reaction kinetics and the adsorption of polysulfides (LiPSs), and hence the electrochemical stability. An in-depth kinetic study shows that under the effect of an external magnetic field, the electrode has lower polarization, a higher Li+ diffusion coefficient and a lower activation energy between electrochemical stages. The electrode also has a capacity retention up to 40 % higher and half the capacity loss per cycle at a high rate of 1C. At an ultra-high rate of 10C, the electrode has a capacity of 507 mAh g−1 after 150 cycles and an areal capacity of up to 3 mAh cm−2 at an ultra-high loading of 13 mg cm−2. In addition to the promising results observed in electrochemical terms, our approach is also more sustainable due to the use of a recycled electronic material obtained via dry milling, thereby avoiding the use of fossil carbons., This research was funded by Ministerio de Ciencia e Innovación MCIN/AEI/10.13039/501100011033 (Projects PID2020-113931RB-I00 & PID2023-147080OB-I00), European Union 'NextGenerationEU'/PRTR (Project PDC2021-120903-I00), Junta de Andalucía (FQM-175) and Navarra Government (project PC003-04 3D-MAGNET).