Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Modification of polyetherimide membranes with ZIFs fillers for CO2 separation

  • Vega, J.
  • Andrio, A.
  • Lemus, A.A.
  • Díaz, J.A.I.
  • del Castillo, L.F.
  • Gavara, Rafael
  • Compañ Moreno, Vicente|||0000-0001-8233-7472
[EN] Flat hybrid membranes composed of polyetherimide (PEI) as matrix and zeolitic imidazolate frameworks (ZIFs) as fillers at concentrations of 10 and 20 wt% were prepared. Apparent permeability coefficient and apparent diffusivity coefficient of gases (CO2 and N-2) for these hybrid membranes (PZIFs) were determined by the "timelag" method. The experimental conditions used were from 25 degrees C to 55 degrees C with pressures of 2, 3 and 5 bar. The PZIFs with fillers of ZIF-8 (PZ-Zn) and ZIF-67 (PZ-Co) showed apparent selectivities (alpha(pa(CO2)/pa(N2))) of 39.6 and 27.5, respectively, higher than the alpha(pa(CO2)/pa(N2)) of the reference membrane PEI, while the membrane with filler of ZIF-Mix (PZ-Zn/Co) showed the lowest alpha(pa(CO2)()/pa(N2)) selectivity of 10.3 in the membrane series (under conditions of 25 degrees C and 2 bar). It is proposed that the selectivity of the membrane series can be attributed to two critical factors: the particle size/distribution ratio in the polymer base and sorption of CO2 at local sites of the bimetallic mixture. On the other hand, gas permeation studies (O-2, CO2 and CH4, and CO2/CH(4 )and CO2/C2H4 mixtures), were carried out in the series of PZIFs membranes. Permeability data were obtained by an isostatic method based on a permeation cell connected in series to a gas chromatograph where the rate of permeated gases was analyzed until a stationary state was reached. The complementary characterization techniques were: scanning electron microscopy, thermogravimetric analysis, and powder X-ray diffraction, which support the existence of the amorphous/crystalline phases of the PZIFs., This research has been supported by the ENE/2015-69203-R project, granted by the Ministerio de Economia y Competitividad (MINECO), Spain; Also authors are grateful to UNAM-DGAPA-PAPIIT projects IG-100185, and IG-114818. This study was partially supported by the CONACyT (Mexico) projects 2013-05-231461 and CB -2014-01-235840.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

High proton conductivity at low and moderate temperature in a simple family of Prussian blue analogs, divalent transition metal hexacyanocobaltates (III)

  • Vega-Moreno, J.
  • Lemus-Santana, A.A.
  • Reguera, E.
  • Andrio, A.
  • Compañ Moreno, Vicente|||0000-0001-8233-7472
[EN] Proton conductivity behavior was studied in a family of hexacyanocobaltates with divalent transition metals (II), HCCMs. The HCCMs, with molecular formula M3[Co(CN)6]2-xH2O (where M = Ni, Co, Fe, Mn and Cd), had cubic crystal structures and similar cell parameters. The number of water molecules per formula unit (x) present in each HCCMs was determined from thermogravimetric analysis data. Differences in conductivity values were evaluated by running dielectric impedance experiments. The values of the permittivity and conductivity real and imaginary parts were obtained for each material. The actual conductivity part was analyzed as a temperature and frequency function. Mobilities, diffusivities, and ion charge densities were derived from the electrode polarization model that appropriately fits the loss tangent curves. The measurement conditions for all the samples were relative humidity of 99% and temperature ranging from 25 to 105 °C. The conductivity values obtained for the HCCMs varied from 10-4 to 10-2 S cm-1. At low temperatures, proton conductivity values for the nickel hexacyanocobaltate (HCCNi) stood out (from 10 -3 and 10-2 S cm-1, at 25 and 45°C, respectively), followed by Fe, Cd, Co and Mn. In addition to the results stated above, activation energies were determined using the Arrhenius model, where the obtained values were below 21.1 kJ mol-1. The proton transport activation energies suggest that the transport through the HCCM porous framework was achieved by the Grotthuss mechanism. The diffusivity in the porous framework increased with temperature for all the samples except for HCCNi, following the trend DHCCFe > DHCCMn> DHCCCo> DHCCCd. The variability observed between the samples could be related to the ion-binding energies (Eb). These results indicate that hexacyanocobaltates can be useful as mixed matrix membrane (MMM) fillers, providing excellent conductivity and diffusivity when the medium contains a sufficient amount of ionic components depending on the involved transition metal., This research has been supported by the ENE/2015-69203-R project, granted by the Ministerio de Economía y Competitividad (MINECO), Spain, also authors are grateful to UNAM-DGAPA-PAPIIT projects IG-100185, and IG-114818. This study was partially supported by the CONACyT (Mexico) projects 2013-05-231461 and CB-2014-01-235840. The authors appreciate the access to the experimental facility of the National Laboratory for Energy Conversion and Storage (CONACyT) to carry out the experimental study. The authors thank S. Vega from Mexican Institute of Petroleum (IMP) for reviewing and improving the English language of this work.