Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Comparison of the Diffusive Flame Structure for Dodecane and OMEX Fuels for Conditions of Spray A of the ECN

  • Pastor, José V.|||0000-0003-4113-4681
  • García-Oliver, José M|||0000-0002-2676-9681
  • Micó, Carlos|||0000-0001-5787-6212
  • Tejada-Magraner, Francisco José|||0000-0001-6851-5084
[EN] A comparison of the flame structure for two different fuels, dodecane and oxymethylene dimethyl ether (OMEX), has been performed under condition of Spray A of the Engine Combustion Network (ECN). The experiments were carried out in a constant pressure vessel with wide optical access, at high pressure and temperature and controlled oxygen concentration. The flame structure analysis has been performed by measuring the formaldehyde and OH radical distributions using planar Laser-Induced Fluorescence (PLIF) techniques. To complement the analysis, this information was combined with that obtained with high-speed imaging of OH* chemiluminescence radiation in the UV. Formaldehyde molecules are excited with the 355-nm radiation from the third harmonic of a Nd:YAG laser, whilst OH is excited with a wavelength of 281.00-nm from a dye laser. In both cases, the beam was transformed into a laser sheet in order to excite an axial flame plane and the fluorescence radiation was collected with an intensified camera (ICCD) and proper filtering. Consequently, two-dimensional maps in the axial flame plane were obtained at different instants after the start of injection (ASOI). Signal from both formaldehyde and OH chemical species can be compared, in order to analyze spatial distribution and interaction. When dodecane and OMEX are compared, several differences arise. The second one presents larger lift-off length but remarkably shorter flame length. Additionally, it has been possible to appreciate for this fuel a lower amount of soot formation during combustion., The research leading to these results has received funding from the European Union's Horizon 2020 Programme, grant agreement n° 828947, and from the Mexican Department of Energy, CONACYT-SENER Hidrocarburos grant agreement n° B-S-69926.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Conductivity of composite membrane-based poly(ether-ether-ketone) sulfonated (SPEEK) nanofiber mats of varying thickness

  • Reyes, J.L
  • Solorza-Feria, Omar
  • García Bernabé, Abel
  • Sahuquillo, Oscar
  • Giménez Torres, Enrique|||0000-0002-6330-0209
  • Compañ Moreno, Vicente|||0000-0001-8233-7472
Nanofiber mats of SPEEK70wt%-PVB30 wt% (polyvinyl butyral)-based composite membranes were prepared by varying the electrospinning time in order to obtain mats with different thicknesses. These mats were embedded in SPEEK65wt%-PVA(35wt%) (polyvinyl alcohol) polymer solution to fill the pores in the fibers. The obtained membranes with different mat thicknesses have been characterized by water uptake, ionic exchange capacity, scanning electron microscopy, mechanical properties and proton conductivity. Microtensile test studies reveal that the maximum tensile strength increases as the thickness of the SPEEK-PVB nanofiber mats increases, resulting in more flexible composite membranes compared to a pure SPEEK-PVA membrane obtained by casting. The proton conductivity occurs more easily through the nanofiber than through the matrix phase, and the best conductivity (0.038 S cm(-1)) was measured at 120 degrees C for the composite membrane of SPEEK-PVB nanofiber mats obtained after 12 hours of electrospinning time. This value suggests that our composite membranes have high potential to function in the temperature range between 100 and 140 degrees C without losing their strength and while maintaining their high proton conductivity, making them an excellent candidate for fuel cells that operate at intermediate temperatures., This research has been supported by the ENE/2011-24761 project, granted by the Ministerio de Economia y Competitividad (MINECO), Spain, and grants from CONACYT-SENER-SUSTENTABILIDAD ENERGETICA 2014-02-245920 through Centro de Investigacion y de Estudios Avanzados del Instituto Politecnico Nacional (CINVESTAV), Mexico. Jose Luis Reyes-Rodriguez thanks CONACYT Program for a fellowship at the Universidad Politecnica de Valencia (UPV).