Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

Dipòsit Digital de Documents de la UAB
Publication Artículo científico (JournalArticle)

An analytical method to implement high-sensitivity transmission line differential sensors for dielectric constant measurements

  • Muñoz Enano, Jonathan|||0000-0003-1271-3801
  • Vélez, Paris|||0000-0001-6502-5987
  • Gil Barba, Marta|||0000-0002-1106-5059
  • Martín, Ferran|||0000-0002-1494-9167
A simple analytical method useful to optimize the sensitivity in differential sensors based on a pair of meandered microstrip lines is presented in this paper. Sensing is based on the phase difference of the transmission coefficients of both lines, when such lines are asymmetrically loaded. The analysis provides the combination of operating frequency and line length (the main design parameters) that are necessary to obtain the maximum possible differential phase (±180°) for a given level of the differential dielectric constant (input dynamic range). The proposed sensor is useful to detect tiny defects of a sample under test (SUT) as compared to a reference (REF) sample. It can also be applied to the measurement of the complex dielectric constant of the SUT, where the real part is inferred from the differential phase, whereas the imaginary part, or the loss tangent, is derived from the modulus of the transmission coefficient of the line loaded with the SUT. It is experimentally demonstrated that the proposed device is able to detect the presence of few and small (purposely generated) defects in a commercial microwave substrate, as well as subtle variations in their density, pointing out the high achieved sensor sensitivity. Sensor validation is also carried out by determining the dielectric constant and loss tangent of commercial microwave substrates.
Dipòsit Digital de Documents de la UAB
Publication Artículo científico (JournalArticle)

Signal balancing in unbalanced transmission lines

  • Muñoz Enano, Jonathan|||0000-0003-1271-3801
  • Vélez, Paris|||0000-0001-6502-5987
  • Martín, Ferran|||0000-0002-1494-9167
Balanced lines operating as transmission line interconnects are subjected to differential-mode to common-mode conversion (and vice versa) in situations where symmetry imbalances (e.g., caused by line bends) are unavoidable. In this paper, a technique to compensate for such symmetry imbalances, providing pure differential-mode signals at the differential output port of the line, is presented. Such technique uses a rat-race balun (to generate the differential-mode signal) with the isolated port conveniently loaded, and it is based on the modification of the characteristic impedance of one of the unbalanced lines. A detailed analysis that justifies this compensation technique (valid for any arbitrary four-port network) and provides the design equations is presented. The approach is validated through simulation and experiment, by demonstrating that common-mode signals are not transmitted to the differential output port of a bended (i.e., unbalanced) line pair.