Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

In-flame soot quantification of diesel sprays under sooting/non-sooting critical conditions in an optical engine

  • Xuan, Tiemin
  • He, Zhixia
  • Wang, Qian
  • Reyes, Miriam
  • Pastor, José V.|||0000-0003-4113-4681
  • García-Oliver, José M|||0000-0002-2676-9681
  • García Martínez, Antonio|||0000-0001-5783-4936
[EN] Because of the challenge of meeting stringent emissions regulations for internal combustion engines, some advanced low temperature combustion modes have been raised in recent decades to improve combustion efficiency. Therefore, detailed understanding and capability for accurate prediction of in-flame soot processes under such low sooting conditions are becoming necessary. Nowadays, a lot of investigations have been carried out to quantify in-flame soot in Diesel sprays under high sooting conditions by means of different optical techniques. However, no information of soot quantification can be found for sooting/non-sooting critical conditions. In current study, the instantaneous soot production in a two-stroke optical engine under low sooting conditions has been measured by means of a Diffused back-illumination extinction technique (DBI) and two-color method (2C) simultaneously. The fuels used were n-dodecane and n-heptane, which have been injected separately though two different injectors equipped with single-hole nozzles. A large cycle-to-cycle variation on soot production can be observed under such operating conditions, however the in-cylinder heat release traces were quite repeatable. It is the same with the well-known trends of soot amount to operating conditions that the probability of sooting cycles increases with higher ambient temperature, higher ambient density and lower injection pressure. Both techniques present a pretty good agreement on soot amount when the peak of KL value is close to 1. However, the KL value of two-color method becomes bigger than that of DBI and the difference increases with lower sooting conditions., This study was partially funded by the Natural Science Foundation of China (No. 51876083), China Postdoctoral Science Foundation (2018M642176) and High-tech Research Key laboratory of Zhenjiang (SS2018002)
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Soot temperature characterization of spray a flames by combined extinction and radiation methodology

  • Xuan, Tiemin
  • Desantes J.M.|||0000-0002-4124-9393
  • Pastor, José V.|||0000-0003-4113-4681
  • García-Oliver, José M|||0000-0002-2676-9681
[EN] Even though different optical techniques have been applied on 'Spray A' in-flame soot quantification within Engine Combustion Network in recent years, little information can be found for soot temperature measurement. In this study, a combined extinction and radiation methodology has been developed with different wavelengths and applied on quasi-steady Diesel flame to obtain the soot amount and temperature distribution simultaneously by considering self-absorption issues. All the measurements were conducted in a constant pressure combustion chamber. The fuel as well as the operating conditions and the injector used were chosen following the guidelines of the Engine Combustion Network. Uncertainty caused by wavelength selection was evaluated. Additionally, temperature-equivalence ratio maps were constructed by combining the measurements with a 1D spray model. Temperature fields during the quasi-steady combustion phase show peak temperatures around the limit of the radiation field, in agreement with a typical diffusion flame structure. Effects of different operating parameters on soot formation and temperature were investigated. Soot temperature increases dramatically with oxygen concentration, but it shows much less sensitivity with ambient temperature and injection pressure, which on the other hand have significant effects on soot production. (C) 2019 The Combustion Institute. Published by Elsevier Inc. All rights reserved., This study was partially funded by the Ministerio de Economia y Competitividad from Spain in the frame of the CHEST Project (TRA2017-89139-C2-1-R) and China Postdoctoral Science Foundation (2018M642176). This study was also partially supported by State Key Laboratory of Engines, Tianjin University.