Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 9
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication

Dysprosium removal from water using active carbons obtained from spent coffee ground

  • Alcaraz, Lorena
  • Escudero, Esther
  • Alguacil, Francisco José
  • Llorente, Irene
  • Urbieta, Ana
  • Fernández, Paloma
  • López Gómez, Félix Antonio
This paper describes the physicochemical study of the adsorption of dysprosium (Dy3+) in aqueous solution onto two types of activated carbons synthesized from spent coffee ground. Potassium hydroxide (KOH)-activated carbon is a microporous material with a specific Brunauer–Emmett–Teller (BET) surface area of 2330 m2·g−1 and pores with a diameter of 3.2 nm. Carbon activated with water vapor and N2 is a solid mesoporous, with pores of 5.7 nm in diameter and a specific surface of 982 m2·g−1. A significant dependence of the adsorption capacity on the solution pH was found, but it does not significantly depend on the dysprosium concentration nor on the temperature. A maximum adsorption capacity of 31.26 mg·g−1 and 33.52 mg·g−1 for the chemically and physically activated carbons, respectively, were found. In both cases, the results obtained from adsorption isotherms and kinetic study were better a fit to the Langmuir model and pseudo-second-order kinetics. In addition, thermodynamic results indicate that dysprosium adsorption onto both activated carbons is an exothermic, spontaneous, and favorable process., This project has received funding from the European Union’s Horizon 2020 research and innovation program under grant agreement No 776851 (carEService).
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Oxidized and Non-Oxidized Multiwalled Carbon Nanotubes as Materials for Adsorption of Lanthanum(III) Aqueous Solutions

  • Alguacil, Francisco José
  • García-Díaz, Irene
  • Escudero, Esther
  • Rodríguez-Largo, Olga
  • López Gómez, Félix Antonio
© 2020 by the authors., The behavior of oxidized and non-oxidized multiwalled carbon nanotubes (MWCNTs) in the adsorption of lanthanum(III) from aqueous solutions is described. Metal uptake is studied as a function of several variables such as the stirring speed of the system, pH of the aqueous solution and metal and nanomaterial concentrations. The experimental results are fitted to various kinetic and isotherm models, the rate law being fitted to the film diffusion and particle diffusion models, when the non-oxidized and the oxidized nanomaterials are used to remove lanthanum from the solution, respectively. Sulfuric acid solutions seem to be appropriate to recover the metal from La-loaded nanomaterials., This research has received funding from the European Union’s Horizon 2020 research and innovation program under grant agreement No. 776851 (CarEService)., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

On the Adsorption of Cerium(III) Using Multiwalled Carbon Nanotubes

  • Alguacil, Francisco José
  • García-Díaz, Irene
  • Escudero, Esther
  • Rodríguez-Largo, Olga
  • López Gómez, Félix Antonio
© 2020 by the authors., Commercially available oxidized (carboxylic groups) and nonoxidized multiwalled carbon nanotubes were studied as adsorbents of cerium(III) in batch operation mode. Several variables affecting the rare earth adsorption were investigated, including: the stirring speed applied to the system, the pH of the solution, and the metal concentration and carbon dosages. Although the removal of cerium from the solution is different and dependent upon the adsorbent type—(i) adsorption in nonoxidized multiwalled carbon nanotubes, (ii) cation exchange in the case of using oxidized multiwalled carbon nanotubes—the adsorption kinetics, the rate law and the isotherm models are the same for both adsorbents: pseudo-second order, film diffusion, and Langmuir Type-1, respectively. Cerium is desorbed from loaded adsorbents using acidic solutions., This research has received funding from the European Union’s Horizon 2020 research and innovation program under grant agreement No 776851 (CarEService)., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Characterization of K6Ta10.8O30 Microrods with Tetragonal Tungsten Bronze-Like Structure Obtained from Tailings from the Penouta Sn-Ta-Nb Deposit

  • Sotillo, Belén
  • Alcaraz, Lorena
  • López Gómez, Félix Antonio
  • Fernández, Paloma
© 2020 by the authors., In this work, a deep characterization of the properties of K6Ta10.8O30 microrods has been performed. The starting material used to grow the microrods has been recovered from mining tailings coming from the Penouta Sn-Ta-Nb deposit, located in the north of Spain. The recovered material has been submitted to a thermal treatment to grow the microrods. Then, they have been characterized by scanning electron microscopy, X-ray diffraction, micro-Raman and micro-photoluminescence. The results of our study confirm that the K6Ta10.8O30 microrods have a tetragonal tungsten bronze-like crystal structure, which can be useful for ion-batteries and photocatalysis., The authors are grateful to the Complutense University of Madrid and Banco Santander for support via the project UCM-Santander 2019 (PR87/19-22613), the Spanish Ministry of Science, Innovation and Universities for support via the projects ESTANNIO (RTC-2017-6629-5) and MINECO/FEDER-MAT2015-65274-R. This project has received funding from the European Union’s Horizon 2020 research and innovation program under grant agreement No 776851 (carEService). B. Sotillo acknowledges financial support from Comunidad de Madrid and Complutense University of Madrid (Ayudas del Programa de Atracción de Talento 2017-T2/IND-5465, and Proyectos de I+D para jóvenes doctores PR65/19-22464). We also acknowledge support of the publication fee by the CSIC Open Access Publication Support Initiative through its Unit of Information Resources for Research (URICI)., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Application of a Low-Cost Cellulose-Based Bioadsorbent for the Effective Recovery of Terbium Ions from Aqueous Solutions

  • Alcaraz, Lorena
  • Saquinga, Dayana Nathaly
  • López, Floralba
  • Lima, Lola De
  • Alguacil, Francisco José
  • Escudero, Esther
  • López Gómez, Félix Antonio
© 2020 by the authors., The preparation of a low-cost cellulose-based bioadsorbent from cellulosic material extracted from rose stems (CRS) was carried out; rose stems are considered agricultural waste. After the required pretreatment of this waste and further treatment with an acidic mixture of acetic and nitric acids, the CRS product was produced. The resulting bioadsorbent was characterized by several techniques, such as X-ray diffraction, which revealed diffraction maxima related to the cellulose structure, whose calculated crystallinity index (CrI) was 75%. In addition, Fourier Transform Infrared spectroscopy (FTIR), 13C Nuclear Magnetic Resonance (NMR), and X-ray Photoelectron Spectroscopy (XPS) showed signs of acetylation of the sample. The thermal properties of the solid were also evaluated through Thermogravimetric Analysis (TGA). Scanning Electron Microscopy (SEM) showed cellulose fibers before and after the adsorption process, and some particles with irregular shapes were also observed. The CRS bioadsorbent was used for the effective adsorption of valuable Tb(III) from an aqueous solution. The adsorption data showed a good fit to the Freundlich isotherm and pseudo-second-order kinetic models; however, chemisorption was not ruled out. Finally, desorption experiments revealed the recovery of terbium ions with an efficiency of 97% from the terbium-loaded bioadsorbent., This research has received funding from the European Union’s Horizon 2020 research and innovation program under Grant No. 776851 (Car-E Service)., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Application of activated carbon obtained from spent coffee ground wastes to effective terbium recovery from liquid solutions

  • Alcaraz, Lorena
  • Saquinga, Dayana Nathaly
  • Alguacil, Francisco José
  • Escudero, Esther
  • López Gómez, Félix Antonio
A process aimed at the recovery of terbium from liquid solutions using activated carbon (AC) derived from spent coffee grounds (SCG) was assessed. AC was obtained using the hydro-alcoholic treatment of SCG, followed by the physical activation of the as‐obtained product. The AC exhibited both microporous and mesoporous structures, which were shown by the corresponding nitrogen adsorption–desorption isotherms and scanning electron microscopy (SEM) images. In ad-dition, a certain graphitic character was found in the micro‐Raman measurements. By use of this AC, terbium adsorption was investigated, and the influence of solution pH, temperature, and the adsorbent amount on terbium uptake was tested. In addition, adsorption isotherms and kinetic studies were also evaluated. The best fit was found for the type‐1 Langmuir isotherm and pseudo-second‐order kinetics model. Thermodynamic studies revealed that terbium adsorption is an endo-thermic and spontaneous process. Terbium desorption by the use of acidic solutions was also in-vestigated. This work demonstrated that it is possible to recover this valuable metal from liquid solution using the present AC., This research has received funding from the European Union’s Horizon 2020 research and innovation program under Grant No. 776851 (Car-E Service). We acknowledge the support for the publication fee from the CSIC Open Access Publication Support Initiative through its Unit of Information Resources for Research (URICI).
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Characterization of Nb22O54 microrods grown from niobium oxide powders recovered from mine tailings

  • Sotillo, Belén
  • López Gómez, Félix Antonio
  • Alcaraz, Lorena
  • Fernández, Paloma
In this work, the possibility of using niobium oxide recovered from tailings from the Penouta Sn–Nb–Ta deposit (located at the North of Spain) as starting material for growing microstructures is demonstrated. The properties of the starting material have been studied to understand its crystal structure, quality and purity. Recovered niobium oxide powders are mainly of TT-NbO. These powders have been used to grow NbO microrods by an evaporation method in an argon atmosphere. Different characterization techniques (X-Ray diffraction, scanning electron microscopy, micro-Raman spectroscopy, luminescence) have been used to determine the properties of NbO microrods, mainly focusing on the crystal quality and refractive index. The present study opens the way to the transformation of waste (mine tailings) into a material of high technological value as niobium oxide, and its reintroduction into the value chain for a wide range of applications, from coatings to batteries and supercapacitors., The authors are grateful to the Spanish Ministry of Science, Innovation and Universities for support via the projects ESTANNIO (RTC-2017-6629-5) and MINECO/FEDER-MAT2015-65274-R. This project has received funding from the European Union's Horizon 2020 research and innovation program under grant agreement No 776851 (carEService). B. Sotillo acknowledges financial support from Comunidad de Madrid (Ayudas del Programa de Atracción de Talento 2017-T2/IND-5465).
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Obtaining and Characterization of Highly Crystalline Recycled Graphites from Different Types of Spent Batteries

  • Alcaraz, Lorena
  • Díaz-Guerra, Carlos
  • Calbet, Joaquín
  • Lopez, María Luisa
  • López Gómez, Félix Antonio
Spent batteries recycling is an important way to obtain low-cost graphite. Nevertheless, the obtaining of crystalline graphite with a rather low density of defects is required for many applications. In the present work, high-quality graphites have been obtained from different kinds of spent batteries. Black masses from spent alkaline batteries (batteries black masses, BBM), and lithium-ion batteries from smartphones (smartphone black masses, SBM) and electric and/or hybrid vehicles (lithium-ion black masses, LBM) were used as starting materials. A hydrometallurgical process was then used to obtain recycled graphites by acidic leaching. Different leaching conditions were used depending on the type of the initial black mass. The final solids were characterized by a wide set of complementary techniques. The performance as Li ion batteries anode of the sample with better structural quality was assessed., This work has been funded by the European Union′s Horizon 2020 research and innovation program under grant agreement No 776851 (CarE Service), the Spanish Ministry of Economy and Competitiveness (MINECO) under project MAT2017-84118-C2-2-R and by Banco Santander-UCM through project PR87/19-22613.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Study of the Carbochlorination Process with CaCl2 and Water Leaching for the Extraction of Lithium from Spent Lithium-Ion Batteries

  • Gonzalez Peña, Yarivith Carolina
  • Romo, Alcaraz
  • Alcaraz, Lorena
  • Alguacil, Francisco José
  • González, Jorge
  • Barbosa, Lucía
  • López Gómez, Félix Antonio
This work was funded by the European Union’s Horizon 2020 research under grant agreement No 776851 (Car-E Service)., Peer reviewed