e-Archivo. Repositorio Institucional de la Universidad Carlos III de Madrid
Publication
Artículo científico (JournalArticle)
Single plane illumination microscopy for microfluidic device imaging
This article belongs to the Special Issue Microfluidics for Detection and Analysis., Three-dimensional imaging of live processes at a cellular level is a challenging task. It requires high-speed acquisition capabilities, low phototoxicity, and low mechanical disturbances. Three-dimensional imaging in microfluidic devices poses additional challenges as a deep penetration of the light source is required, along with a stationary setting, so the flows are not perturbed. Different types of fluorescence microscopy techniques have been used to address these limitations; particularly, confocal microscopy and light sheet fluorescence microscopy (LSFM). This manuscript proposes a novel architecture of a type of LSFM, single-plane illumination microscopy (SPIM). This custom-made microscope includes two mirror galvanometers to scan the sample vertically and reduce shadowing artifacts while avoiding unnecessary movement. In addition, two electro-tunable lenses fine-tune the focus position and reduce the scattering caused by the microfluidic devices. The microscope has been fully set up and characterized, achieving a resolution of 1.50 μ
m in the x-y plane and 7.93 μ
m in the z-direction. The proposed architecture has risen to the challenges posed when imaging microfluidic devices and live processes, as it can successfully acquire 3D volumetric images together with time-lapse recordings, and it is thus a suitable microscopic technique for live tracking miniaturized tissue and disease models., This work was partially supported by Ministerio de Ciencia, Innovación y Universidades, Agencia Estatal de Investigación, under Grants TEC2016-78052 (A.M.-B.) and PID2019-109820RB-I00 (A.M.-B.), MCIN/AEI/10.13039/501100011033/, co-finance by European Regional Development Fund (ERDF), "A way of making Europe." CGC acknowledges support from the Ministerio de Ciencia, Innovacion y Universidades, Spain (FPU20/01459). JR acknowledges funding from Ministerio de Economía y Competitividad (FIS2020-115088RB-I00) and Horizon 2020 Framework Programme (801347-SENSITIVE).
Project:
EC / H2020 801347