Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Contribución de congreso (ConferenceOutput)

BAFFI: a bit-accurate fault injector for improved dependability assessment of FPGA prototypes

  • Tuzov, Ilya|||0000-0002-1980-0708
  • de-Andrés-Martínez, David|||0000-0002-4744-3795
  • Ruiz, Juan Carlos|||0000-0001-7678-3513
  • Hernández Luz, Carles|||0000-0003-1192-6223
[EN] FPGA-based fault injection (FFI) is an indispensable technique for verification and dependability assessment of FPGA designs and prototypes. Existing FFI tools make use of Xilinx essential bits technology to locate the relevant fault targets in FPGA configuration memory (CM). Most FFI tools treat essential bits as black-box, while few of them are able to filter essential bits on the area basis in order to selectively target design components contained within the predefined Pblocks. This approach, however, remains insufficiently precise since the granularity of Pblocks in practice does not reach the smallest design components. This paper proposes an open-source FFI tool that enables much more fine-grained FFI experiments for Xilinx 7-series and Ultrascale+ FPGAs. By mapping the essential bits with the hierarchical netlist, it allows to precisely target any component in the design tree, up to an individual LUT or register, without the need for defining Pblocks (floorplanning). With minimal experimental effort it estimates the contribution of each DUT component into the resulting dependability features, and discovers weak points of the DUT. Through case studies we show how the proposed tool can be applied to different kinds of DUTs: from small-footprint microcontrollers, up to multicore RISC-V SoC. The correctness of FFI results is validated by means of RT-level and gate-level simulation-based fault injection., This work has received funding from (i) ECSEL Joint Undertaking (JU) under grant agreement No 877056, (ii) Agencia Estatal de Investigacion from Spain under grant agreement no. PCI2020-112092, (iii) European Unions Horizon 2020 research and innovation programme under grant agreement no. 871467, and (iv) Grant PID2020-120271RB-I00 funded by MCIN/AEI/ 10.13039/501100011033. Carles Hernandez is partially supported by Spanish Ministry of Science, Innovation and Universities under Ramon y Cajal, fellowship No. RYC2020-030685-I.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Contribución de congreso (ConferenceOutput)

Improving the Robustness of Redundant Execution with Register File Randomization

  • Tuzov, Ilya|||0000-0002-1980-0708
  • Andreu-Cerezo, Pablo|||0000-0003-2070-9271
  • L. Medina-Chaveli|||0000-0001-5954-0261
  • López Rodríguez, Pedro Juan|||0000-0003-4544-955X
  • Flich Cardo, José
  • Hernández Luz, Carles|||0000-0003-1192-6223
  • Picornell-Sanjuan, Tomás
  • Robles Martínez, Antonio
[EN] Staggered Redundant execution (SRE) is a fault-tolerance mechanism that has been widely deployed in the context of safety-critical applications. SRE not only protects the system in the presence of faults but also helps relaxing safety requirements of individual elements. However, in this paper, we show that SRE does not effectively protect the system against a wide range of faults and thus, new mechanisms to increase the diversity of homogeneous cores are needed. In this paper, we propose Register File Randomization (RFR), a low-cost diversity mechanism that significantly increases the robustness of homogeneous multicores in front of common-cause faults (CCFs) and register file wearout. Our results show that RFR completely removes the failure rate for register file CCFs for certain workloads and reduces by a factor of 5X the impact of stress related register file aging for the workloads analysed. Our implementation requires less than 50 RTL lines of code and the area (FPGA logic) overhead of RFR is less than 0.2% of a 64-bit RISC-V core FPGA implementation., This work has received funding from the ECSEL Joint Undertaking (JU) under grant agreement No 877056 and the Agencia Estatal de Investigacion from Spain under grant agreement no. PCI2020-112092, and from the the European Unions Horizon 2020 research and innovation programme under grant agreement no. 871467.
UPCommons. Portal del coneixement obert de la UPC
Publication Contribución de congreso (ConferenceOutput)

Unboxing the sand: on deploying safety measures in the programmable logic of COTS MPSoCs

  • Alcaide Portet, Sergi|||0000-0001-8561-7795
  • Cabo Pitarch, Guillem
  • Bas Jalón, Francisco
  • Benedicte Illescas, Pedro|||0000-0003-1670-7783
  • Mazzocchetti, Fabio
  • Cazorla Almeida, Francisco Javier
  • Abella Ferrer, Jaume|||0000-0001-7951-4028
The lack of sufficient hardware support for functional safety precludes the full adoption of many Commercial Off-the-Shelf (COTS) MPSoCs in safety-related systems, such as those in the aerospace industry. Some recent MPSoCs come along with programmable logic (PL), primarily intended to offload some specific complex functions that can be much more efficiently implemented in hardware than in software, hence being such PL a kind-of-sandbox fully mastered by ASIC cores outside the PL. This paper proposes using PL in those COTS MPSoCs to deploy the support needed to implement safety measures efficiently to enable the use of those MPSoCs for systems needing high assurance levels. Hence, the goal is not mastering PL from the cores solely, but also allowing PL to provide monitoring (e.g. contention, diversity, watchdogs) and control (e.g. configuring QoS features) capabilities to enable the realization of a safety concept atop. The early work presented in this paper already provides specific monitoring, diversity, and controlling strategies to allow PL take over safety-related functionalities., This work is part of the project PCI2020-112010, funded by MCIN/AEI/10.13039/501100011033 and the European Union “NextGenerationEU”/PRTR, and the European Union’s Horizon 2020 Programme under project ECSEL Joint Undertaking (JU) under grant agreement No 877056. This work has also been partially supported by the Spanish Ministry of Science and Innovation under grant PID2019-107255GBC21 funded by MCIN/AEI/10.13039/501100011033., Peer Reviewed
UPCommons. Portal del coneixement obert de la UPC
Publication Contribución de congreso (ConferenceOutput)

Security, reliability and test aspects of the RISC-V ecosystem

  • Abella Ferrer, Jaume|||0000-0001-7951-4028
  • Alcaide Portet, Sergi|||0000-0001-8561-7795
  • Anders, Jens
  • Bas Jalón, Francisco
  • Becker, Steffen
  • De Mulder, Elke
  • Elhamawy, Nourhan
  • Gürkaynak, Frank K.
  • Handschuh, Helena
  • Hernández Luz, Carles
  • Hutter, Mike
  • Kosmidis, Leonidas
  • Polian, Ilia
  • Sauer, Matthias
  • Wagner, Stefan
  • Regazzoni, Francesco
RISC-V has emerged as a viable solution on academia and industry. However, to use open source hardware for safety-critical applications, we need a deep understanding of the way in which well established mechanisms for testing and reliability could be integrated and deployed on the RISCV ecosystem, and we need a clear knowledge on how such an ecosystem can be leveraged to improve security. This paper includes four contributions presenting the potential of RISC-V in security research, the way in which RISC-V can be hardened against power analysis attacks, how to implement, using RISCV, software and hardware/software solutions for dual core lock step, and how to perform system-level testing in the RISC-V ecosystem., Peer Reviewed
Recercat. Dipósit de la Recerca de Catalunya
Publication Contribución de congreso (ConferenceOutput)

Security, reliability and test aspects of the RISC-V ecosystem

  • Abella Ferrer, Jaume
  • Alcaide Portet, Sergi
  • Anders, Jens
  • Bas Jalón, Francisco
  • Becker, Steffen
  • De Mulder, Elke
  • Elhamawy, Nourhan
  • Gürkaynak, Frank K.
  • Handschuh, Helena
  • Hernández Luz, Carles
  • Hutter, Mike
  • Kosmidis, Leonidas
  • Polian, Ilia
  • Sauer, Matthias
  • Wagner, Stefan
  • Regazzoni, Francesco
RISC-V has emerged as a viable solution on academia and industry. However, to use open source hardware for safety-critical applications, we need a deep understanding of the way in which well established mechanisms for testing and reliability could be integrated and deployed on the RISCV ecosystem, and we need a clear knowledge on how such an ecosystem can be leveraged to improve security. This paper includes four contributions presenting the potential of RISC-V in security research, the way in which RISC-V can be hardened against power analysis attacks, how to implement, using RISCV, software and hardware/software solutions for dual core lock step, and how to perform system-level testing in the RISC-V ecosystem., Peer Reviewed, Postprint (published version)
Recercat. Dipósit de la Recerca de Catalunya
Publication Contribución de congreso (ConferenceOutput)

Unboxing the sand: on deploying safety measures in the programmable logic of COTS MPSoCs

  • Alcaide Portet, Sergi
  • Cabo Pitarch, Guillem
  • Bas Jalón, Francisco
  • Benedicte Illescas, Pedro
  • Mazzocchetti, Fabio
  • Cazorla Almeida, Francisco Javier
  • Abella Ferrer, Jaume
The lack of sufficient hardware support for functional safety precludes the full adoption of many Commercial Off-the-Shelf (COTS) MPSoCs in safety-related systems, such as those in the aerospace industry. Some recent MPSoCs come along with programmable logic (PL), primarily intended to offload some specific complex functions that can be much more efficiently implemented in hardware than in software, hence being such PL a kind-of-sandbox fully mastered by ASIC cores outside the PL. This paper proposes using PL in those COTS MPSoCs to deploy the support needed to implement safety measures efficiently to enable the use of those MPSoCs for systems needing high assurance levels. Hence, the goal is not mastering PL from the cores solely, but also allowing PL to provide monitoring (e.g. contention, diversity, watchdogs) and control (e.g. configuring QoS features) capabilities to enable the realization of a safety concept atop. The early work presented in this paper already provides specific monitoring, diversity, and controlling strategies to allow PL take over safety-related functionalities., This work is part of the project PCI2020-112010, funded by MCIN/AEI/10.13039/501100011033 and the European Union “NextGenerationEU”/PRTR, and the European Union’s Horizon 2020 Programme under project ECSEL Joint Undertaking (JU) under grant agreement No 877056. This work has also been partially supported by the Spanish Ministry of Science and Innovation under grant PID2019-107255GBC21 funded by MCIN/AEI/10.13039/501100011033., Peer Reviewed, Postprint (published version)