Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 5
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Polyoxometalate-Stabilized Silver Nanoparticles and Hybrid Electrode Assembly Using Activated Carbon

  • Goberna-Ferrón, Sara|||0000-0002-3306-3791
  • Cots, Laia
  • Perxés Perich, Marta
  • Zhu, Jun-Jie
  • Gomez-Romero, Pedro
[EN] The intersection between the field of hybrid materials and that of electrochemistry is a quickly expanding area. Hybrid combinations usually consist of two constituents, but new routes toward more complex and versatile electroactive hybrid designs are quickly emerging. The objective of the present work is to explore novel triple hybrid material integrating polyoxometalates (POMs), silver nanoparticles (Ag-0 NPs), and activated carbon (AC) and to demonstrate its use as a hybrid electrode in a symmetric supercapacitor. The tri-component nanohybrid (AC/POM-Ag-0 NPs) was fabricated through the combination of AC with pre-synthesized & SIM;27 nm POM-protected Ag-0 NPs (POM-Ag-0 NPs). The POM-Ag-0 NPs were prepared using a green electrochemical method and characterized via UV-vis and IR spectroscopy, electron microscopy, dynamic light scattering (DLS), X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), and cyclic voltammetry (CV). Afterward, the AC/POM-Ag-0 NPs ternary nanocomposite material was constructed and characterized. The electrochemical behavior of AC/POM-Ag-0 NPs' modified electrodes reveal that the nanomaterial is electroactive and exhibits a moderately higher specific capacitance (81 F/g after 20 cycles) than bare AC electrodes (75 F/g) in a symmetrical supercapacitor configuration in the voltage range 0 to 0.75 V and 20 mV/s, demonstrating the potential use of this type of tri-component nanohybrid for electrochemical applications., This project has received funding from the European Union's Horizon 2020 research and innovation program under the Marie Sklodowska-Curie grant agreement No 894270. This research was funded by the postdoctoral fellowship program Beatriu de Pinos, funded by the Commission for Universities and Research of the Department of Innovation, Universities, and Enterprise of the Generalitat de Catalunya and by the Horizon 2020 program of research and innovation of the European Union under the Marie Sklodowska-Curie grant agreement No 801370.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Structural Evolution of Stapes Controls the Electrochemical CO2 Reduction on Bimetallic Cu-doped Gold Nanoclusters

  • Ibáñez-Alé, Enric
  • Hu, Jiajun
  • Simonelli, Laura
  • Marini, Carlo
  • López, Nuria
  • Barrabés, Noelia
  • Albero-Sancho, Josep|||0000-0002-4841-7206
  • García Gómez, Hermenegildo|||0000-0002-9664-493X
  • Goberna-Ferrón, Sara|||0000-0002-3306-3791
[EN] Ligand protected gold nanoclusters have been proposed for electrochemical CO2 reduction (eCO(2)R) as an alternative to polycrystalline catalysts, showing higher selectivity control due to the tailored composition and precise microenvironment. Here, two gold cluster families are studied with different staple motifs (Au-25(SR)(18) and Au-144(SR)(60), where SR = thiolate) doped with Ag or Cu to understand the interplay between the composition and the performance of these catalysts. Detailed cluster characterization and Density Functional Theory simulations demonstrate that the dynamic aspects involving ligand removal are crucial to unraveling the role of the dopant, the cluster curvature, and the staple structure. The best activity performance toward CO is obtained for Cu-doped Au-144(SR)(60) at U = -0.8 V-RHE as ligands are only partially depleted and the staple can bend to stabilize *CO intermediate, while Cu-containing Au-25(SR)(18) can produce formate but shows worse CO selectivity. This study points toward the importance of ligand stability during eCO(2)R on bimetallic gold nanoclusters, paving the way for improving the design and operation of this family of catalysts., This project has received funding from the European Union's Horizon 2020 research and innovation programme under the Marie Sklodowska-Curie grant agreement No 894270. The authors acknowledge financial support from the Spanish Ministry of Science and Innovation (PRE2021-097615, PID2021-122516OB-I00, and Severo Ochoa Centre of Excellence CEX2019-000925-S 10.13039/501100011033), the Austrian Science Fund (FWF) via grant Elise Richter (V831-N), and the COSY COST action (CA21101) supported by COST (European Cooperation in Science and Technology). The Barcelona Supercomputing Centre-MareNostrum (BSC-RES) is acknowledged for providing generous computational resources. EuroHPC Joint Undertaking is also acknowledged for awarding them access to MareNostrum5 at BSC, Spain. The XAFS measurements were performed at the NOTOS and CLAESS beamline at ALBA Synchrotron with the collaboration of ALBA staff. Funding for open access charge: CRUE-Universitat Politecnica de Valencia. J.A. thanks the Spanish Ministry of Science and Innovation for a Ramon y Cajal research associate contract (RYC2021-031006-I financed support by MCIN/AEI/10.13039/501100011033 and by European Union/NextGenerationEU/ PRTR), and Generalitat Valenciana (CIGE 2022-093) financed by European Union-Next Generation EU, through the Conselleria de Innovacion, Universidades, Ciencia y Sociedad Digital. J.H. thanks the Chinese Scholarship Council for doctoral fellowship.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Fe and Sn Single-Site-Based Electrodes for High-Current CO2. Reduction in Acid Media and Stable Zn-CO2 Batteries

  • Hu, Jiajun
  • Simonelli, Laura
  • Lopez-Salas, Nieves
  • Goberna-Ferrón, Sara|||0000-0002-3306-3791
  • García Gómez, Hermenegildo|||0000-0002-9664-493X
  • Albero-Sancho, Josep|||0000-0002-4841-7206
[EN] Electrocatalytic CO2 conversion is a promising method for reducing the dependence on fossil fuels and lowering CO2 emissions. However, challenges such as suppression of the competing hydrogen evolution reaction (HER) and long-term stability, especially in acidic media, among others, hinder its industrial application. Herein, Fe and Sn single sites supported on an N-doped carbon support (FSNC) was prepared by direct pyrolysis of selected precursors. XANES and EXAFS measurements confirmed the presence of Fe and Sn single atoms coordinated to N or O atoms in the N-doped carbon. An analogous material synthesized by deposition of Fe and Sn precursors on a previously fabricated N-doped carbon matrix (FS/NC), followed by thermal reduction, rendered Fe-O small clusters and Sn single atoms. FSNC was tested for CO2 reduction, obtaining a CO Faradaic efficiency (FE) of 92%, while the CO FE of FS/NC was 63%. We attributed the differences in selectivity to the interaction between the Fe and Sn single sites, while the Fe-O clusters are inactive for this reaction. Double-layer capacitance (CDL) and electrochemical impedance spectroscopy (EIS) measurements confirmed a larger electrochemically active surface area and lower charge-transfer resistance, respectively, in FSNC. In addition, FSNC demonstrated a high CO FE (90%) under acidic conditions (pH = 2.1), demonstrating that this electrocatalyst can effectively suppress the HER under acidic conditions. Moreover, 5 cm2 electrodes containing FSNC were fabricated, and their stability was tested for 20 h of continuous operation in an electrochemical flow cell at different current densities (50-350 mA/cm2), demonstrating improved stability at high current densities and under acidic conditions. Finally, FSCN-based cathodes were also tested in a Zn-CO2 battery, achieving a maximum power density of 2.54 mW/cm2 at 0.48 V with a current density of 5.2 mA/cm2 and demonstrating outstanding rechargeability and stability upon 50 continuous charge-discharge cycles for 50 h., Financial support was provided by the Spanish Ministry of Science and Innovation (Severo Ochoa CEX2021-1230-S, financed by MCIN/AEI/10.13039/501100011033, and PDI2021-0126071-OB-CO21 and PID2022-141099OA-I00, funded by MCIN/AEI/10.13039/501100011033 and NextGenerationEU/PRTR) and Generalitat Valenciana (Prometeo 2021-083, CIGE 2022-093, and Advanced Materials programme Graphica MFA/2022/023, financed by NextGenerationEU through the Conselleria de Innovacion, Universidades, Ciencia y Sociedad Digital). J.A. also thanks the Spanish Ministry of Science and Innovation for a Ramon y Cajal research associate contract (RYC2021-031006-I, funded by MCIN/AEI/10.13039/501100011033 and NextGenerationEU/PRTR). J.H. thanks the Chinese Scholarship Council for a postgraduate scholarship to perform his PhD at Valencia. S.G.-F. thanks the European Union's Horizon 2020 research and innovation program (Marie Sklodowska-Curie grant agreement No. 894270).
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Polyoxometalate-Stabilized Silver Nanoparticles and Hybrid Electrode Assembly Using Activated Carbon

  • Goberna-Ferrón, Sara
  • Cots, Laia
  • Perxés Perich, Marta
  • Zhu, Jun-Jie
  • Gómez-Romero, P.
The intersection between the field of hybrid materials and that of electrochemistry is a quickly expanding area. Hybrid combinations usually consist of two constituents, but new routes toward more complex and versatile electroactive hybrid designs are quickly emerging. The objective of the present work is to explore novel triple hybrid material integrating polyoxometalates (POMs), silver nanoparticles (Ag0 NPs), and activated carbon (AC) and to demonstrate its use as a hybrid electrode in a symmetric supercapacitor. The tri-component nanohybrid (AC/POM-Ag0 NPs) was fabricated through the combination of AC with pre-synthesized ∼27 nm POM-protected Ag0 NPs (POM-Ag0 NPs). The POM-Ag0 NPs were prepared using a green electrochemical method and characterized via UV-vis and IR spectroscopy, electron microscopy, dynamic light scattering (DLS), X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), and cyclic voltammetry (CV). Afterward, the AC/POM-Ag0 NPs ternary nanocomposite material was constructed and characterized. The electrochemical behavior of AC/POM-Ag0 NPs’ modified electrodes reveal that the nanomaterial is electroactive and exhibits a moderately higher specific capacitance (81 F/g after 20 cycles) than bare AC electrodes (75 F/g) in a symmetrical supercapacitor configuration in the voltage range 0 to 0.75 V and 20 mV/s, demonstrating the potential use of this type of tri-component nanohybrid for electrochemical applications., This project has received funding from the European Union’s Horizon 2020 research and innovation program under the Marie Skłodowska-Curie grant agreement No 894270. This research was funded by the postdoctoral fellowship program Beatriu de Pinós, funded by the Commission for Universities and Research of the Department of Innovation, Universities, and Enterprise of the Generalitat de Catalunya and by the Horizon 2020 program of research and innovation of the European Union under the Marie Skłodowska-Curie grant agreement No 801370., Peer reviewed
Dipòsit Digital de Documents de la UAB
Publication Artículo científico (JournalArticle)

Polyoxometalate-Stabilized Silver Nanoparticles and Hybrid Electrode Assembly Using Activated Carbon

  • Goberna-Ferrón, Sara|||0000-0002-3306-3791
  • Cots, Laia
  • Perxés Perich, Marta|||0000-0003-3062-7288
  • Zhu, Jun-Jie|||0000-0002-8024-099X
  • Gómez-Romero, Pedro|||0000-0002-6208-5340
The intersection between the field of hybrid materials and that of electrochemistry is a quickly expanding area. Hybrid combinations usually consist of two constituents, but new routes toward more complex and versatile electroactive hybrid designs are quickly emerging. The objective of the present work is to explore novel triple hybrid material integrating polyoxometalates (POMs), silver nanoparticles (Ag 0 NPs), and activated carbon (AC) and to demonstrate its use as a hybrid electrode in a symmetric supercapacitor. The tri-component nanohybrid (AC/POM-Ag 0 NPs) was fabricated through the combination of AC with pre-synthesized ∼27 nm POM-protected Ag 0 NPs (POM-Ag 0 NPs). The POM-Ag 0 NPs were prepared using a green electrochemical method and characterized via UV-vis and IR spectroscopy, electron microscopy, dynamic light scattering (DLS), X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), and cyclic voltammetry (CV). Afterward, the AC/POM-Ag 0 NPs ternary nanocomposite material was constructed and characterized. The electrochemical behavior of AC/POM-Ag 0 NPs' modified electrodes reveal that the nanomaterial is electroactive and exhibits a moderately higher specific capacitance (81 F/g after 20 cycles) than bare AC electrodes (75 F/g) in a symmetrical supercapacitor configuration in the voltage range 0 to 0.75 V and 20 mV/s, demonstrating the potential use of this type of tri-component nanohybrid for electrochemical applications.