Skip to main content

METANO A PARTIR DE ENERGIAS RENOVABLES Y CAPTURA Y UTILIZACION DE CO2 EN EL SECTOR RESIDENCIAL, INDUSTRIAL Y AUTOMOVILISTICO

ENE2016-76850-R

•
Funding agency name Agencia Estatal de Investigación
Funding agency acronym AEI
Program Programa Estatal de I+D+i Orientado a los Retos de la Sociedad
Call Proyectos I+D+i Retos de Investigación
Call year 2016
State Plan 2013-2016 Plan Estatal de Investigación Científica y Técnica y de Innovación
Beneficiary centre UNIVERSIDAD DE ZARAGOZA

Resultados relacionados

Resultados totales (Incluyendo duplicados): 8
Encontrada(s) 1 página(s)

Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publication Artículo científico (JournalArticle)

Decision-making methodology for managing photovoltaic surplus electricity through Power to Gas: Combined heat and power in urban buildings

  • Bailera, Manuel
  • Peña, Begoña
  • Lisbona, Pilar
  • Romeo, Luis M.
Power to Gas technology, which converts surplus electricity into synthetic methane, is a promising alternative to overcome the ¿uctuating behavior of renewable energies. Hybridization with oxy-fuel combustion provides the CO2 ¿ow required in the methanation process and allows supplying both heat and electricity, keeping the CO 2 in a closed loop. The complexity of these facilities makes their management a key factor to be economically viable. This work presents a decision-making methodology to size and manage a cogeneration system that combines solar photovoltaic, chemical storage through Power to Gas, and an oxy-fuel boiler. Up to 35 potential situations have been identi¿ed, depending on the surplus electricity, occupancy of the intermediate storages of hydrogen and synthetic methane, and thermal demand. For illustration purposes, the methodology has been applied to a case study in the building sector. Speci¿cally, a building with 270 kW of solar photovoltaic installed power is analyzed under nine energy scenarios. The calculated capacities of electrolysis vary from 65 kW to 96 kW with operating hours between 2184 and 2475 h. The percentage of methane stored in the gas grid varies from 0.0% (no injection) to 30.9%. The more favorable scenarios are those with the lowest demands, showing temporary displacements beyond the month between injection and utilization.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publication Artículo científico (JournalArticle)

Techno-economic feasibility of power to gas–oxy-fuel boiler hybrid system under uncertainty

  • Bailera, M.
  • Hanak, D.P.
  • Lisbona, P.
  • Romeo, L.M.
One of the main challenges associated with utilisation of the renewable energy is the need for energy storage to handle its intermittent nature. Power-to-Gas (PtG) represents a promising option to foster the conversion of renewable electricity into energy carriers that may attend electrical, thermal, or mechanical needs on-demand. This work aimed to incorporate a stochastic approach (Artificial Neural Network combined with Monte Carlo simulations) into the thermodynamic and economic analysis of the PtG process hybridized with an oxy-fuel boiler (modelled in Aspen Plus®). Such approach generated probability density curves for the key techno-economic performance indicators of the PtG process. Results showed that the mean utilisation of electricity from RES, accounting for the chemical energy in SNG and heat from methanators, reached 62.6%. Besides, the probability that the discounted cash flow is positive was estimated to be only 13.4%, under the set of conditions considered in the work. This work also showed that in order to make the mean net present value positive, subsidies of 68 €/MWelh are required (with respect to the electricity consumed by PtG process from RES). This figure is similar to the financial aids received by other technologies in the current economic environment.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publication Artículo científico (JournalArticle)

Renewable energy sources and power-to-gas aided cogeneration for non-residential buildings

  • Bailera, Manuel
  • Lisbona, Pilar
  • Llera, Eva María
  • Peña, Begoña
  • Romeo, Luis Miguel
One promising technology to manage and store renewable electricity from wind or solar sources is Power to Gas (PtG). PtG combines H2 from electrolysis –run by renewable electricity– with CO2 to produce synthetic CH4. A suitable option to get the required CO2 streams is the integration with carbon capture technologies, in particular with oxy-fuel combustion. The application proposed in this study is a cogeneration system that combines PtG, oxyfuel boiler, wind energy and photovoltaic solar production to be applied in buildings. This paper describes the concept and analyses the influence of equipment dimensions varying the relative size and the proportion of the solar-wind installed power for two locations representative of North and South European countries. Results: Show that higher solar and wind powers are required in the Northern region to satisfy coverage of thermal demand. It results in longer time displacement of energy storage towards cold months. Accordingly to the generation patterns of wind and solar energies, higher solar proportion results in longer energy storage periods. Therefore, solar resource is more suitable than wind power to exploit the potential of PtG technology, although the size of the overall systems increases.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publication Artículo científico (JournalArticle)

Improved Flexibility and Economics of Combined Cycles by Power to Gas

  • Bailera, Manuel
  • Peña, Begoña
  • Lisbona, Pilar
  • Romeo, Luis M.
Massive penetration of renewable energy in the energy systems is required to comply with existing CO2 regulations. Considering current power pools, large shares of renewable energy sources imply strong efficiency and economic penalties in fossil fuel power plants as they are mainly operated to regulate the system and constant shutdowns are expected. Under this framework, the integration of a combined cycle power plant (CCPP) with an energy storage technology such as power to gas (PtG) is proposed to virtually reduce its minimum complaint load through the diversion of instantaneous excess electricity. Power to gas produces hydrogen through water electrolysis, which is later combined with CO2 to produce methane. The main novelty of this study relies in the improved flexibility and economics of combined cycles by means of using power to gas as a tool to reduce the minimum complaint load. The principal objective of the study is the quantification of cost reduction under different scenarios of shutdowns and conventional start-ups. The case study analyses a combined cycle of 400 MWe gross power with a minimum complaint load of 30% that can be virtually reduced to 20% by means of a 40- MWe power-to-gas plant. Eight scenarios are defined to compare the reference case of conventional operation under hot, warm, and cold start-ups with power-to-gas-assisted operation. Additionally, PtG-assisted operation scenarios are analyzed with different loads (30–50–70%). These scenarios also include the consideration of a temporary peak of demand occurring in a period in which dispatch is below the minimum complaint load. Under this situation, the response time of conventional plants is very limited, while PtG-assisted CCPP can rapidly satisfy the peak. The techno-economic model quantifies the required fuel, gross and net power, and emissions as well as total costs and incomes under each scenario and net differential profit in an hourly basis. The analysis of the obtained results does not recommend the operation of the PtG-assisted CCPP at minimum complaint load for hot, warm, or cold start-ups. However, important marginal profits are achieved with the proposed system for part-loads operation over 50% for every sort of start-up, avoiding shutdowns and extending the capacity factor.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publication Artículo científico (JournalArticle)

Reducing cycling costs in coal fired power plants through power to hydrogen

  • Romeo, L.M.
  • Peña, B.
  • Bailera, M.
  • Lisbona, P.
The increase of renewable share in the energy generation mix makes necessary to increase the flexibility of the electricity market. Thus, fossil fuel thermal power plants have to adapt their electricity production to compensate these fluctuations. Operation at partial load means a significant loss of efficiency and important reduction of incomes from electricity sales in the fossil power plant. Among the energy storage technologies proposed to overcome these problems, Power to Gas (PtG) allows for the massive storage of surplus electricity in form of hydrogen or synthetic natural gas. In this work, the integration of a Power to Gas system (50 MWe) with fossil fuel thermal power plants (500 MWe) is proposed to reduce the minimum complaint load and avoid shutdowns. This concept allows a continuous operation of power plants during periods with low demand, avoiding the penalty cost of shutdown. The operation of the hybrid system has been modelled to calculate efficiencies, hydrogen and electricity production as a function of the load of the fossil fuel power plant. Results show that the utilisation of PtG diminishes the specific cost of producing electricity between a 20% and 50%, depending on the framework considered (hot, warm and cold start-up). The main contribution is the reduction of the shutdown penalties rather than the incomes from the sale of the hydrogen. At the light of the obtained results, the hybrid system may be implemented to increase the cost-effectiveness of existing fossil fuel power plants while adapting the energy mix to high shares of variable renewable electricity sources.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publication Artículo científico (JournalArticle)

A review on CO2 mitigation in the Iron and Steel industry through Power to X processes

  • Bailera, Manuel
  • Lisbona, Pilar
  • Peña, Begoña
  • Romeo, Luis M.
In this paper we present the first systematic review of Power to X processes applied to the iron and steel industry. These processes convert renewable electricity into valuable chemicals through an electrolysis stage that produces the final product or a necessary intermediate. We have classified them in five categories (Power to Iron, Power to Hydrogen, Power to Syngas, Power to Methane and Power to Methanol) to compare the results of the different studies published so far, gathering specific energy consumption, electrolysis power capacity, CO2 emissions, and technology readiness level. We also present, for the first time, novel concepts that integrate oxy-fuel ironmaking and Power to Gas. Lastly, we round the review off with a summary of the most important research projects on the topic, including relevant data on the largest pilot facilities (2–6 MW).
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publication Artículo científico (JournalArticle)

Lab-scale experimental tests of Power to Gas-Oxycombustion hybridization: system design and preliminary results

  • Bailera, Manuel
  • Begoña, Peña
  • Lisbona, Pilar
  • Marín, Julián
  • Romeo, Luis M.
Power-to-Gas (PtG) represents one of the most promising energy storage technologies. PtG converts electricity surplus into synthetic natural gas by combining water electrolysis and CO2 methanation. This technology valorises captured CO2 to produce a ‘carbon neutral’ natural gas, while allowing temporal displacement of renewable energy. PtG-Oxycombustion hybridization is proposed to integrate mass and energy flows of the global system. Oxygen, comburent under oxy-fuel combustion, is commonly produced in an air separation unit. This unit can be replaced by an electrolyser which by-produces O2 reducing the electrical consumption and the energy penalty of the carbon separation process. The aim of this work is to present the design, construction and testing of a methanation reactor at laboratory scale to increase the knowledge of the key component of this system. Experimental data are used to validate the theoretical kinetic model at different operating temperatures implemented in Aspen Plus. CO2 conversions about 60-80% are found for catalyst temperature between 350 and 550 ºC. These values agree well with expected theoretical conversions from the kinetic model.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publication Artículo científico (JournalArticle)

Synthetic natural gas production in a 1 kW reactor using Ni–Ce/Al2O3 and Ru–Ce/Al2O3: Kinetics, catalyst degradation and process design

  • Bailera, M.
  • Lisbona, P.
  • Peña, B.
  • Alarcón, A.
  • Guilera, J.
  • Perpiñán, J.
  • Romeo, L. M.
Nickel and ruthenium promoted by ceria were compared as catalyst active phase for the production of synthetic natural gas in a 1 kW fixed-bed reactor (49 cm in length and 3 cm in diameter). Both catalysts were tested in a broad range of conditions: 250–450 °C, 8000–16000 h−1 GHSV, 3.5–5.5H2/CO2 ratio, and atmospheric pressure. The Ni-based catalyst presented higher CO2 conversion and lower reduction of BET area and metal dispersion after utilization. Two kinetic models were elaborated according to the performance of the catalysts in this reactor. The minimum mean squared error between the kinetic model and experiments was 3.0% for the Ru-based catalyst and 1.4% for the Ni-based catalyst. The kinetic model of the Ni-based catalyst was implemented in Aspen Plus to evaluate potential methanation plant designs. The simulation minimized the amount of catalyst required to reach 95 vol% of CH4, within proper technical limits (GHSV 5000 h−1 and temperature 300 °C). The 3-reactor plant was the most adequate configuration. The total catalyst mass was 3.26 kg per kg/h of SNG, the heat removed from the reactors was 10.8 MJ/kgSNG, and the preheating necessity was 4.90 MJ/kgSNG. The electrolysis energy consumption was 86.4 MJ/kgSNG.