Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

Repositorio Institucional de la Universidad de Burgos (RIUBU)
Publication Artículo científico (JournalArticle)

Parameter Optimisation in Selective Laser Melting on C300 Steel

  • Cuesta Segura, Isidoro Iván
  • Díaz Portugal, Andrés
  • Rojo, M. A.
  • Peral, Luis Borja
  • Martínez, J.
  • Alegre Calderón, Jesús Manuel
Additive manufacturing (AM) of metallic materials is increasingly being adopted in numerous sectors, such as biomedicine, aerospace or automotive industries, due to its versatility in the creation of complex geometries and the minimisation of material waste when compared to traditional subtractive methods. In order to ensure a reliable operation of these parts, however, an in-depth study of the effect of additive manufacturing on mechanical properties, including tensile, fatigue and fracture resistance, is necessary. Among the vast number of methods and materials, this project is focused in one of the most promising techniques for the industry: Selective Laser Melting (SLM) for the production of a tools steel, in particular C300 steel components for the automotive sector. The main objective of this paper is to optimise some of the key parameters in the printing process, such as laser power, laser speed and hatch spacing. These variables are essential to obtain parts with good resistance. To that purpose, tensile tests were performed in 3D printed specimens, and then elastoplastic properties were extracted, organised and analysed through a design of experiments for the subsequent output fitting using the response surface methodology., This research was funded by: INVESTUN/22/BU/0003 // BU-002-P20 // MU-21-UP2021-030.
Repositorio Institucional de la Universidad de Burgos (RIUBU)
Publication Artículo científico (JournalArticle)

Methodology to predict mechanical properties of PA-12 lattice structures manufactured by powder bed fusion

  • Rodríguez Aparicio, Rubén
  • Alegre Calderón, Jesús Manuel
  • Verbeeten, Wilco M.H.
  • Lorenzo Bañuelos, Miriam
  • Cuesta Segura, Isidoro Iván
Topology optimization for weight reduction of additive manufacturing parts is commonly achieved throughout the creation of lattice structures, typically generated with beams of small size cross-section. In order to carry out accurate simulations of these lattice structures, knowing the mechanical behavior of pillars is required. In this paper, a methodology for determining the mechanical properties of small size pillars printed in PA-12 material, using polymer powder bed fusion (PBF) and in particular the Selective Laser Sintering (SLS) technology, is presented. The effect of defects originated during the manufacturing process on the macroscopic mechanical properties is studied and the mechanisms which influence these properties are analyzed. A methodology for the determination of these properties is proposed, based on a successive correction of the printed nominal diameters according to two approaches; one due to the outer skin of unmelted material and the other due to internal melting defects. Once the material properties are determined, as a function of the cross-section of the lattice pillars, the numerical simulation of lattice-type structures has been carried out and the degree of adjustment of the proposed methodology has been experimentally verified, obtaining good results. This validation provides a reliable method for the simulation of the macroscopic behavior of lattice-type structures with reduced sizes, taking into account the intrinsic defects generated during the printing process., The authors wish to acknowledge the funding received through the Junta de Castilla y León projects BU-002-P20 and INVESTUN/22/BU/0003 co-financed with FEDER funds, and the projects MR5W.P3 (C17. I01. P01. S21) and MR4W.P2 co-financed by JCyL and MICINN and the NextGenerationEU/PRTR funds.