Skip to main content

PREPARACION, TEXTURADO Y CARACTERIZACION DE CERAMICAS TERMOELECTRICAS DE ALTAS PRESTACIONES BASADAS EN OXIDOS DE CO

MAT2008-00429

•
Funding agency name Ministerio de Ciencia e Innovación
Funding agency acronym MICINN
Program Programa Nacional de Proyectos de Investigación Fundamental
Subprogram Subprograma de Proyectos de Investigación Fundamental no Orientada
Call Proyectos I+D
Call year 2008
State Plan 2008-2011 Plan Nacional de Investigación Científica, Desarrollo e Innovación Tecnológica
Management unit Subdirección General de Proyectos de Investigación
Beneficiary centre UNIVERSIDAD DE ZARAGOZA

Resultados relacionados

Resultados totales (Incluyendo duplicados): 5
Encontrada(s) 1 página(s)

Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publication Artículo científico (JournalArticle)

Effect of Ag additions on the Bi1.6Pb0.4Sr2Co1.8Ox thermoelectric properties

  • Diez, J.C.
  • Rasekh, Sh.
  • Constantinescu, G.
  • Torres, M.A.
  • Madre, M.A.
  • Sotelo, A.
Bi1.6Pb0.4Sr2Co1.8Ox thermoelectric ceramics with small Ag additions (0, 1, and 3 wt.%) have been successfully produced by a sol-gel method via nitrates. Microstructure has shown a reduction on the amount of secondary phases and an increase on the bulk density with increasing Ag contents. The microstructural evolution, as a function of Ag content, is confirmed with the electrical resistivity values which show an important decrease for the 3 wt.% Ag samples, leading to maximum power factor values of about 0.025 mW/K2.m at room temperature, which is about two times higher than the obtained for the Ag-free sintered samples. Se han preparado cerámicas termoeléctricas de composición Bi1.6Pb0.4Sr2Co1.8Ox con pequeñas adiciones de Ag (0, 1, y 3 % en peso) por medio de un método sol-gel a partir de los nitratos metálicos. La microestructura ha mostrado una reducción de la cantidad de fases secundarias y un aumento de la densidad del material al aumentar la cantidad de Ag. La evolución microestructural, en función del contenido de Ag, se ha confirmado con los valores de la resistividad eléctrica que muestra una reducción importante para las muestras con 3 % en peso de Ag, lo que lleva a alcanzar valores máximos del factor de potencia de alrededor de 0.025 mW/K2.m a temperatura ambiente, que es dos veces mayor que el obtenido para muestras sinterizadas sin Ag
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publication Artículo científico (JournalArticle)

Effect of current polarity on BSCCO/Ag ceramics textured by electrically assisted laser floating zone

  • Costa, F.M.
  • Rasekh, S.
  • Ferreira, N.M.
  • Sotelo, A.
  • Diez, J.C.
  • Madre, M.A.
Bi-2212/Ag superconducting ceramics were grown using the electrically assisted laser floating zone (EALFZ) technique. The main goal was improving the superconducting properties by applying an electrical current through the sample during the solidification process. The effect of a 100 mA current intensities in two configurations were studied: (i) direct current (connecting the seed rod to the positive pole and the feed to the negative one) and (ii) reverse current (positive pole connected to the feed rod and negative to the seed one). The resulting textured cylindrical bars were annealed in order to obtain the superconducting phases. A strong correlation between current polarity, grain alignment and superconducting properties was observed. The rods grown under direct current exhibit higher critical current density (∼3000 A/cm2) than the ones grown under conventional method (∼2300 A/cm2) or under reverse current condition (∼35 A/cm2). The superior value obtained for the direct current results from a better grain alignment and fewer amount of second phases.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publication Artículo científico (JournalArticle)

Effect of postannealing process on Bi2Sr2.1Ca 0.9Cu2O8+δ textured superconductors

  • Sotelo, A.
  • Madre, M.A.
  • Rasekh, S.
  • Constantinescu, G.
  • Torres, M.A.
  • Diez, J.C.
Bi-2212 samples prepared by the classical solid-state method have been grown from the melt using the Laser Floating Zone (LFZ) method. They have shown good grain alignment and transport critical current densities (J c ). After postannealing processes designed to produce the Bi-2212 phase controlled decomposition, J c values have been increased in an important manner. Maximum values have been achieved when samples were thermally treated at 680 °C for 168 h with improvements around 80 %, compared with the original textured samples. The results clearly indicate that postannealing processes, when adequately controlled, produce the formation of effective pinning centers which are responsible for the increase in the measured J c values.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publication Artículo científico (JournalArticle)

Solution-based synthesis routes to thermoelectric Bi2Ca2Co1.7Ox

  • Sotelo, A.
  • Rasekh, S.
  • Madre, M.A.
  • Guilmeau, E.
  • Marinel, S.
  • Diez, J.C.
The synthesis of Bi2Ca2Co1.7Ox misfit compounds by different processing routes, i.e. classical solid-state, and two solution methods namely sol–gel via nitrates and a polymer route, has been investigated. A comparison among the final products has been performed using DTA, TGA, X-ray diffraction, scanning electron microscopy, and thermoelectric characterizations. All the samples obtained by solution synthesis show a very important increase in ZT, as compared to the solid state prepared samples, due to a significant decrease in the electrical resistivity values.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publication Artículo científico (JournalArticle)

Improvement of thermoelectric properties of Bi2Sr2Co1.8Ox through solution synthetic methods

  • Torres, M.A.
  • Sotelo, A.
  • Rasekh, Sh.
  • Serrano, I.
  • Constantinescu, G.
  • Madre, M.A.
  • Diez, J.C.
Several solution synthetic methods, sol-gel and a polymeric route, have been studied in order to obtain Bi2Sr2Co1.8Ox ceramics with improved thermoelectric properties, compared to the classical solid state reaction. The products obtained by these different methods have been compared using DTA-TGA, powder X-ray diffraction, scanning electron microscopy, and thermoelectric characterizations. All the samples obtained by solution synthesis show higher homogeneity and lower content of secondary phases. The main differences in thermoelectrical properties are due to the decrease of electrical resistivity in samples obtained by solution methods, compared with the solid state obtained samples. Between them, the decrease is especially high for those samples prepared by the polymer solution method. Therefore, the polymeric solution synthesis route is shown to yield a power factor four times higher than the obtained for the solid state and sol-gel methods at room temperature.