RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication
Artículo científico (JournalArticle)
Effect of laser irradiation on failure mechanism of TiCp reinforcedtitanium composite coating produced by laser cladding
[EN] Laser cladding is an effective technique to coat a metallic substrate with a layer of a different nature.It has been widely reported that the most important combined parameters controlling the quality ofthe coating are the specific energy (E) and the powder density ( ). In the present work, clad depositsof Ti6Al4V + 60 wt.% TiC were prepared on a Ti6Al4V substrate using an optimum combination of Ec= 24 J/mm2 and c= 3 mg/mm2. These experiments were performed using a laser power of 400 and600 W, in order to study the effect of laser power on the properties of the clad. The microstructure, phasecomposition and nanohardness of the coatings were investigated by optical microscopy, scanning elec-tron microscopy and X-ray diffraction. During laser processing, TiC can be partially converted to TiCX(X = 0.5) due mainly to the TiC dissolution into the laser-generated melting pool and subsequent precipi-tation during cooling. It was observed that the lower laser power limit reduces primary TiC dissolution butit also promotes secondary carbide alignment at the interface. On the other hand, the damage mechanisminduced by high laser power is dominated by primary TiC particle cracking by the high stress concentra-tion at the particle matrix interface followed by ductile failure of the matrix. It is also remarkable thatirradiance affects the TiC/TiCxratio despite Ecand care fixed and it determines hardness distributioninside the coating., Authors thank MINECO funding in special the Training of Research Staff programme with the help BES-2009-013589 and the support of the Comision Interministerial de Ciencia y Tecnologia (CICYT), Spain, under Grant MAT2012-39124. This work was developed at the Materials Technology Unit of the Polytechnic University of Valencia associated to CSIC through the National Centre for Metallurgical Research (CENIM). Finally, thank the EU for the funding received through the FEDER help in the project UPOV08-3E-005 for the purchase of equipment and the Generalitat Valenciana for the help ACOMP/2012/094.