Skip to main content

PROPIEDADES AVANZADAS EN MATERIALES FOTONICOS Y ELECTROCERAMICOS BASADOS EN PIROCLOROS

PID2020-116149GB-I00

•
Funding agency name Agencia Estatal de Investigación
Funding agency acronym AEI
Program Programa Estatal de I+D+i Orientado a los Retos de la Sociedad
Call Proyectos de I+D+i (Generación de Conocimiento y Retos Investigación)
Call year 2020
State Plan 2017-2020 Plan Estatal de Investigación Científica y Técnica y de Innovación
Beneficiary centre UNIVERSITAT JAUME I DE CASTELLO

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

RUA. Repositorio Institucional de la Universidad de Alicante
Publication Otros (Other)

Non-Stoichiometric BaxMn0.7Cu0.3O3 Perovskites as Catalysts for CO Oxidation: Optimizing the Ba Content

  • Díaz Verde, Álvaro
  • Veiga, Emerson Luiz dos Santos
  • Beltrán-Mir, Héctor
  • Illán-Gómez, María José
  • Cordoncillo, Eloísa
  • Díaz Verde, Álvaro|||/items/cd6c7340-fb5a-431d-be4e-8bde8df84857
  • Illán-Gómez, María José|||/items/c60edb64-b18b-4119-bf4b-4dae3cc71c22
In this work, a series of BaxMn0.7Cu0.3O3 samples (x: 1, 0.9, 0.8, and 0.7, BxMC) was synthesized, characterized, and used as catalysts for CO oxidation reaction. All formulations were active for CO oxidation in the tested conditions. A correlation between the electrical conductivity, obtained by impedance spectroscopy, and the reducibility of the samples, obtained by H2-TPR, was observed. The Ba0.8Mn0.7Cu0.3O3 composition (B0.8MC) showed the best catalytic performance (comparable to that of the 1% Pt/Al2O3 reference sample) during tests conducted under conditions similar to those found in the exhaust gases of current gasoline engines. The characterization data suggest the simultaneous presence of a high Mn(IV)/Mn(III) surface ratio, oxygen vacancies, and reduced copper species, these two latter being key properties for ensuring a high CO conversion percentage as both are active sites for CO oxidation. The reaction temperature and the reactant atmosphere composition seem to be the most important factors for achieving a good catalytic performance, as they strongly determine the location and stability of the reduced copper species.
RUA. Repositorio Institucional de la Universidad de Alicante
Publication Otros (Other)

Evaluation of Pr2Zr2-xCexO7±δ pyrochlores as a potential Cu support catalysts for CO oxidation in simulated GDI conditions

  • Veiga, Emerson Luiz dos Santos
  • Díaz Verde, Álvaro
  • Illán-Gómez, María José
  • Beltrán-Mir, Héctor
  • Cordoncillo, Eloísa
  • Díaz Verde, Álvaro|||/items/cd6c7340-fb5a-431d-be4e-8bde8df84857
  • Illán-Gómez, María José|||/items/c60edb64-b18b-4119-bf4b-4dae3cc71c22
This study evaluates the catalytic activity, both as bulk catalysts and as supports for copper catalysts for CO oxidation in a simulated Gasoline Direct Injection Engine (GDI) of two pyrochlores: Pr2Zr2O7 (PZ) and Pr2Zr1.9Ce0.1O7±δ (PZC). These pyrochlores were synthesized by the solvothermal method. XRD, FE-SEM, HR-TEM, XPS, H2-TPR, and O2-TPD characterization techniques were employed to determine the structural, microstructural, and redox properties of the samples. All materials exhibited high catalytic activity for CO oxidation, with Cu-PZC showing the best performance, which is comparable to that of a 1% Pt/Al2O3 commercial catalyst used as a reference. Thus, the synthesized solids could be a promising and cost-effective alternative to noble metal-based catalysts used to control GDI exhaust gas composition.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

A site-selective fluorescence spectroscopy study of the crystal phases of KY3F10: Leveraging the optical response of Eu3+ ions

  • Serna-Gallén, Pablo
  • Beltrán-Mir, Héctor
  • Cordoncillo, Eloísa
  • Balda, Rolindes
  • Fernández, Joaquín
The present work deals with the investigation of the site-selective symmetries in Eu3+-doped KY3F10 with different crystal phases. Employing time-resolved fluorescence line-narrowing (TRFLN), a study of the luminescent response of the dopant is reported in samples presenting a single δ-phase, a single α-phase, and a mixture of both δ and α. A new, simple, very low time-consuming and high-yield method was developed to obtain nanospheres of the δ-phase. For both crystal phases, the main site symmetry is spectrally corroborated with that expected by the crystallographic substitution position (C2v in δ, and C4v in α). In addition, the accuracy of the measurements also unveils the presence of significantly distorted Eu3+ ions in the surface of the nanoparticles in all the samples studied, a spectral behavior commonly found in glassy systems. All these findings contribute to the proper understanding of the optical response of luminescent dopants in this and related types of complex fluorides. It is worth highlighting the fact that the huge potential of the unexplored δ-phase is demonstrated, since the site-selective emission of the Eu3+-doped δ-phase is up to 20 times more intense than that of the α-phase., This work was supported financially by the Spanish MCIN (Grant PID2020-116149GB-I00 and PID2020-115419GB/C-22 funded by MCIN/AEI/10.13039/501100011033) and the University of the Basque Country (GIU21/006). P. Serna also thanks the Spanish MCIN for an FPU predoctoral contract (FPU18/04511 funded by MCIN/AEI /10.13039/501100011033 and by “ESF Investing in your future”)., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Low-temperature, high-throughput spatial atomic layer deposition of NiOx nanocrystalline thin films from [Ni(ipki)2]

  • Porcar, Samuel
  • Schmickler, Marcel
  • Okcu, Hayri
  • Obenlüneschloß, Jorit
  • D'Ercole, Stefano
  • Cervera Gabalda, Laura
  • Galarreta-Rodriguez, Itziar
  • Rubio-Zuazo, Juan
  • González Cuadra, Jaime
  • Lahlahi, Abderahim
  • Fraga, Diego
  • Sanchez-Velasquez, Camilo
  • Bellet, Daniel
  • Fix, Thomas
  • Carda, Juan B.
  • Devi, Anjana
  • Muñoz-Rojas, David
Spatial atomic layer deposition (SALD) is a recent ALD variant enabling much faster deposition rates, even at atmospheric pressure, making it ideal for scalable, low-cost devices. NiOx, a transparent p-type oxide, is widely used in emerging technologies like perovskite solar cells. However, no suitable SALD process for NiO thin films has been reported so far. In this work, we present the deposition of nanocrystalline NiOx thin films via SALD using a recent Ni precursor not yet explored for the ALD of NiO, namely, bis(4-(isopropylamino)pent-3en-2-onato)nickel(II) or [Ni(ipki)2]. O2 has been used as coreactant, with higher deposition rates being achieved if H2O is added to the O2 flow. A narrow ALD window has been obtained between 230 °C and 250 °C, where a GPC of 0.023 nm is observed. This corresponds to a deposition rate of 1.4 nm/min, which is 2 to 10 times faster than the rates reported for conventional ALD of NiO thin films. Remarkably, the growth onset of NiOx starts around only 170 °C. The transmittance of the films reaches nearly 97 % in the visible for 55 nm thick films. Scanning electron microscopy (SEM) and transmission electron microscopy (TEM) studies revealed a high homogeneity of the films. X-ray diffraction (XRD), Raman spectroscopy and X-ray absorption spectroscopy (XAS) studies confirm the presence of a cubic NiOx crystalline phase. Finally, NiOx films have been deposited on Ag nanowire networks, demonstrating the possibility of depositing homogeneous and conformal coatings with this new process., The authors would like to express their gratitude for the financial support provided by several research initiatives: the FOTOCER project (PID2020–116149GB-I00), funded by MCIN/AEI/10.13039/501100011033; the CLUSCERM project (TED2021–130963B-C22), supported by MCIN/AEI/10.13039/501100011033 and the European Union’s NextGenerationEU/PRTR initiative; and the CLUSKER project (INNEST/2024/420), funded by the Valencian Institute of Business Competitiveness (IVACE). Additional support was received from the, jointly funded by ANR (project number 21-CE08–0047) and DFG (project number 490773082). The work has also benefited from funding under the Investissement d’Avenir (PIA) program – LabEx MINOS. Furthermore, the authors acknowledge support through the postdoctoral fellowship CIAPOS/2023/425 and the predoctoral fellowship CIACIF/2022/277, both co-financed by the Valencian regional government and the European Social Fund. Authors also want to thank the “Cátedra de Innovación Cerámica 'Ciutat de Vila-real' de l’Universitat Jaume I” for the financial support. We also acknowledge the Spanish Ministerio de Ciencia, Innovación y Universidades and Consejo Superior de Investigaciones Científicas for financial support and for provision of synchrotron radiation facilities through the projects 2010 6 0E 013, 2021 60 E 030 and CEX2024-001445-S., With funding form the Spanish government through the "Severa Ochoa Centre of Excellence" accreditation (CEX2024-001445-S)., Peer reviewed
UPCommons. Portal del coneixement obert de la UPC
Publication Artículo científico (JournalArticle)

Structural and electrical properties of Zr-doped K0.48Na0.52NbO3 ceramics: "Hard" lead-free piezoelectric

  • Beltrán Mir, Hector
  • Vendrell Villafruela, Xavier|||0000-0003-4705-8253
  • Dos Santos Veiga, Emerson Luiz
  • Mestres, Lourdes
  • Cordoncillo, Eloísa
The structural and electrical properties of K0.48Na0.52Nb1-xZrxO3-d (x = 0–0.04) ceramics prepared by the conventional solid-state reaction method were studied. Pellets with composition x = 0.03 sintered at 1125 °C for 2 h showed single-phase of potassium sodium niobate (KNN) perovskite structure. Based on X-ray diffraction and Raman results, a mixture of orthorhombic and monoclinic phases was observed in intermediate compositions. The addition of Zr improved the sinterability and the “hard” piezoelectric properties of KNN, increasing the Ec and Qm values. The composition with x = 0.03 presented the highest permittivity at room temperature, ¿r' = 363 and the lowest dielectric losses, tan d = 0.027. Moreover, it was the sample with the highest Qm and d33 values, with Qm = 1781 and d33 = 82 pC/N. It was therefore the best compositions to obtain a “hard” piezoelectric material based on Zr-doped KNN, which makes it promising candidate for use as “hard” lead-free piezoelectric material for high power applications., Peer Reviewed
Recercat. Dipósit de la Recerca de Catalunya
Publication Artículo científico (JournalArticle)

Structural and electrical properties of Zr-doped K0.48Na0.52NbO3 ceramics: "Hard" lead-free piezoelectric

  • Beltrán Mir, Hector
  • Vendrell Villafruela, Xavier
  • Dos Santos Veiga, Emerson Luiz
  • Mestres, Lourdes
  • Cordoncillo, Eloísa
The structural and electrical properties of K0.48Na0.52Nb1-xZrxO3-d (x = 0–0.04) ceramics prepared by the conventional solid-state reaction method were studied. Pellets with composition x = 0.03 sintered at 1125 °C for 2 h showed single-phase of potassium sodium niobate (KNN) perovskite structure. Based on X-ray diffraction and Raman results, a mixture of orthorhombic and monoclinic phases was observed in intermediate compositions. The addition of Zr improved the sinterability and the “hard” piezoelectric properties of KNN, increasing the Ec and Qm values. The composition with x = 0.03 presented the highest permittivity at room temperature, ¿r' = 363 and the lowest dielectric losses, tan d = 0.027. Moreover, it was the sample with the highest Qm and d33 values, with Qm = 1781 and d33 = 82 pC/N. It was therefore the best compositions to obtain a “hard” piezoelectric material based on Zr-doped KNN, which makes it promising candidate for use as “hard” lead-free piezoelectric material for high power applications., Peer Reviewed, Postprint (published version)