Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 3
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Seed-free electrodeposition of ZnO bi-pods on electrophoretically-reduced graphene oxide for optoelectronic applications

  • Pruna, Alina Iuliana
  • Reyes Tolosa, María Dolores
  • Pullini, D.
  • Hernández Fenollosa, María de los Ángeles
  • Busquets Mataix, David Jeronimo|||0000-0001-5031-7805
[EN] Large areas of reduced graphene oxide (rGO) films were obtained by electrophoretic deposition onto insulating glass substrate. ZnO nanostructures were directly grown on the rGO films by single-step electrodeposition method. The properties of ZnO nanostructures were evaluated as a function of deposition mode onto rGO electrodes with different stoichiometry. Atomic force microscopy (AFM), X-ray diffraction (XRD), scanning electron microscopy (SEM), thermogravimetrical analysis (TGA), transmission measurements, Raman spectroscopy and X-ray photoelectron spectroscopy (XPS) were employed to characterize the obtained materials. Bi-pod morphology was observed for ZnO electrodeposited on rGO films by pulsed current elelctrodeposition. The obtained ZnO/rGO hybrid structures show high potential for highly transparent optoelectronic nanodevices., Financial support from Romanian Authority for Scientific Research-UEFISCDI (project no. PN-II-RU-PD-2012-3-0124) and European Commission (project no. NMP3-SL-2010-246073) is gratefully acknowledged. The authors also thank for the support given by the Microscopy Service and Institute of Chemical Technology (ITQ)-Universidad Politecnica de Valencia.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Effect of combined chemical and electrochemical reduction of graphene oxide on morphology and structure of electrodeposited ZnO

  • Cembrero Cil, Jesús
  • Pruna, Alina Iuliana
  • Pullini, Daniele
  • Busquets Mataix, David Jeronimo|||0000-0001-5031-7805
This study reports a novel method of tailoring the properties of ZnO nanostructures by electrodeposition in presence of chemically-reduced graphene oxide (rGO). The coupled electrochemical and chemical reduction of graphene oxide resulted in few-layer graphene-based material. The presence of rGO in the electrolytic bath showed a marked influence on the morphology and structure of the hybrid nanostructures. The results indicated the presence of 5 mg L 1 rGO results in a 42.9% decrease in resistivity of the hybrid material with respect to the pure ZnO. The proposed approach shows very promising for the fabrication of transparent conductive oxide electrodes., Financial support is gratefully acknowledged from the European Commission (Project no. NMP3-SL-2010-246073) and Romanian Authority for Scientific Research - UEFISCDI (Project no. PN-II-RU-PD-2012-3-0124). The authors would like to thank the support given by the Microscopy Service and Institute of Chemical Technology (ITQ) from the Universidad Politecnica de Valencia (Spain).
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Fast route to obtain Al2O3-based nanocomposites employing graphene oxide: Synthesis and Sintering

  • Benavente Martínez, Rut|||0000-0002-4566-9475
  • Borrell Tomás, María Amparo|||0000-0003-4292-4538
  • Salvador Moya, Mª Dolores|||0000-0002-4242-478X
  • Penaranda-Foix, Felipe L.|||0000-0003-4012-0763
  • Busquets Mataix, David Jeronimo|||0000-0001-5031-7805
  • Pruna, Alina Iuliana
  • Pullini, Daniele
A fast approach based on microwave technology was employed for the sintering of novel composites of alumina and using graphene oxide (GO) as susceptor. The thermal stability and structure of GO materials produced by chemical oxidation of graphite were characterized. The morphology, structure and mechanical properties of the composites sintered by microwave approach were reported to the counterparts sintered by conventional method. The results indicated the formation of an interconnecting graphene network promoted the electrical conductivity in the composite having only 2 wt.% GO. Hardness and elastic modulus decreased significantly in samples sintered by conventional method due to lower values of density while microwave technology allowed to achieve a positive effect on the densification and showed a smaller grain size when compared to the one achieved by conventional heating. (C) 2014 Elsevier Ltd. All rights reserved., Financial support from European Commission (project no. NMP3-SL-2010-246073), Universidad Politecnica de Valencia (project SP20120677) and Ministerio de Economia y Competitividad - MINECO (project TEC2012-37532-C02-01, co-funded by ERDF (European Regional Development Funds) is gratefully acknowledged. A.B. acknowledges the Spanish Ministry of Science and Innovation (contract JCI-2011-10498). A.P. acknowledges support from Romanian Authority for Scientific Research - UEFISCDI (project no. PN-II-RU-PD-2012-3-0124).