Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Highly efficient heterogeneous modal superposition method for the full-wave analysis of arbitrarily shaped H-plane structures fed through rectangular waveguides

  • Belenguer Martínez, Ángel
  • Lucas Borja, Alejandro
  • Cascón López, Joaquín
  • Esteban González, Héctor|||0000-0002-5936-658X
  • Boria Esbert, Vicente Enrique|||0000-0001-7150-9785
A new fully modal characterisation procedure is proposed to reduce the number of unknowns needed to characterise the ports of an arbitrary H-plane device in rectangular waveguide, so that no equivalent currents will be involved in the characterisation of the ports. Moreover, since no currents are needed to characterise the ports, the weights of the scattered modes can be unknowns of the resulting system of equations. This is an important fact, since, to find the wanted modal weights, a subsequent projection step is not necessary anymore. The new method is then advantageous when compared to other hybrid alternatives in the literature, not only because the ports are solved using fewer unknowns, which is the main advantage of the proposal, but also because the scattering parameters can be computed directly, once the system of equations is posed., This work was supported by Ministerio de Ciencia e Innovacion, Spanish Government, under Research Project TEC2007-67630-C03-01 and by the Autonomous Government of Castilla-La Mancha under Research Project PPII10-0047-0220.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Dual Composite Right-/Left-Handed Coplanar Waveguide Transmission Line Using Inductively Connected Split-Ring Resonators

  • Belenguer Martínez, Ángel
  • Cascón López, Joaquín
  • Lucas Borja, Alejandro
  • Esteban González, Héctor|||0000-0002-5936-658X
  • Boria Esbert, Vicente Enrique|||0000-0001-7150-9785
In this paper, a simple geometrical modification of the well-known split-ring resonator (SRR) topology is proposed. This modification consists of joining the opposite sides of the rings by means of an inductive connection. Due to this modification, it is possible to synthesize a dual composite right-/left-handed artificial transmission line from a host coplanar waveguide (CPW). In addition, it is quite straightforward to synthesize a dual balanced line showing a wider transmission bandwidth (around 13% for 3 GHz and 8% for 6 GHz) with this new SRR geometry. In fact, in order to design a balanced line, one must just modify the inductance of the direct connection between the rings, which can be derived from the equivalent circuit of this new ring, which is also presented in this paper. The final result is a balanced artificial CPW transmission line with a dual composite right-/left-handed behavior. In this case, the right-handed transmission band is placed below the left-handed one, and there is no frequency separation between both transmission bands. © 1963-2012 IEEE., This work was supported in part by the Ministerio de Ciencia e Innovacion, Spanish Goverment, under Research Projects TEC2010-21520-C04-03 and TEC2010-21520-C04-01 and by the Autonomous Government of Castilla-La Mancha under Research Projects PPII10-0047-0220 and PPII10-0027-1277.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Novel empty substrate integrated waveguide for high performance microwave integrated circuits

  • Belenguer Martínez, Ángel
  • Esteban González, Héctor|||0000-0002-5936-658X
  • Boria Esbert, Vicente Enrique|||0000-0001-7150-9785
Abstract Over the last years, a great number of substrate integrated circuits has been developed. These new circuits are a compromise between the advantages of classical waveguide technologies, such as high quality factor and low losses, and the advantages of planar circuits, such as low cost and easy compact integration. Although their quality factor and losses are better than for planar circuits, these characteristics are worse than in the case of waveguides, mainly due to the presence of the dielectric substrate. In order to improve the performance of the integrated circuits, a new methodology for manufacturing empty waveguides, without a dielectric substrate, but at the same time completely integrated in a planar substrate, is proposed in this work. A wideband transition with return losses greater than 20 dB in the whole bandwith of the waveguide allows the integration of the empty waveguide into the planar substrate so that the waveguide can be directly accessed with a microstrip line. Therefore, a microwave circuit integrated in a planar substrate, but at the same time with a very high quality factor (measured quality factor is 4.5 times higher than for the same filter in the substrate integrated waveguide), and very low losses is successfully achieved., This work was supported by the Ministerio de Ciencia e Innovacion, Spanish Goverment, under Research Project TEC2010-21520-C04-03 and Research Project EC2010-21520-C04-01, and by the Autonomous Government of Castilla-La Mancha under Research Project PPII10-0047-0220.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Broadband Equivalent Circuit Model for a Coplanar Waveguide Line Loaded with Split Ring Resonators

  • Sanz, Victor
  • Belenguer Martínez, Ángel
  • Lucas Borja, Alejandro
  • Cascón López, Joaquín
  • Esteban González, Héctor|||0000-0002-5936-658X
  • Boria Esbert, Vicente Enrique|||0000-0001-7150-9785
A new equivalent circuit for a coplanar waveguide loaded with split ring resonators is presented. The traditional circuits that model these devices are only able to characterize the left-handed propagation band, and their response is very similar to the real one within a very limited bandwidth. In contrast, this proposed broadband equivalent circuit is able to portray not only the left-handed propagation band, but also the right-handed one that occurs at higher frequencies. Besides, the response of this kind of basic cells can be adjusted with the proposed circuit model in a bandwidth close to a decade., This work was supported by the Ministerio de Ciencia e Innovacion, Spanish Goverment, under Research Projects TEC2010-21520-C04-03 and -01, and by the Autonomous Government of Castilla-La Mancha under Research Projects PPII10-0047-0220 and PPII10-0027-1277.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Balanced Dual Composite Right/Left-Handed Microstrip Line With Modified Complementary Split-Ring Resonators

  • Belenguer Martínez, Ángel
  • Lucas Borja, Alejandro
  • Boria Esbert, Vicente Enrique|||0000-0001-7150-9785
This letter presents a dual composite right/left-handed microstrip line loaded with modified complementary split-ring resonators. In this particular case, the well-known resonant particle employed has been capacitively loaded in order to obtain a balanced frequency response. The inclusion of this capacitive element has two main effects. On the one hand, the right-and left-handed bands are interchanged; on the other hand, the possibility to control the position of the right-handed band, while maintaining the left-handed one unaltered. Consequently, it is relatively simple to design balanced transmission lines with improved bandwidth and reconfigurable properties. In addition, the equivalent circuit that describes the electromagnetic behavior of the structure has been obtained. Finally, a prototype has been fabricated and measured to confirm experimentally the validity of the proposed design., This work was supported by the Ministerio de Ciencia e Innovacion, Spanish Goverment, under Research ProjectsTEC2010-21520-C04-03 and -01 and the Autonomous Government of Castilla-La Mancha under Research Projects PPII10-0047-0220 and PPII10-0027-1277.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Hybrid Technique Plus Fast Frequency Sweep for the Efficient and Accurate Analysis of Substrate Integrated Waveguide Devices

  • Belenguer Martínez, Ángel
  • Díaz Caballero, Elena
  • Cascón López, Joaquín
  • Esteban González, Héctor|||0000-0002-5936-658X
  • Bachiller Martin, Maria Carmen|||0000-0002-5518-5060
  • Boria Esbert, Vicente Enrique|||0000-0001-7150-9785
In this paper, we adapt a novel mode-matching and method-of-moments hybrid technique to efficiently analyze substrate integrated waveguide (SIW) based devices. The hybrid technique is formulated in terms of a single equivalent current. This fact is used to include the emergent modal weights, i.e., the scattering parameters, as unknowns of the method-of-moments system of equations. In this case, it is relatively easy to develop fast frequency sweep schemes that can be used to highly accelerate the solution of an arbitrary device and, as a result, a very efficient technique is obtained. This technique can be applied to the analysis and design of SIW devices, and it is highly competitive when compared to other method-of-moments and mode-matching hybrid formulations or when compared to reference commercial software. © 2006 IEEE., This work was supported by the Ministerio de Ciencia e Innovacion, Spanish Government, under Research Project TEC2007-67630-C03-01 and by the Autonomous Government of Castilla-La Mancha under Research Project PPII10-0047-0220.