Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 4
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Otros (Other)

Iron-based carbon xerogels for metal-air batteries

  • Alegre Gresa, Cinthia
  • Villanueva, Nicolás
  • Pérez Rodríguez, Sara
  • Lázaro Elorri, María Jesús
1 figure.--P32.-- Abstract of the poster presented at the CESEP’19 Conference: 8th International Conference on Carbon for Energy Storage and Environment Protection, October 20-24th, Alicante (Spain).-- © Universidad de Alicante., Metal-air batteries (MABs) are foreseen as a new generation device aiming to replace Li-ion batteries (LIBs). MABs present a higher theoretical energy density, lower cost, environmental friendliness, and safety. In particular, iron-based materials are cheap and easily obtained, and so they can be used for both the negative electrode and the positive electrode in MABs [1]. Here, Fe-doped carbon xerogels were synthesized in order to be tested as both positive and negative electrodes of iron-air batteries., The authors thank Gobierno de Aragón for their economical support to Grupo de Conversión de Combustibles (T06_17R). C. Alegre acknowledges CSIC for her Juan de la Cierva contract., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Sulfur-doped carbon nanofibers as support for tantalum oxides bifunctional catalysts for the oxygen reduction and evolution reactions

  • Ruiz Cornejo, Juan Carlos
  • Sebastián del Río, David
  • Pardo, Juan Ignacio
  • Martínez Huerta, M. Victoria
  • Lázaro Elorri, María Jesús
10 figures, 7 tables.-- Supplementary information available., Highly efficient, low-cost and stable bifunctional catalysts for oxygen reduction reaction (ORR) and oxygen evolution reaction (OER) are highly desirable for the development of green electrochemical energy storage and conversion devices. Here, we report the synthesis of sulfur-doped carbon nanofibers (CNF) as support for tantalum oxide nanoparticles. Carbon nanofibers and tantalum oxides represent a durable choice for oxygen electrocatalysis, but an improvement of catalytic activity is required. Upon doping, sulfur is found to be mainly bonded to carbon as C–S–C species (more than 80%). The results show that the effective incorporation of sulfur in the support has a clear positive effect on the electroactivity of the tantalum oxide catalysts. It causes a decrease of OER/ORR overpotential of 80 mV with respect to the undoped counterpart, with special improvement in the ORR. The new catalysts have shown an interesting bifunctional behavior for the OER and ORR, as well as a good stability through time., The authors wish to acknowledge the grants PID2020-115848RB-C21 and PID2020-115848RB-C22 funded by MCIN/AEI/10.13039/501100011033, and to the Gobierno de Aragón (DGA) for the funding to Grupo de Conversión de Combustibles (T06_17R). J.C. Ruiz-Cornejo acknowledges also DGA for his PhD grant., Peer reviewed
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publication Artículo científico (JournalArticle)

Optimization of the catalytic layer for alkaline fuel cells based on fumatech membranes and ionomer

  • Sebastián, D.
  • Lemes, G.
  • Luque-Centeno, J.M.
  • Martínez-Huerta, M.V.
  • Pardo, J.I.
  • Lázaro, M.J.
Polymer electrolyte fuel cells with alkaline anion exchange membranes (AAEMs) have gained increasing attention because of the faster reaction kinetics associated with the alkaline environment compared to acidic media. While the development of anion exchange polymer membranes is increasing, the catalytic layer structure and composition of electrodes is of paramount importance to maximize fuel cell performance. In this work, we examine the preparation procedures for electrodes by catalyst-coated substrate to be used with a well-known commercial AAEM, Fumasep® FAA-3, and a commercial ionomer of the same nature (Fumion), both from Fumatech GmbH. The anion exchange procedure, the ionomer concentration in the catalytic layer and also the effect of membrane thickness, are investigated as they are very relevant parameters conditioning the cell behavior. The best power density was achieved upon ion exchange of the ionomer by submerging the electrodes in KCl (isopropyl alcohol/water solution) for at least one hour, two exchange steps, followed by treatment in KOH for 30 min. The optimum ionomer (Fumion) concentration was found to be close to 50 wt%, with a relatively narrow interval of functioning ionomer percentages. These results provide a practical guide for electrode preparation in AAEM-based fuel cell research.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publication Artículo científico (JournalArticle)

Sulfur-doped carbon nanofibers as support for tantalum oxides bifunctional catalysts for the oxygen reduction and evolution reactions

  • Ruiz-Cornejo, Juan Carlos
  • Sebastián, David
  • Pardo, Juan Ignacio
  • Martínez-Huerta, María Victoria
  • Lázaro, María Jesús
Highly efficient, low-cost and stable bifunctional catalysts for oxygen reduction reaction (ORR) and oxygen evolution reaction (OER) are highly desirable for the development of green electrochemical energy storage and conversion devices. Here, we report the synthesis of sulfur-doped carbon nanofibers (CNF) as support for tantalum oxide nanoparticles. Carbon nanofibers and tantalum oxides represent a durable choice for oxygen electrocatalysis, but an improvement of catalytic activity is required. Upon doping, sulfur is found to be mainly bonded to carbon as C–S–C species (more than 80%). The results show that the effective incorporation of sulfur in the support has a clear positive effect on the electroactivity of the tantalum oxide catalysts. It causes a decrease of OER/ORR overpotential of 80 mV with respect to the undoped counterpart, with special improvement in the ORR. The new catalysts have shown an interesting bifunctional behavior for the OER and ORR, as well as a good stability through time.