Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publication Artículo científico (JournalArticle)

Interoperability in digital electrocardiography: Harmonization of ISO/IEEE x73-PHD and SCP-ECG

  • Trigo Vilaseca, Jesús Daniel
  • Chiarugi, Franco
  • Alesanco, Álvaro
  • Martínez de Espronceda Cámara, Miguel
  • Serrano Arriezu, Luis Javier
  • Chronaki, Catherine E
  • Escayola Calvo, Javier
  • Martínez Ruiz, Ignacio
  • García, José
The ISO/IEEE 11073 (x73) family of standards is a reference frame for medical device interoperability. A draft for an ECG device specialization (ISO/IEEE 11073-10406-d02) has already been presented to the Personal Health Device (PHD) Working Group, and the Standard Communications Protocol for Computer-Assisted ElectroCardioGraphy (SCP-ECG) Standard for short-term diagnostic ECGs (EN1064:2005+A1:2007) has recently been approved as part of the x73 family (ISO 11073-91064:2009). These factors suggest the coordinated use of these two standards in foreseeable telecardiology environments, and hence the need to harmonize them. Such harmonization is the subject of this paper. Thus, a mapping of the mandatory attributes defined in the second draft of the ISO/IEEE 11073-10406-d02 and the minimum SCP-ECG fields is presented, and various other capabilities of the SCP-ECG Standard (such as the messaging part) are also analyzed from an x73-PHD point of view. As a result, this paper addresses and analyzes the implications of some inconsistencies in the coordinated use of these two standards. Finally, a proof-of-concept implementation of the draft x73-PHD ECG device specialization is presented, along with the conversion from x73-PHD to SCP-ECG. This paper, therefore, provides recommendations for future implementations of telecardiology systems that are compliant with both x73-PHD and SCP-ECG., This work was supported in part by the Innovation and Science Ministry (MICINN) and the European Regional Development Fund under Project TIN-2011-23792, and in part by the Ministry of Industry, Tourism and Trade (MITyC) under Project TSI-020100-2010-277.
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publication Artículo científico (JournalArticle)

Implementation methodology for interoperable personal health devices with low-voltage low-power constraints

  • Martínez de Espronceda Cámara, Miguel
  • Serrano Arriezu, Luis Javier
  • Led Ramos, Santiago
  • Trigo Vilaseca, Jesús Daniel
  • Marzo Pérez, Asier
  • Escayola Calvo, Javier
  • García, José Ángel
Traditionally, e-Health solutions were located at the point of care (PoC), while the new ubiquitous user-centered paradigm draws on standard-based personal health devices (PHDs). Such devices place strict constraints on computation and battery efficiency that encouraged the International Organization for Standardization/IEEE11073 (X73) standard for medical devices to evolve from X73PoC to X73PHD. In this context, low-voltage low-power (LV-LP) technologies meet the restrictions of X73PHD-compliant devices. Since X73PHD does not approach the software architecture, the accomplishment of an efficient design falls directly on the software developer. Therefore, computational and battery performance of such LV-LP-constrained devices can even be outperformed through an efficient X73PHD implementation design. In this context, this paper proposes a new methodology to implement X73PHD into microcontroller-based platforms with LV-LP constraints. Such implementation methodology has been developed through a patterns-based approach and applied to a number of X73PHD-compliant agents (including weighing scale, blood pressure monitor, and thermometer specializations) and microprocessor architectures (8, 16, and 32 bits) as a proof of concept. As a reference, the results obtained in the weighing scale guarantee all features of X73PHD running over a microcontroller architecture based on ARM7TDMI requiring only 168 B of RAM and 2546 B of flash memory., This work was supported in part by Comisión Interministerial de Ciencia y Tecnología (CICYT) and European Regional Development Fund (ERDF) under Project TIN-2009-08414 and Project TIN-2008-00933/TSI, and by Ministerio de Industria, Turismo y Comercio, and FPI Grant to M. Martínez-Espronceda (Res.1342/2006 Public University of Navarre) under Project TSI-020100-2010-277, Project TSI-020302-2009-89, and Project TSI-020302-2009-7/Plan Avanza I+D.