- Navarro, Marta
- Paseta, Lorena
- Echaide‐Górriz, Carlos
- Benito, Javier
- Gascón, Ignacio
- Coronas, Joaquín
- Téllez, Carlos
Póster presentado al Microscopy at the Frontiers of Science Congress Series (MFS), celebrado en el Parque de las Ciencias de Granada (España) del 11 al 13 de septiembre de 2019., Thin film composite (TFC) membranes consist of a polyamide (PA) thin film (35-100 nm thick) as a selective layer, grown via interfacial polymerization (IP) of monomeric acid chlorides and amines on top of an asymmetric polyimide support, cast over a polypropylene non-woven backing material by phase inversion. This type of
membrane is very competitive for organic solvent nanofiltration, where chemical stable polymers are mandatory. In order to increase membrane flux without decreasing rejection, nanoparticles are incorporating during the IP process, giving rise to Thin film nanocomposite (TFN) membranes (Fig. 1a). Their performance is determined by the structural and physicochemical properties of the fillers and PA thin film. Metal organic
frameworks (MOFs), built from organic linkers and metal-containing clusters, have been extensively included as fillers in TFN membranes, showing exceptional affinity with polymer chains and improved solvent permeation. The combination of nanoscale visualization via conventional Transmission electron microscopy (TEM) and Scanning transmission electron microscopy (STEM), and spectroscopic analysis via energy dispersive X-ray spectroscopy (EDX) and Electron energy loss spectroscopy (EELS), are some of the most potent techniques for shedding further light into the connection between the nanostructure of the MOF-PA film and their transport and rejection properties. Sample preparation is a key step to examine the presence, distribution and morphology of MOF nanoparticles within the PA film, but also to confirm their crystallinity after the IP process by electron microscopy, given the multilayer and heterogeneous character of these membranes and but also because of the beamsensitive nature of MOFs. Here, we report different sample preparation protocols for applying TEM, STEM-EDS/EELS and electron diffraction depending on the nature of the TFN sample and on the characterization aim: 1. When the aim was to confirm the presence, distribution and morphology of two types of MOFs of different chemical composition in the PA layer, a fragment of the MOF-PA film was detached from the polyimide support in the last stage of the IP process. The fragment was removed from the distilled water bath and placed onto a carbon film grid. TEM and STEM-EDS techniques were applied. 2. When the objective was to check the distribution of the MOF nanoparticles within the TFN membrane and their crystallinity, a MOF-TFN membrane was synthesized over a non-crosslinked polyimide support without backing material. Then, the membrane was immersed in N,N-dimethylformamide at room temperature for 5 min to dissolve the polyimide support. The separated PA top layer was placed onto a carbon film grid. TEM and electron diffraction were applied. 3. When the goal was to verify the presence of a defect free MOF monolayer film in between the two polymer layers (Fig. 1b), transferred by the Langmuir-Schaefer (LS) technique, a lamella (∼80 nm thick) was obtained from the upper 2 μm of the TFN membrane using cryo-focused ion beam (FIB) equipment (Dual Beam 3 Nova 200) and Ga atoms for the etching. STEM-EDS/EELS techniques were applied (Fig. 1c)., Financial support from the Research Project MAT2016-77290-R (MINECO/AEI/FEDER, UE) is gratefully acknowledged., Peer reviewed