Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 3
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Dip-in Nanomechanical Probes for Mass Characterization of Nanoparticles in Ultra-Low Volume Liquid Suspensions

  • Molina, Juan
  • Escobar, Javier E.
  • Kosaka, Priscila M.
  • Malvar, Óscar
  • Ruz, José J.
  • Tamayo, Javier
  • San Paulo, Álvaro
  • Calleja, Montserrat
The mass of nanoparticles has a critical influence on their phenomenology and functional performance, driving the need for measurement tools that combine high-throughput with high-resolution single-particle analysis. Mass characterization of large nanoparticle populations under such demands remains a persistent challenge, particularly for nanoparticles of large mass, where consolidated techniques encounter limitations. Here, a dip-in nanomechanical probe sensing approach for weighing nanoparticles in liquid suspensions which simultaneously provides high mass resolution and sensing rate is demonstrated. The method relies on nanoparticle transfer to nanowire resonator probes via iterative immersion into the suspension, requiring minimal volume and resulting in negligible losses. It also introduces ionic liquids as suspension media, enabling vacuum operation for optimizing mass resolution through single-mode resonance frequency tracking of the probes. Additionally, implementing acoustofluidic actuation on the suspension regulates nanoparticle adsorption/desorption during immersion, significantly enhancing the sensing rate. Measurements of 30 nm gold nanoparticles demonstrate accurate characterization of their mass distribution with a probe resolution of 0.1 ag, a sensing rate of 38 NPs min-1, and a sample volume of a few nanoliters. The concurrent advances in all these performance characteristics reveal the potential of dip-in nanomechanical probes for precise and fast characterization of individual nanoparticles over a wide mass range., This work was supported by the European Union (HORIZON-EIC-2022-PATHFINDEROPEN Project VIRUSONG 101099058 and ERC-2023-PoC Project VIR-Quantify 101157423) and by the Spanish MCIN (project AEROMECH PID2021-128395OB-I00 funded by MCIN/AEI/10.13039/501100011033/FEDER-UE with related predoctoral grant PRE2022-101661; project VIROMECH PDC2022-133944-I00 funded by MCIN/AEI/10.13039/501100011033 and European Union “NextGenerationEU”/ PRTR). We acknowledge the service from the MiNa Laboratory at IMN, and funding from EU (FEDER, FSE), MCIN/AEI/10.13039/501100011033 and Next Generation EU/PRTR (EQC2021-006944-P)., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Mass and stiffness sensing performance of nanomechanical resonators: viability of infectious virus detection

  • Gómez-Moreno, Manuel
  • Molina, Juan
  • Ruz, José J.
  • Malvar, Óscar
  • Tamayo, Javier
  • Calleja, Montserrat
  • San Paulo, Álvaro
We examine the performance of nanomechanical resonators for mass and stiffness sensing of nanoparticulate analytes with focus on their application for untargeted infectious virus detection. The characteristic narrow mass distributions of viruses, together with the existing correlations between their stiffness and infectivity, point out to nanomechanical sensors as a particularly suited alternative to molecular detection techniques, constrained by limited processing speed, target-specificity, and the inability to directly assess infectivity. We present a theoretical analysis of the response of flexural beam resonators to the adsorption of nanoparticulate analytes, and derive analytical expressions for the mass and stiffness sensing responsivity, resolution and signal to noise ratio as a function of the beam characteristics and analyte adsorption parameters. We demonstrate that both the mass and stiffness of viruses can contribute to resonance frequency shifts that significantly exceed the fundamental detection limits of beams with plausible dimensions and for realistic adsorption parameters. Particularly, stiffness resolution can reach levels well below the stiffness variations observed in some viruses as a consequence of maturation, enabling an integrated approach for infectivity assessment. We conclude that the practical application of nanomechanical spectrometry for infectious virus detection is not limited by the performance of state-of-the-art sensor technology, but by the efficiency of analyte delivery methods, encouraging future research on optimizing their implementation., This work was supported by the European Union (HORIZON-EIC-2022-PATHFINDEROPEN Project VIRUSONG 101099058 and ERC-2023-PoC Project VIR-Quantify 101157423) and by the Spanish MCIN (project AEROMECH PID2021-128395OB-I00 funded by MCIN/AEI/https://doi.org/10.13039/501100011033/FEDER-UE with related predoctoral grant PRE2022-101661; project VIROMECH PDC2022-133944-I00 funded by MCIN/AEI/https://doi.org/10.13039/501100011033 and European Union “NextGenerationEU”/ PRTR)., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Multiparametric quantification of bacterial cells using digital holographic microscopy

  • Cano-Tortajada, Álvaro
  • Sanz-Jiménez, Adrián
  • Malvar, Óscar
  • Ruz Martínez, José Jaime
  • Kosaka, Priscila M.
  • García-López, Sergio
  • Calleja, Montserrat
  • Tamayo de Miguel, Francisco Javier
The detection and quantification of the physical properties of bacterial cells are crucial for advancing precision microbiology. Here, we use digital holographic microscopy (DHM) to measure the dry mass of individual Staphylococcus epidermidis (S. epidermidis) and Escherichia coli (E. coli) cells with high throughput and rapid acquisition. We demonstrate that by processing quantitative phase images with polynomial background correction, Gaussian filtering, and adaptive masking, we are able to obtain, not only the dry mass of individual bacterial cells, but also detailed morphological information. These features allow the discrimination between single and clustered cocci, as well as the identification of elongation patterns in bacilli, that may provide relevant indicators of bacterial growth and physiological state. Finally, we compare the DHM dry mass distribution with those obtained by nanomechanical mass spectrometry (NMS), highlighting the potential and limitations of each technique., This work was supported by the European Union through HORIZON-EIC-2022-PATHFINDEROPEN Project VIRUSONG 101099058, by the Spanish MCIN through projects “CELLBIOPHYS” (PID2021-126993OB-I00/MCIN/AEI/10.13039/501100011033/FEDER, UE), “ONCODEEPLASM” (PLEC2021–007892/MCIN/AEI/10.13039/501100011033/European Union/ Next Generation EU/PRTR) and by Comunidad Autónoma de Madrid (S2022/BMD-7437, i-LUNG 20). This work has also been supported by FERO Fundación Elena Torres Cancer Association funding. We acknowledge the service from MiNa Laboratory at IMN, and founding from EU (FEDER, FSE), MCIN/AEI/10.13039/50110001.1033 and Next Generation EU/PRTR (EQC2021-006944-P)., Peer reviewed