Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 4
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Plasma Assisted Oblique Angle Deposition of Transparent and Conductive in-Plane Anisotropic ITO Thin Films

  • Parra-Barranco, J.
  • Sánchez-Valencia, J. R.
  • Aparicio, Francisco J.
  • Ferrer, F. J.
  • García-García, Francisco J.
  • Rico, Víctor J.
  • López-Santos, Carmen
  • Borrás, Ana
  • González-Elipe, Agustín R.
  • Barranco, Ángel
Oblique angle deposition (OAD) is a powerful technique for the fabrication of porous nanostructured oxide thin films. OAD films typically present a columnar tilted nanostructure due to geometrical shadowing effects during the thin film growth. In this work, we study the fabrication of transparent and conducting indium tin oxide films (ITO) by OAD assisted by a microwave ECR plasma. The objective of assisting the deposition with a plasma discharge is to modify the growth mechanism of the OAD process introducing additional parameters to control the columnar microstructure, composition, porosity of the films. The results indicate the OAD ITO deposition assisted by the plasma discharge is a very effective process to develop in-plane structural anisotropy in the ITO nanocolumnar films what determines their electrical properties., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Self-assembly of the non-planar Fe(III) phthalocyanine small-molecule: unraveling the impact on the magnetic properties of organic nanowires

  • Filippin, Nicolas
  • López-Flores, Víctor
  • Rojas, T. Cristina
  • Saghi, Zineb
  • Rico, Víctor J.
  • Sánchez-Valencia, J. R.
  • Espinós, J.P.
  • Zitolo, Andrea
  • Viret, Michel
  • Midgley, Paul A.
  • Barranco, Ángel
  • Borrás, Ana
In this article we show for the first time the formation of magnetic supported organic nanowires (ONWs) driven by self-assembly of a nonplanar Fe(III) phthalocyanine chloride (FePcCl) molecule. The ONWs grow by a crystallization mechanism on roughness-tailored substrates. The growth methodology consists of a vapor deposition under low vacuum and mild temperature conditions. The structure, microstructure, and chemical composition of the FePcCl NWs are thoroughly elucidated and compared with those of Fe(II) phthalocyanine NWs by a consistent and complementary combination of advanced electron microscopies and X-ray spectroscopies. In a further step, we vertically align the NWs by conformal deposition of a SiO2 shell. Such orientation is critical to analyze the magnetic properties of the FePcCl and FePc supported NWs. A ferromagnetic behavior below 30 K with an easy axis perpendicular to the phthalocyanine plane was observed in the two cases with the FePcCl nanowires presenting a wider hysteresis. These results open the path to the fabrication of nanostructured one-dimensional small-molecule spintronic devices., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

The role of surface recombination on the performance of perovskite solar cells: effect of morphology and crystalline phase of TiO2 contact

  • Idígoras, Jesús
  • Contreras-Bernal, Lidia
  • Cave, James M.
  • Courtier, Nicola E.
  • Barranco, Ángel
  • Borrás, Ana
  • Sánchez-Valencia, J. R.
  • Anta, Juan A.
  • Walker, Alison B.
Herein, the preparation of 1D TiO nanocolumnar films grown by plasma-enhanced chemical vapor deposition is reported as the electron selective layer (ESL) for perovskite solar devices. The impact of the ESL architecture (1D and 3D morphologies) and the nanocrystalline phase (anatase and amorphous) is analyzed. For anatase structures, similar power conversion efficiencies are achieved using an ESL either the 1D nanocolumns or the classical 3D nanoparticle film. However, lower power conversion efficiencies and different optoelectronic properties are found for perovskite devices based on amorphous 1D films. The use of amorphous TiO as electron selective contact produces a bump in the reverse scan of the current–voltage curve as well as an additional electronic signal, detected by impedance spectroscopy measurements. The dependence of this additional signal on the optical excitation wavelength used in the IS experiments suggests that it stems from an interfacial process. Calculations using a drift-diffusion model which explicitly considers the selective contacts reproduces qualitatively the main features observed experimentally. These results demonstrate that for a solar cell in which the contact is working properly the open-circuit photovoltage is mainly determined by bulk recombination, whereas the introduction of a “bad contact” shifts the balance to surface recombination., The authors thank Junta de Andalucía for financial support via grant FQM 1851 and FQM 2310. The authors thank Ministerio de Economía y Competitividad of Spain and Agencia Estatal de Investigación (AEI) and EU (FEDER) under grants MAT2013‐47192‐C3‐3‐R, MAT2016‐76892‐C3‐2‐R, MAT2016‐79866‐R and Red de Excelencia “Emerging photovoltaic Technologies” for financial support. J.R.S.‐V. and A.B. acknowledge Marie Skłodowska‐Curie ActionsH2020‐MSCA‐IF‐2014 PlasmaPerovSol grant (Project ID 661480) and the University of Seville through the VI PPIT‐US. J.M.C. and N.E.C. were supported by EPSRC funded studentships from the CDT in New and Sustainable Photovoltaics (reference EP/L01551X/1). A.B.W. was supported by the Energy oriented Centre of Excellence (EoCoE), Horizon2020 grant research number 676629.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Enhanced stability of perovskite solar cells incorporating dopant-free Crystalline spiro-OMeTAD layers by vacuum sublimation

  • Barranco, Ángel
  • López-Santos, Carmen
  • Idígoras, Jesús
  • Aparicio, Francisco J.
  • Obrero-Pérez, José M.
  • López-Flores, Víctor
  • Contreras-Bernal, Lidia
  • Rico, Víctor J.
  • Ferrer, F. J.
  • Espinós, J.P.
  • Borrás, Ana
  • Anta, Juan A.
  • Sánchez-Valencia, J. R.
The main handicap still hindering the eventual exploitation of organometal halide perovskite-based solar cells is their poor stability under prolonged illumination, ambient conditions, and increased temperatures. This article shows for the first time the vacuum processing of the most widely used solid-state hole conductor (SSHC), i.e., the Spiro-OMeTAD [2,2′,7,7′-tetrakis (N,N-di-p-methoxyphenyl-amine) 9,9′-spirobifluorene], and how its dopant-free crystalline formation unprecedently improves perovskite solar cell (PSC) stability under continuous illumination by about two orders of magnitude with respect to the solution-processed reference and after annealing in air up to 200 °C. It is demonstrated that the control over the temperature of the samples during the vacuum deposition enhances the crystallinity of the SSHC, obtaining a preferential orientation along the π–π stacking direction. These results may represent a milestone toward the full vacuum processing of hybrid organic halide PSCs as well as light-emitting diodes, with promising impacts on the development of durable devices. The microstructure, purity, and crystallinity of the vacuum sublimated Spiro-OMeTAD layers are fully elucidated by applying an unparalleled set of complementary characterization techniques, including scanning electron microscopy, X-ray diffraction, grazing-incidence small-angle X-ray scattering and grazing-incidence wide-angle X-ray scattering, X-ray photoelectron spectroscopy, and Rutherford backscattering spectroscopy., The authors thank the “Agencia Estatal de Investigación”, “Consejería de Economía y Conocimiento de la Junta de Andalucía” (US‐1263142), “Ministerio de Economía y Competitividad” (MAT2016‐79866‐R, MAT2013‐42900‐P, FPA2016‐77689‐C2‐1‐R, and MAT2016‐76892‐C3‐2‐R) and the European Union (EU) through cohesion fund and FEDER 2014‐2020 programs for financial support. J.R.S.‐V. and A.B. acknowledge the EU project PlasmaPerovSol and funding from the European Union's Horizon 2020 research and innovation programme under the Marie Skłodowska‐Curie grant agreement ID 661480. J.R.S.‐V‐ and M.C.L.‐S. thank the University of Seville through the VI “Plan Propio de Investigación y Transferencia de la US” (VI PPIT‐US). This research has received funding from the EU‐H2020 research and innovation programme under Grant Agreement No. 654360 having benefitted from the access provided by Technische Universität Graz at Elettra—TUG in Trieste (IT) within the framework on the NFFA (Nanoscience Foundries & Fine Analysis) Europe Transnational Access Activity. F.J.A. and J.R.S.‐V. acknowledge the “Juan de la Cierva” and “Ramon y Cajal” national programs, respectively.