Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 3
Encontrada(s) 1 página(s)

Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

An approach to the integrated design of PCM-air heat exchangers based on numerical simulation: a solar cooling case study

  • Dolado Bielsa, Pablo
  • Lázaro Fernández, Ana
  • Delgado Gracia, Mónica
  • Peñalosa García, Conchita
  • Mazo Olarte, Javier
  • Marín Herrero, José María
  • Zalba Nonay, Belén
A novel technique of design of experiments applied to numerical simulations is proposed in this paper as a methodology for the sizing and design of thermal storage equipment integrated in any specific application. The technique is carried out through the response surfaces in order to limit the number of simulation runs required to achieve an appropriate solution. Thus, there are significant savings on the time spent on the design as well as a potential cost saving on the experimentation if similarity relationships between the prototype and the model are met. The technique is applied here to a previously developed and validated numerical model that simulates the thermal behavior of a phase change material-air heat exchanger. The incorporation of the thermal energy storage unit is analyzed in the case of a solar cooling application, improving the system coefficient of performance. The economic viability is mainly conditioned by the price of the macroencapsulated phase change material.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Experimental analysis of the influence of microcapsule mass fraction on the thermal and rheological behavior of a PCM slurry

  • Delgado,M.
  • Lázaro,A.
  • Peñalosa,C.
  • Zalba,B .
A microencapsulated PCM (Phase Change Material) slurry with three different PCM mass fractions (14, 20 and 30%) has been analyzed. The present study investigates the influence of the PCM microcapsule mass fraction on the thermal and rheological characterization. Specifically, the EnthalpyeTemperature curves, the Thermal ConductivityeTemperature curves and the ViscosityeShear rate curves have been determined In addition, the physical stability under thermo-mechanical cycles has also been studied, as well as the heat transfer phenomenon and the fluid mechanics. The results have shown an enhancement in the heat transfer phenomenon, the slurry with 20% PCM microcapsules being the best option for use as a heat transfer fluid. Rupture of the PCM microcapsules was only observed for the slurry with 30% PCM microcapsules, after being pumped during three weeks and having experienced 10,000 solidification emelting cycles.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Modeling a radiant floor system with Phase Change Material (PCM) integrated into a building simulation tool: Analysis of a case study of a floor heating system coupled to a heat pump

  • Mazo, J.
  • Delgado, M.
  • Marin, J. M.
  • Zalba, B.
This work describes a model developed to simulate a radiant floor system with PCM in simple building types. The building simulation model has been validated by comparing its behavior with Energy Plus. The PCM radiant floor model is based on a one-dimensional finite difference scheme where the effective capacity method is used for PCM simulation. Some adjustments have been made to this one-dimensional scheme so that the thermal effect of two-dimensional heat transfer within the radiant floor slab is taken into account. The results of an analyzed case study are also presented in this paper. Here, the PCM floor heating system is fed by a heat pump which mainly operates during night time, thus reducing the costs of electric energy consumption.