Pasar al contenido principal

Development and advanced characterisation of chalcogenides technologies for efficient solar devices

IJC2018-038199-I

•
Nombre agencia financiadora Agencia Estatal de Investigación
Acrónimo agencia financiadora AEI
Programa Programa Estatal de Promoción del Talento y su Empleabilidad en I+D+i
Subprograma Subprograma Estatal de Incorporación
Convocatoria Juan de la Cierva Incorporación
Año convocatoria 2018
Plan Estatal 2017-2020 Plan Estatal de Investigación Científica y Técnica y de Innovación
Centro beneficiario FUNDACIO INSTITUT DE RECERCA DE L ENERGIA DE CATALUNYA

Resultados relacionados

Resultados totales (Incluyendo duplicados): 4
Encontrada(s) 1 página(s)

Dipòsit Digital de Documents de la UAB
Publicación Artículo científico (JournalArticle)

2D nanosheet SnS2 solution-processed photoanodes, Unveiling enhanced visible light absorption for solar fuels applications

  • Sánchez, Yudania
  • Guc, Maxim|||0000-0002-2072-9566
  • Martí-Sánchez, Sara|||0000-0003-4283-1489
  • Jiménez-Guerra, Maykel
  • Lugo-Loredo, Shadai|||0000-0002-7290-7571
  • Arbiol i Cobos, Jordi|||0000-0002-0695-1726
  • Perez-Rodriguez, Alejandro
  • Martorell, Jordi|||0000-0002-2043-2762
  • Ros, Carles|||0000-0002-9148-2767
The scale-up of photoelectrochemical water splitting and CO reduction is currently hindered by the excessive band gap of metal oxide photoanodes. Metal sulfides 2D nanostructured morphology offer improved optoelectronic properties and catalytic capabilities in the oxygen evolution reaction (OER). This study demonstrates for the first time visible spectra absorption capabilities of SnS photoanodes, fabricated by facile non-vacuum techniques and post-annealed in a sulfur atmosphere, yielding SnS multilayer nanosheets with visible-light absorption down to 900 nm wavelengths. Optimal annealing (500 °C) resulted in >1 V photovoltages, photocurrents surpassing 1.6 mA/cm at 1.23V, incident photon-to-current conversion efficiency (IPCE) of 75% at 330 nm. Photon conversion in the 500-900 nm range (down to 1.37 eV) is correlated with phase transformation from orthorhombic α-SnS to SnS and further hexagonal SnS. IPCE is key for describing effective phase transformation and photon conversion at wavelengths below the dominant direct band gap for the SnS, suggesting potential indirect transitions or confinement in the low-dimensional nanosheets. SnS nanosheets fabricated by solution-processed means, hold great potential for large-scale, cost-effective, and efficient photoelectrochemical devices.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Sulfurization of co-evaporated Cu2ZnGeSe4 layers: Influence of the precursor cation's ratios on the properties of Cu2ZnGe(S,Se)4 thin films

  • Palma-Lafuente, David
  • Diez-Silva, Pablo
  • Rotaru, Victoria
  • Jawhari, Tariq
  • Bertram, Tobias
  • Reyes-Figueroa, Pablo
  • Guc, Maxim
  • Merino, José Manuel
  • Caballero, Raquel
12 pages, 16 figures, 1 table, Cu2ZnGe(S,Se)4 (CZGSSe) thin films were fabricated by sulfurization of co-evaporated Cu2ZnGeSe4 (CZGSe) thin films. The goal of this work is to investigate the effect of the composition of CZGSe layers on the structural, vibrational and morphological properties of CZGSSe compounds. Different CZGSe layers with different cation's ratios (Cu-poor, Zn-rich; Cu-poor, Zn-stoichiometric and Cu-poor, Ge-rich) were investigated before and after the sulfurization process. Break-off and different cooling experiments during sulfurization of CZGSe were also carried out. Break-off experiments revealed that 440 °C is the key temperature to incorporate S into CZGSe lattice, being required 480 °C to enhance the interdiffusion of the elements. Fast cooling experiments during sulfurization appeared to be a promising strategy to avoid the formation of secondary phases. All the samples showed the CZGSSe kesterite phase, as well as higher S content and different secondary phases at the surface. These experiments demonstrate that a minimum Ge content in CZGSe is required to assist the growth of CZGSSe grains and develop a compact structure. These results indicate the importance of controlling the cation's ratio of CZGSe to develop high quality wide band gap CZGSSe compounds, which can be very attractive for different applications., This work was supported by Spanish Ministry of Science, Innovation and Universities Project (CELL2WIN: PID2019-104372RB-C32) and European Project INFINITE-CELL (H2020-MSCA-RISE-2017-777968). DPL acknowledges the financial support from Spanish Ministry of Science and Innovation within FPI Program. MG acknowledges the financial support from Spanish Ministry of Science, Innovation and Universities within the Juan de la Cierva Program (IJC2018-038199-I). Authors from IREC belong to the SEMS (Solar Energy Materials and Systems) Consolidated Research Group of the “Generalitat de Catalunya” (Ref. 2017 SGR 862). The authors acknowledge the service from the MiNa Laboratory at IMN-CSIC, and funding from CM (project S2018/NMT-4291 TEC2SPACE), MINECO (project CSIC13-4E-1794) and European Union (FEDER, FSE)., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Wide band gap Cu2ZnGe(S,Se)4 thin films and solar cells: Influence of Na content and incorporation method

  • Ruiz-Perona, Andrea
  • Guc, Maxim
  • Sánchez, Yudania
  • Kodalle, Tim
  • Merino, José M.
  • León, Máximo
  • Caballero, Raquel
9 pages, 9 figures, 2 tables, The influence of the Na content and incorporation procedure into Cu2ZnGe(S,Se)4 (CZGSSe) thin films and solar cells is investigated. The effects of the presence/absence of Se during the deposition of a 15 nm thick NaF layer before and/or after the Cu2ZnGeSe4 (CZGSe) co-evaporation, are compared. Both the Na content, and Na-supply method significantly influence the incorporation of S into the CZGSe lattice and its distribution in the absorber. A [S]/([S] + [Se])-gradient throughout the CZGSSe layers is observed for all the samples and correlated with effects induced by the Na incorporation procedure. For instance, the evaporation of Se together with NaF leads to an increased S concentration in the surface-region of the CZGSSe layer and a modified surface morphology. CZGSSe-based solar cells with band gap energies of about 2 eV are obtained, regardless of the NaF addition method used, while the absence of the NaF layer reduces the S incorporation and the Eg. However, the evaporation of Se together with NaF results in higher Eg and open circuit voltage VOC, probably related to a higher S accumulation near the surface, demonstrating the importance of the [S]/([S] + [Se]) distribution. CZGSSe-based photovoltaic devices with efficiency of 3.2 % and Eg of 2 eV are obtained., This work was supported by Spanish Ministry of Science, Innovation and Universities Project (WINCOST: ENE2016-80788-C5-2-R, CELL2WIN: PID2019-104372RB-C32) and European Project INFINITE-CELL (H2020-MSCA-RISE-2017-777968). MG acknowledges the financial support from Spanish Ministry of Science, Innovation and Universities within the Juan de la Cierva Program (IJC2018-038199-I). Authors from IREC belong to the SEMS (Solar Energy Materials and Systems) Consolidated Research Group of the “Generalitat de Catalunya” (Ref. 2017 SGR 862). The authors acknowledge the service from the MiNa Laboratory at IMN-CSIC, and funding from CM (project S2018/ NMT-4291 TEC2SPACE), MINECO (project CSIC13-4E-1794) and European Union (FEDER, FSE)., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

2D nanosheet SnS2 solution-processed photoanodes: Unveiling enhanced visible light absorption for solar fuels applications

  • Sánchez, Yudania
  • Guc, Maxim
  • Martí-Sànchez, Sara
  • Jiménez-Guerra, Maykel
  • Lugo-Loredo, Shadai
  • Arbiol, Jordi
  • Pérez-Rodríguez, Alejandro
  • Martorell, Jordi
  • Ros, Carles
The scale-up of photoelectrochemical water splitting and CO2 reduction is currently hindered by the excessive band gap of metal oxide photoanodes. Metal sulfides 2D nanostructured morphology offer improved optoelectronic properties and catalytic capabilities in the oxygen evolution reaction (OER). This study demonstrates for the first time visible spectra absorption capabilities of SnxSy photoanodes, fabricated by facile non-vacuum techniques and post-annealed in a sulfur atmosphere, yielding SnS2 multilayer nanosheets with visible-light absorption down to 900 nm wavelengths. Optimal annealing (500 °C) resulted in >1 V photovoltages, photocurrents surpassing 1.6 mA/cm2 at 1.23VRHE, incident photon-to-current conversion efficiency (IPCE) of 75% at 330 nm. Photon conversion in the 500–900 nm range (down to 1.37 eV) is correlated with phase transformation from orthorhombic α-SnS to Sn2S3 and further hexagonal SnS2. IPCE is key for describing effective phase transformation and photon conversion at wavelengths below the dominant direct band gap for the SnS2, suggesting potential indirect transitions or confinement in the low-dimensional nanosheets. SnS2 nanosheets fabricated by solution-processed means, hold great potential for large-scale, cost-effective, and efficient photoelectrochemical devices., ICFO acknowledge financial support from LICROX and SOREC2 EU-Funded projects (Codes: 951843 and 101084326), the BIST Program and Severo Ochoa Program. This work was partially funded by CEX2019-000910-S (MCIN/AEI/10.13039/501100011033 and PID2020-112650RB-I00), Fundació Cellex, Fundació Mir-Puig, and Generalitat de Catalunya through CERCA. C.R. acknowledges support from the MCIN/AEI JdC-F Fellowship (FJC2020-043223-I) and the Severo Ochoa Excellence Post-doctoral Fellowship (CEX2019-000910-S). Authors from IREC belong to the MNT-Solar Consolidated Research Group of the “Generalitat de Catalunya” (ref. 2021 SGR 01286) and are grateful to European Regional Development Funds (ERDF, FEDER Programa Competitivitat de Catalunya 2007–2013). M.G. acknowledges the financial support from Spanish Ministry of Science, Innovation and Universities within the Juan de la Cierva fellowship (IJC2018-038199-I). ICN2 acknowledges funding from Generalitat de Catalunya 2021SGR00457. The authors thank support from the project NANOGEN (PID2020-116093RB-C43), funded by MCIN/AEI/10.13039/501100011033/and by “ERDF A way of making Europe”, by the “European Union”. ICN2 is supported by the Severo Ochoa program from Spanish MCIN/AEI (Grant No.: CEX2021-001214-S) and is funded by the CERCA Programme/Generalitat de Catalunya., With funding from the Spanish government through the "Severo Ochoa Centre of Excellence" accreditation (CEX2019-000910-S)., With funding from the Spanish government through the "Severo Ochoa Centre of Excellence" accreditation (CEX2021-001214-S)., Peer reviewed